Heath Zenith SL-6290 Series - Manual

Heath Zenith SL-6290 Series

Heath Zenith SL-6290 Series – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
Page: / 24

Table of Contents:

  • Page 2 – Set the push button jumpers to match the chime receiver; See “Code and Tune Setting” section.
  • Page 3 – Code and Tune Settings; Code Settings; . The push button and chime both have eight different jumper
  • Page 5 – Push Button Battery Replacement
  • Page 6 – Troubleshooting; Chime does not sound:; Batteries seem OK, but the chime does not work when installed:
  • Page 7 – sistance before returning product to store.; No Service Parts Available for this Product
  • Page 8 – FIVE YEAR LIMITED WARRANTY
  • Page 11 – Programaciones del código y del tono; Programaciones del código; . Tanto el pulsador como la campana tienen ocho posiciones
  • Page 13 – Reemplazo de la Batería del Pulsador
  • Page 14 – Análisis de Averías
  • Page 15 – Servicio Técnico; para pedir ayuda antes de devolver el producto a la tienda.; No hay piezas de servicio disponibles para este producto.; Información Regulatoria
  • Page 16 – GARANTÍA LIMITADA A 5 AÑOS
  • Page 19 – Réglages du code et de la mélodie; Réglage du code; . L’unité de bouton-poussoir et le carillon comptent chacun huit
  • Page 22 – Dépannage; Le carillon ne sonne pas:
  • Page 23 – Service Technique; pour obtenir de l’aide avant de retourner l’article au magasin.; Aucune pièce de rechange n’est disponible pour ce produit.; Renseignements de règlements
  • Page 24 – GARANTIE LIMITÉE DE 5 ANS
Loading the manual

Wireless Push Button
Accessory

The Heath

®

/Zenith Wireless Push Button Acces-

sory works with existing Heath

®

/Zenith jumper or

dip switch systems.
• Battery powered push button - No wires to run.
• 128 selectable codes allow more than one chime

system in the same house.

© 2007 HeathCo LLC

595-5507-11

SL-6190 Series and SL-6290 Series
(Style may vary from illustration)

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Set the push button jumpers to match the chime receiver; See “Code and Tune Setting” section.

-2- 595-5507-11 2. Set the push button jumpers to match the chime receiver code. See “Code and Tune Setting” section. 1. Install alkaline type A23 12 volt push button battery. Remove back of case by pushing in tab on bottom with a small screwdriver. Make sure battery is oriented properly (see page 5...

Page 3 - Code and Tune Settings; Code Settings; . The push button and chime both have eight different jumper

-- 595-5507-11 Code and Tune Settings Code Settings Note: Most installations will not require you to change any jumpers on your chime and push button.WARNING: Disconnect chime unit from power source before opening code access door. Close door and replace screw before reconnecting to power. The push ...

Page 5 - Push Button Battery Replacement

-5- 595-5507-11 Push Button Battery Replacement Install an alkaline type A23 12 Volt battery. See diagram inside push but- ton for correct battery orientation. Remove screw to open access door Tune Setting (Not used on all models) Back of Chime 1 2 4 5 6 7 8 1 2 4 5 6 7 8 Inside Push Button * Code S...

Other Heath Zenith Models

All Heath Zenith Other