Heath Zenith SL-4303 - Manual

Heath Zenith SL-4303

Heath Zenith SL-4303 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
Page: / 20

Table of Contents:

  • Page 2 – wiring Light Fixture; ual; dimmer cOntrOL; warning: turn power off at circuit
  • Page 3 – recommended grounding method; Other wiring Options; All wiring should be run in accordance with; contact a qualified; When determining the maximum
  • Page 4 – testing; turn on the circuit breaker and light switch.; Adjustment of Coverage; if the dual controlled wiring is not done; instaLL Fixture Base tO; DualBrite; SENSITIVITY; Maximum Range
  • Page 5 – sPeciFicatiOns; adJustment OF cOverage
  • Page 6 – trOuBLeshOOting guide; Five year Limited warranty; technicaL service; no service Parts available for this Product
  • Page 7 – TEST; Prueba
  • Page 8 – caBLeadO deL aParatO de LuZ; cuidadO: nO retire el conector de; desarme eL aParatO de LuZ; cOntrOL reductOr D; advertencia: desconecte la energía
  • Page 9 – método recomendado de conexión a tierra; Otras opciones de cableado; Todo el cableado debe ser hecho de acuerdo; Póngase; Cuando determine la potencia
  • Page 10 – PrueBa; Regulación del área de cobertura; si el cableado; instaLe La Base deL aParatO a; Alcance Máximo
  • Page 11 – esPeciFicaciOnes; reguLaciÓn deL Área de; Lo menos sensible Lo más sensible
  • Page 12 – guia de investigaciOn de averias; de devolver el producto a la tienda.
  • Page 13 – garantía Limitada a 5 aÑOs
  • Page 14 – rÉsumÉ du mOde de cOmmutatiOn; PRIORITÉ MANUELLE
  • Page 15 – Branchement des FiLs; attentiOn : ne retireZ Pas le con-; dÉmOntage du Luminaire; rhÉOstat D; mise en garde : coupez l’alimentation
  • Page 16 – méthode de mise à la terre recommandée; autres options de raccordement; Le câblage doit être conforme aux exigences; si vous; Lors de la détermination de la puis-
  • Page 17 – essais; Réglage; si le raccordement d’un système à double; instaLLatiOn du sOcLe du; (d’une puissance maximum de 25 w
  • Page 18 – rÉgLage de La ZOne de; Portée maximale
  • Page 19 – Fiche technique; guide de dÉPannage
  • Page 20 – avant de retourner l’article au magasin.
Loading the manual

Features

• Light comes on when motion is detected.
• Automatically turns light off.
• Half power Accent lighting.
• Photocell keeps the light off during daylight

hours.

requirements

• The light control requires 120 volts AC.
• If you want to use Manual Mode, the control must

be wired through a switch.

•

some electrical codes require installation by
a qualified electrician.

motion sensing Porch
Light

This package includes:
• Porch Light
• Easy to use Universal Mounting Bracket
• Mounting Hardware
• Wire Nuts
• Lens Shield

SL-4303

© 2008 HeathCo LLC

598-1348-00

Mode:

On-Time

Works: Day Night

test

5 Sec

x

x

auto/

1, 5, or 10 min

x

accent Off, 3, 6 Hr, to Dawn

x

manual

Until Dawn*

x

OPeratiOn

Note:

When first turned on wait about 1

1

/

2

minutes

for the circuitry to calibrate.

* resets to Auto Mode at dawn.

ON-TIME

test 1 5 10 MIN

test

Set ON-TIME switch to
1, 5, or 10 minutes.

autO

ON-TIME Switch at 1, 5, or
10 minutes

... back on.

1 Second OFF

then

...

Manual mode only works at
night because daylight returns
the sensor to AUTO.
Flip the light switch off for one
second then back on to toggle
between AUTO and MANUAL
MODE.
Manual mode works only with
the ON-TIME switch in the 1,
5, or 10 position.

mOde switching summary

Flip light switch off
for one second then
back on*

* If you get confused while switching modes, turn
the power off for one minute, then back on. After
the calibration time the control will be in the AUTO
mode.

MANUAL MODE

AUTO

TEST

manuaL mOde

ON-TIME

TEST

1 5 10 min

Before installation, record the model number
listed inside the fixture. attach receipt in case
of possible warranty issues.

model number:

Set the ON-TIME switch
on the sensor to TEST.

M e e t s t h e E N E R G Y S TA R

®

guidelines when D

ual

B

rite

®

func-

tion is off.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - wiring Light Fixture; ual; dimmer cOntrOL; warning: turn power off at circuit

2 598-1348-00 DU AL BRITE ® ON -TIM E TE ST 1 5 10 MIN OFF 3 6 D US K TO DA WN DU AL BR ITE ® ON -TIM E TE ST 1 5 10 MIN OFF 3 6 D USK TO DA WN instaLL universaL mOunting Bracket For best performance, mount the fixture at least 8 feet (2.4 m) above the ground. Fixture Screw (Tightened Finger Tight) ...

Page 3 - recommended grounding method; Other wiring Options; All wiring should be run in accordance with; contact a qualified; When determining the maximum

3 598-1348-00 Ground Screw white to white Black to Black recommended grounding method One Motion Sensing Light Two Motion Sensing Lights (Working Independently) Other wiring Options This fixture can be wired to control another standard or motion sensing light fixture(s). See the following wiring dia...

Page 4 - testing; turn on the circuit breaker and light switch.; Adjustment of Coverage; if the dual controlled wiring is not done; instaLL Fixture Base tO; DualBrite; SENSITIVITY; Maximum Range

4 598-1348-00 testing 1. turn on the circuit breaker and light switch. Note: Sensor has a 1 1 / 2 minute warm up period before it will detect motion. When first turned on wait 1 1 / 2 minutes. 2. Set the ON-TIME switch to the TEST position and the D ual B rite ® switch to the OFF position. 3. Walk t...

Other Heath Zenith Models

All Heath Zenith Other