Heath Zenith 598-1135-08 - Manual

Heath Zenith 598-1135-08

Heath Zenith 598-1135-08 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
Page: / 44

Table of Contents:

  • Page 2 – CodE SwItCH LoCatIoNS; ON
  • Page 3 – ENGLISH; REMotE CoNtRoL; Rear View of Remote Control; Code Settings; Left Side; IMpORTANT
  • Page 4 – Battery Compartment; INdooR aNd outdooR; Select Night or 24 Hour Mode; Attaching Ball Mounting Bracket to Indoor Motion Sensor; Installing Indoor Motion Sensor using optional
  • Page 5 – Attaching Indoor Motion Sensor to Mounting Bracket; Installing Indoor Motion Sensor directly to wall; Attaching Indoor Motion Sensor Directly to Wall; Installing outdoor Motion Sensor; Indoor Motion Sensor -
  • Page 7 – Troubleshooting Guide; Battery Replacement; Removing Battery Tab; Operation; Receiver; KId’S REMotE CoNtRoL; operation; Receiver Information,; Removing Access Door
  • Page 8 – Removing Tab In Battery Chamber; Inside of Remote Control; -waY waLL SwItCH tRaNSMIttER; Installation; waRNING: turn off the power to the light switch circuit; waRNING: the white neutral wires in a 3-way circuit
  • Page 9 – Bulb Replacement; one
  • Page 10 – Installing Wall Switch Receiver; waLL SwItCH RECEIVER; Gang
  • Page 11 – RECEPtaCLE RECEIVER; Installing Receptacle Receiver; testing and operation; CautIoN: do not exceed the maximum load limits
  • Page 12 – tRouBLESHootING GuIdE; SYMPtoM; REGuLatoRY INFoRMatIoN; No Service Parts available for this Product
  • Page 13 – two YEaR LIMItEd waRRaNtY
  • Page 14 – CaRaCtERIStICaS; Productos a control remoto; CaLIBRaCIoNES dEL CÓdIGo; La mayoría de instalaciones de sólo un sistema no reque-; Ejemplo 1 - Calibraciones del código, sistema 1; Guía de Análisis de Averías.; Ejemplo 2 - Calibraciones del código, sistema 2
  • Page 15 – uBICaCIoNES dE LoS INtERRuPtoRES dE CIRCuIto IMPRESo
  • Page 16 – Presilla opcional del visor del carro (incluida); Calibraciones del Código; Lado izquierdo; Retiro de la presilla del visor – Vista posterior; CoNtRoL REMoto; oFF; Vista posterior del control remoto
  • Page 17 – dEtECtoR INaLÁMBRICo dE MoVIMIENto; Seleccione modo nocturno o modo de 24 horas; Compartimento de la batería; Sujeción de la consola de montaje tipo bola al; Instalación del detector de movimiento para uso; Continuación
  • Page 18 – Sujeción del detector de movimiento para uso interior a la; Fijación del detector de movimiento directamente a la pared
  • Page 19 – Instalación del detector de movimiento; Revisión de la operación y de la regulación; detector de movimiento para uso interior -
  • Page 21 – Reemplazo de la batería; INtERRuPtoR a añadIBLE; Instalación; Interruptor A añadible; operación; Retiro de la aleta de la batería; Retiro de la tapa de
  • Page 22 – Información del receptor; Guía de Análisis; CoNtRoL REMoto PaRa NIñoS; adVERtENCIa: apague la energía al circuito del interruptor
  • Page 23 – Figura 2 - Conexión del conmutador tridireccional de pared; uno
  • Page 24 – Reemplazo de la bombilla; RECEPtoR dE PaREd CoN; IMpORTANTe; INStaLaCIÓN
  • Page 25 – Instalación del receptor de pared con interruptor; RECEPtoR CoN toMaCoRRIENtE; Instalación del receptor con tomacorriente; CuIdado: No exceda los límites de carga máximos
  • Page 26 – Guía dE aNÁLISIS dE aVERíaS; SíNtoMa; Prueba y operación; SERVICIo tÉCNICo; producto a la tienda.
  • Page 27 – INFoRMaCIÓN REGuLatoRIa
  • Page 28 – CaRaCtÉRIStIQuES; Les commandes d’éclairage Heath; Produits télécommandés; RÉGLaGE dES CodES; La plupart des installations simples n’exige pas la mo-; Exemple 3 - Réglage des codes avec un seul; Guide de dépannage
  • Page 29 – EMPLaCEMENt dES MICRo-INtERRuPtEuRS
  • Page 30 – Réglages des codes; Côté gauche; Pince de pare-soleil d'automobile facultative; enlèvement de la pince de pare-soleil – Vue arrière; tÉLÉCoMMaNdE; Vue arrière de la télécommande
  • Page 31 – Compartiment des piles; Sélection du mode de nuit ou du mode 24 heures; Installation du détecteur de mouvements intérieur; Fixation du support pivotant à bille au détecteur de mouve-; dÉtECtEuRS dE MouVEMENt SaNS FIL
  • Page 32 – Installation du détecteur de mouvements intérieur sur le; Installation du détecteur de mouvements intérieur directe-
  • Page 33 – détecteur de mouvements intérieur -; Installation du détecteur de mouvement
  • Page 35 – INtERRuPtEuR d’aPPoINt; Retrait de l’onglet de la pile; Interrupteur d’appoint; Fonctionnement; Informations sur le récepteur; Remplacement de la pile; Retrait de la porte d’accès
  • Page 36 – Intérieur de la télécommande; tÉLÉCoMMaNdE PouR ENFaNt; Informations sur le; ÉMEttEuR d'INtERRuPtEuR MuRaL À; aVERtISSEMENt : Coupez l’alimentation de l’interrup-
  • Page 37 – Figure 1 - Câblage à trois voies typique; aVERtISSEMENt : Les fils blancs du neutre d’un; l’un
  • Page 38 – Remplacement de l’ampoule
  • Page 39 – Installation de l’interrupteur transmetteur mural; PRISE RÉCEPtRICE; Installation de la prise réceptrice; attENtIoN : Évitez d’utiliser une ampoule de puissance supé-
  • Page 40 – GuIdE dE dÉPaNNaGE; SYMPtÔME; Essai et fonctionnement; Réglage des codes
  • Page 41 – GaRaNtIE LIMItÉE dE 2 aNS; Exclusions de la garantie -; RENSEIGNEMENtS dE RèGLEMENtS; l’article au magasin.; le; aucune pièce de rechange n’est disponible pour ce produit.
  • Page 44 – No de modelo / N° de modèle
Loading the manual

ON

1 2 3

4

ON

1 2 3

4

ON

1 2 3

4

ON

1 2 3

4

ON

1 2 3

4

Remote Controlled Products

This manual includes operating instructions for a variety of remote controlled products. All products work on the same principle and use the same
code setting information. Please read all instructional information and note any specific information pertaining to your particular product.

© 2007 HeathCo LLC

598-1135-08

ENGLISH

• Transmitters

– Remote Control
– Indoor Wireless Motion Sensor
– Outdoor Wireless Motion Sensor
– Add-A-Switch
– Kid’s Remote Control
– 3-Way Wall Switch

• Receivers

– Wall Switch Receiver
– Receptacle Receiver

This manual applies to the following products:

FEatuRES

• Products are UL/cUL and/or FCC/IC tested and approved.
• Operational range of up to 100 feet.

Heath

®

/Zenith wireless lighting controls are designed to

work together. Simply determine which transmitter(s) you
would like to have control which receiver(s) and set the code
setting to match.

CodE SEttINGS

Note:

Most single system installations will not require any

change to the code setting. transmitter(s) and receiver(s)
must have the same code and group setting to work together.
Switches 1 through 3 set the code. Switch 4 sets the Group (a
or B). See page 2 for switch locations.

DIM

ON

OFF

ON

OFF

DIM

Receiver(s)

Code

Transmitter(s)/

Receiver(s) Code

Group “A”

Group “B”

Remote Motion

Sensor Code

Group “A”

Example 1 - Code Settings, System 1

(Factory Setting)

Left Side Controls:

Controls One Set of

Group “A” or Group

“B” Receiver(s)

Right Side Controls:
Controls One Set of

Group “A” or Group

“B” Receiver(s)

Transmitter(s)/

Receiver(s) Code

Group “A”

Example 3 - Code Settings with Single transmitter

When using a single group transmitter (

i.e.

Door Transmitter, Add-A-

Switch, Remote Motion Sensor) the code and group settings must
match receiver(s) for the system to function properly.

Note:

This setting will work independently of examples 1 and 2

because the code setting is different.

Note:

The code can also be changed to reduce interference problems

from other wireless products (

i.e.

wireless phones, garage door open-

ers, etc.). See

Troubleshooting Guide

for more information.

(

– Indicates Position of Switch)

Example 2 - Code Settings, System 2

Note:

When operating more than one system independently of each

other, set each system to a different code. There are 8 codes avail-
able by changing the settings of switches 1 through 3.

Receiver(s)

Code

Group “A”

Transmitter

Code

Group Switch
(Group “A” Selection Shown)

ON

1 2 3

4

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - CodE SwItCH LoCatIoNS; ON

2 598-1135-08 CodE SwItCH LoCatIoNS 1 2 3 4 O N 2032 3V L ith ium Batte ry DIM Add-A-Switch Access Door 1 2 3 4 O N 2032 3V L ith ium Batte ry DIM Outdoor Wireless Motion Sensor Code Switches DETECT CODE S 1 2 3 4 DAY NIGHT NIGHT ON LY Code Switches ON 12V Kid’s Remote Control Code Switches CON TRO ...

Page 3 - ENGLISH; REMotE CoNtRoL; Rear View of Remote Control; Code Settings; Left Side; IMpORTANT

3 598-1135-08 ENGLISH Note: One remote control is able to independently operate two receiver units. If more than two receiver units, operating independently, are desired, additional remote controls will need to be purchased.1. Remove Tab from Battery Chamber. Remove cover from back of transmitter. G...

Page 4 - Battery Compartment; INdooR aNd outdooR; Select Night or 24 Hour Mode; Attaching Ball Mounting Bracket to Indoor Motion Sensor; Installing Indoor Motion Sensor using optional

598-1135-08 DETECT CODE S 1 2 3 4 DAY NIGHT NIGHT ON LY Detect Control Battery Compartment INdooR aNd outdooR wIRELESS MotIoN SENSoR Features: • No wiring required.• Up to 70 feet sensing range, 180° Coverage (Outdoor). • Up to 30 feet sensing range, 150° Coverage (Indoor). • Adjustable sensitivity....

Other Heath Zenith Models

All Heath Zenith Other