Heath Zenith 598-1127-03 - Manual
Heath Zenith 598-1127-03 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Mount push button. Use either screws or double
- Page 3 – Tune Settings
- Page 4 – Troubleshooting; C. Batteries seem OK, but the chime does not work when installed:
- Page 6 – Technical Service; before returning product to store.; No Service Parts Available for this Product; Regulatory Information
- Page 7 – ONE YEAR LIMITED WARRANTY
- Page 9 – Instale el pulsador. Use ya sean tornillos o; Monte la campana. Determine el sitio para el
- Page 11 – Análisis de Averías; C. La pilas parecen estar buenas pero la campana no funciona una vez
- Page 13 – Servicio Técnico; pedir ayuda antes de devolver el producto a la tienda.; Información Regulatoria
- Page 14 – GARANTÍA LIMITADA A 1 AÑO
- Page 17 – Réglage de la mélodie
- Page 18 – Dépannage
- Page 19 – Les cavaliers des positions 1 à 3 doivent être exactement les mê-
- Page 20 – Service Technique; obtenir de l’aide avant de retourner l’article au magasin.; Renseignements de règlements
- Page 21 – GARANTIE LIMITÉE DE 1 AN
A B C 1 2
3
This package includes (Style of push button and chime
may vary from illustration):
• Wireless Christmas bell chime
• Wireless push button with battery
• Hardware pack
This chime requires 3 "AA" alkaline batteries (not
included). In typical use, alkaline batteries will last up
to 6 months.
Wireless Christmas
Chime
© 2008 HeathCo LLC
598-1127-03
1. Install alkaline type A23 12 volt push button
battery (included). Remove back of case by
pushing in tab on bottom with a small screwdriver
(see Figure 1). See diagram inside push button for
correct battery orientation.
Note:
If batteries are
preinstalled, remove orange battery tab.
2. Open chime battery compartment. Press in
latch on rear of chime and lift off battery cover
(see Figure 2).
3. Install 3 alkaline "AA" batteries. Make sure
batteries are oriented properly
(see Figure 3).
4. Test range. Temporarily position chime and
push button where you want them mounted.
Press push button to verify chime and push but-
ton work properly. If chime does not sound, see
Troubleshooting
.
Figure 2
Figure 1
Keyhole
Jumpers
AB
C1
23
Figure 3
WARNING: To prevent possible SERIOUS
INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify
doctor.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
-2- 598-1127-03 5. Mount push button. Use either screws or double sided tape to mount push button.• Screw Mounting: To mount with screws, re-move back of case by pushing in tab on bottom with a small screwdriver (see Figure 1). Note: Remove material in screw holes (if needed) before mounting with sc...
-3- 598-1127-03 Tune Setting Tune Settings Your musical Christmas chime has three different selectable tunes. The unit is factory set to jumper location B. The tune can be changed by moving the tune setting jumper (located inside the battery compartment) to a different tune location. Only one tune c...
-4- 598-1127-03 Troubleshooting A. Chime does not sound: • Make sure push button and chime codes are the same (see Figure 7).• Check orientation of push button and chime batteries. (See diagram inside push button and chime for correct battery orientation.) • Check charge of push button and chime bat...
