Heath Zenith 598-1109-06 - Manual

Heath Zenith 598-1109-06

Heath Zenith 598-1109-06 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
Page: / 28

Table of Contents:

  • Page 3 – Figure 5; Chime with Separate Decorative Cover:; Figure 6
  • Page 5 – Some models might require; Tune Settings; Your wireless chime has different selectable tunes:; Inside Push Button: Remove jumper from location 8.; Dong; tune and the front door use the
  • Page 6 – Troubleshooting; Code Setting; D. Batteries seem OK, but the chime does not work when installed:
  • Page 7 – T ype; Unit will come factory set with jumpers in locations 5, 6, and 7 on the
  • Page 8 – Technical Service; before returning product to store.; If the problem persists, call* for assistance; No Service Parts Available for this Product; Regulatory Information
  • Page 9 – ONE YEAR LIMITED WARRANTY; Repair service, adjustment and calibration due to misuse,
  • Page 10 – Análisis de Averías; Campana mecánica; Figura 2
  • Page 11 – Montaje con tornillos:; Para montar con tornillos,; Montaje con cinta adhesiva:; Cuando fije el
  • Page 12 – la base de la campana.
  • Page 14 – Programación del tono; Dentro del Pulsador: Quite el puente del sitio 8.; Talán; la puerta frontal el tono
  • Page 15 – cuando se pulsa el botón designado para el tono; D. La pilas parecen estar buenas pero la campana no funciona una vez; • Trate de ubicar a la campana lo más cerca del pulsador.
  • Page 17 – Servicio Técnico; pedir ayuda antes de devolver el producto a la tienda.; Si el problema continúa, llame al; No hay piezas de servicio disponibles para este producto.; Información Regulatoria
  • Page 18 – GARANTÍA LIMITADA A 1 AÑO; Servicio de reparación, ajuste y calibración debido al mal
  • Page 19 – Carillon mécanique; Ôtez
  • Page 20 – Utilisez soit des vis,; Au moyen de vis :; Pour faire l’installation avec; Au moyen de ruban adhésif :; Déterminez l’emplacement de l’installation.
  • Page 23 – Réglage de la mélodie; dong; Bouton-poussoir intérieure : Enlever le cavalier à la position 8.; et la porte avant, le timbre; Figure 8 - Unité de bouton-poussoir intérieure
  • Page 24 – Dépannage; lorsque le bouton-poussoir désigné pour le
  • Page 26 – Service Technique; obtenir de l’aide avant de retourner l’article au magasin.; Si le problème persiste, composez* le; Aucune pièce de rechange n’est disponible pour ce produit.; Renseignements de règlements
  • Page 27 – GARANTIE LIMITÉE DE 1 AN; Exclusions de la garantie -; Réparations, réglage et calibrage dus à une
Loading the manual

This package includes (Style of push button and chime may vary from illustration):
• Wireless chime
• Wireless push button with battery
• Hardware pack

This chime requires 4 “C” alkaline batteries (not included).

In typical use,

alkaline batteries will last up to 2

1

/

2

years.

Wireless Mechanical

Battery Operated

Chime

© 2008 HeathCo LLC

598-1109-06

Figure 2

Figure 3

1. Install alkaline type A23 12 volt push button

battery (included).

Remove back of case by

pushing in tab on bottom with a small screw-
driver. See diagram inside push button for
correct battery orientation.

Note:

If batteries

are preinstalled, remove orange battery tab.

2. Remove chime cover.

Pull firmly as shown

in Figure 2.

3. Install 4 alkaline “C” batteries in chime.

Make sure batteries are oriented properly as
shown in Figure 3.

4. Test range.

Temporarily position chime and

push button where you want them mounted.
Press push button to verify chime and push
button work properly. If chime does not sound,
see

Troubleshooting

.

Figure 1

1 2 3 4 5 6 7

ON

Type

“C”

Type

“C”

Ty

pe

“C”

Ty

pe

“C”

WA R N I N G : To p r e v e n t p o s s i b l e

SERIOUS INJURY or DEATH:

• N E V E R a l l ow s m a l l c h i l d r e n n e a r

batteries.

• If battery is swallowed, immediately

notify doctor.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 3 - Figure 5; Chime with Separate Decorative Cover:; Figure 6

-3- 598-1109-06 Basic Chime: 1. Remove batteries from chime.2. Place chime against wall and verify the chime is level.3. Use chime holes as a template (see Figure 5). Drill 7/32" diameter pilot hole for 2 wall anchors (provided) and insert anchors. 4. Insert 2 screws (provided) through holes in ...

Page 5 - Some models might require; Tune Settings; Your wireless chime has different selectable tunes:; Inside Push Button: Remove jumper from location 8.; Dong; tune and the front door use the

-5- 598-1109-06 12345678 12345678 Push Button Set for One Note Tune (Dong) Note: Some models might require the use of tweezers to remove and replace the jumpers. Figure 8 - Inside Push Button Tune Settings Your wireless chime has different selectable tunes: Dong (one note) and Ding- Dong (two note)....

Page 6 - Troubleshooting; Code Setting; D. Batteries seem OK, but the chime does not work when installed:

-6- 598-1109-06 Troubleshooting A. Low Battery Indicator: When the push button designated for the “Ding-Dong” tone is pressed, only a “Dong” note will play when battery power is low in chime unit. B. Chime does not sound: • Make sure push button and chime codes are the same (see Figure 9).• Check or...

Other Heath Zenith Models

All Heath Zenith Other