Heath Zenith 4162 - Manual

Heath Zenith 4162

Heath Zenith 4162 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
Page: / 24

Table of Contents:

  • Page 2 – Mode Switching Summary; Flip light switch; INSTALLATION; WARNING: Turn power off at circuit; Do not remove
  • Page 3 – WIRING; One Motion Light; CAUTION: DO NOT connect the RED; Two Motion Lights
  • Page 4 – OPTIONAL WIRING; Wiring Diagram 1; If the dual master wiring is not
  • Page 5 – Optional Assembly; If so equipped, you may install the decora-; COMPLETE THE INSTALLATION; Stuff the wires into the junction box. Make
  • Page 6 – TESTING; Turn on the circuit breaker and light; Least Sensitive; Avoid aiming the control at:
  • Page 7 – SPECIFICATIONS; for maximum wattage; TROUBLESHOOTING GUIDE
  • Page 8 – FIVE YEAR LIMITED WARRANTY; TECHNICAL SERVICE; No Service Parts Available for this Product
  • Page 9 – FUNCIONAMIENTO; Características; MODO MANUAL
  • Page 10 – PRUEBA; Resumen de las modalidades del; INSTALACION; Ajuste los tornillos tan; Método; Atornille la placa de montaje
  • Page 11 – CABLEADO; Luz de un movimiento; CUIDADO: NO conecte el cable ROJO; Nota; Como se enviaron; Negro a negro
  • Page 12 – La conexión inadecuada; CONEXION ALTERNA; Diagrama de Cableado 1
  • Page 13 – Atornille la barra y la; Ensamble superior del; Si lo tiene, usted puede instalar la cola; COMPLETE LA INSTALACION; Meta los cables en la caja de empalme.
  • Page 14 – Lo menos sensible; Evite apuntar el control hacia:
  • Page 16 – GARANTÍA LIMITADA A 5 AÑOS; SERVICIO TÉCNICO; antes de devolver el producto a la tienda.
  • Page 17 – Caractéristiques; Exigences; ou; FONCTIONNEMENT; Note: Après mise en circuit, attendre enfiron; Essai
  • Page 18 – Placer l’interrupteur ON-; Résumé du mode de commutation; Enlever la plaque; tation au disjoncteur ou au fusible.; la plaque de montage.; Fixer la plaque de montage
  • Page 19 – CÂBLAGE; Méthode de mise à la terre recommandée; Tous les fils doivent être installés; Contactez un électricien; Une lanterne à détecteur de mouvement; Torsadez ensemble les fils de la boîte; Tel qu’expédié
  • Page 20 – CÂBLAGE FACULTATIF
  • Page 21 – COMPLÉTEZ L'INSTALLATION; Visser la tige de; Ensemble facultatif; passage des fils
  • Page 22 – ESSAIS; Éviter de pointer l’appareil:; Le moins sensible; Toute autre
  • Page 23 – GUIDE DE DÉPANNAGE; priorité manuelle; FICHE TECHNIQUE
  • Page 24 – GARANTIE LIMITÉE DE 5 ANS; SERVICE TECHNIQUE; l’aide avant de retourner l’article au magasin.
Loading the manual

Motion Sensing Coach
Lights

Tail Assembly

(Lantern & Coach)*

Features

• Light comes on when motion is detected.
• Automatically turns light off.
• Photocell keeps the light off during daylight

hours.

This package includes:

© 2007 HeathCo LLC

595-5530-13

Set ON-TIME switch to
1, 5, or 10 minutes.

ON-TIME

Set the ON-TIME switch
on the bottom of the cover
plate to

TEST.

... back on.

1 Second

OFF

then

...

Manual mode only works at
night because daylight returns
the sensor to AUTO.
Flip the light switch off for one
second then back on to toggle
between AUTO and MANUAL
MODE.
Manual mode works only with
the ON-TIME switch in the 1,
5, or 10 position.

* Model 4162 includes

additional top assembly parts.

NOTE: When first turned on wait about 1

1

/

2

minutes for the circuitry to calibrate.

Requirements

• The light control requires 120 volts AC.
• If you want to use Manual Mode, the control

must be wired through a switch.

•

Some electrical codes require installa-
tion by a qualified electrician.

Mounting screws

and wire connectors

MANUAL MODE

AUTO

* resets to Auto Mode at dawn.

OPERATION

TEST

Mode:

On-Time

Works: Day Night

Test

5 Seconds

x

x

Auto

1, 5, or 10 Min

x

Manual

To Dawn*

x

TEST 1 5 10 MIN

TEST

1 5 10 MIN

ON-TIME

Before installation, record the model number
from back of fixture below. Attach receipt in
case of possible warranty issues.

Carriage Light

or

Lantern

or

Coach Light

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Mode Switching Summary; Flip light switch; INSTALLATION; WARNING: Turn power off at circuit; Do not remove

2 595-5530-13 MANUAL MODE AUTO TEST ON-TIME Switch at 1, 5, or 10 minutes Mode Switching Summary Flip light switch off for one second then back on* * If you get confused while switching modes, turn the power off for one minute, then back on. After the calibration time the control will be in the AUTO...

Page 3 - WIRING; One Motion Light; CAUTION: DO NOT connect the RED; Two Motion Lights

3 595-5530-13 Wire Path WIRING One Motion Light Black White Green or Bare Light Fixture CAUTION: DO NOT connect the RED wire unless you want to control other lights from the motion sensor. Note: All wiring should be run in accordance with the National Electrical Code through conduit or another accep...

Page 4 - OPTIONAL WIRING; Wiring Diagram 1; If the dual master wiring is not

4 595-5530-13 OPTIONAL WIRING This fixture is provided with a sensor rated for 500 Watts. Since the fixture wattage is less than 500 watts, then additional lighting load can be controlled. For example, if the fixture is rated for 100 watts, then 400 watts of additional lighting load can be controlle...

Other Heath Zenith Models

All Heath Zenith Other