Heath Zenith 3003530 - Manual
Heath Zenith 3003530 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Installation; Install alkaline type A23 12 volt push button; Troubleshooting; WARNING: To prevent possible SERIOUS INJURY or DEATH:
- Page 3 – Mount magnet. Repeat step 5 to attach magnet; If using spacer, use the two
- Page 4 – Tune Settings
- Page 5 – • Red light on the sensor does light. Make sure sensor and chime codes; C. Battery seems OK, but the chime does not work when installed:; positions 1 through 7 are used for setting the code.
- Page 7 – before returning product to store.; at; No Service Parts Available for this Product; FIVE YEAR LIMITED WARRANTY
- Page 8 – Campana
- Page 9 – Instalación; Guía de Análisis; ADVERTENCIA: Para evitar una posible LESIÓN SERIA o la MUERTE:
- Page 10 – Montaje con imán. Repita el paso 5 para fijar; Si
- Page 11 – Programación del tono; Tilín
- Page 12 – Análisis de Averías; Cambie la batería del detector.; C. La pilas parecen estar buenas pero la campana no funciona una vez; • Pruebe diferentes sitios para la campana más cerca al detector.
- Page 13 – Los puentes en las posiciones del 1 al 7 deben ser exactamente los
- Page 14 – pedir ayuda antes de devolver el producto a la tienda.
- Page 15 – GARANTÍA LIMITADA A 5 AÑOS; POR CUALQUIER DAÑO ESPECIAL, INDIRECTO, INCIDENTAL
- Page 16 – Branchez le carillon sans fil dans; Carillon de porte
- Page 17 – Installation de la pile alcaline 12 V de type; pannage; MISE EN GARDE : Pour éviter les risques de BLESSURES GRAVES,
- Page 18 – Utiliser l’espaceur; Installation de l’aimant. Répétez l’étape 5; Si vous vous servez de l’espaceur, utili-
- Page 19 – Réglage de la mélodie
- Page 20 – Dépannage; Réglage
- Page 21 – Les cavaliers 1 à 7 doivent occuper exactement les mêmes po-
- Page 22 – obtenir de l’aide avant de retourner l’article au magasin.
- Page 23 – GARANTIE LIMITÉE DE 5 ANS; et ne s’étend
- Page 24 – No de modelo / N° de modèle
© 2007
598-1073-03
1. Plug wireless chime into wall
outlet.
Note:
The volume control is on the back
of the wireless chime. Unplug chime to
adjust volume.
To reduce the risk of electrical shock,
this equipment has a polarized plug
(one blade is wider than the other). This
plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to
install the proper outlet. Do not attempt
to bypass this safety feature.
Chime
Volume
Control
Wireless Plug-in
Chime
Sensor
Magnet
Magnet
Spacer
This package includes:
• Wireless plug-in chime
• Door sensor with battery
• Door magnet
• Magnet spacer
• Hardware pack
Wireless Door
Sensor Chime
Model 3003530 (AC-6168)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
-2- 598-1073-03 Installation Important considerations: The sensor must be mounted to the door jamb. The magnet should be attached to the door. Sensor is for indoor use only. 2. Install alkaline type A23 12 volt push button battery (included). Remove back of case by pushing in tab on bottom with a sm...
-3- 598-1073-03 Use Optional Spacer if Needed 5. Mount sensor. Screw Mounting: Attach sensor back cover to wall using two short screws (provided). Snap sensor onto back cover. Tape Mounting: Apply foam tape to the sensor back cover. Stick sensor back cover to frame of door in desired position. Snap ...
-- 598-1073-03 123 5678 1 2 3 5 6 7 8 Inside Sensor Remove screw to open access door Back of Chime Tune Setting Tune Setting (Not used on all models) Note: Some models might require the use of tweezers to remove and replace the jumpers. Tune Settings Your wireless chime has different selectable tune...
