Heath Zenith 598-1067-03 - Manual

Heath Zenith 598-1067-03

Heath Zenith 598-1067-03 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
Page: / 24

Table of Contents:

  • Page 2 – Mount push button. Use either screws or; Figure 3
  • Page 3 – Your wireless chime has different selectable tunes:; Ding tune and the front door use the Ding-Dong tune; Figure 4; Back of Chime; WARNING: Disconnect chime unit from power source before; Tune Settings
  • Page 4 – Troubleshooting; C. Batteries seem OK, but the chime does not work when installed:; • Do not mount chime or push button on metal or near metal studs. This; positions 1 through 7 are used for setting the code.
  • Page 5 – Figure 5
  • Page 6 – Technical Service; before returning product to store.; at; No Service Parts Available for this Product; Regulatory Information
  • Page 7 – ACE; LIMITED WARRANTY; assembled products and is not extended; Please keep your dated sales receipt, it is required for
  • Page 8 – específcos incluyen 2)
  • Page 9 – Figura 3
  • Page 10 – frontal el tono; Tilín-Talán (o el tono Westminster, disponible en los timbres; Dentro del; ADVERTENCIA: Desconecte la unidad de la campana de la fuente; Programación del tono
  • Page 11 – Análisis de Averías; del pulsador para la orientación correcta de la batería.); C. La pilas parecen estar buenas pero la campana no funciona una vez; • Trate de ubicar a la campana lo más cerca del pulsador.
  • Page 12 – Figura 5
  • Page 13 – Servicio Técnico; pedir ayuda antes de devolver el producto a la tienda.; Información Regulatoria
  • Page 14 – GARANTÍA LIMITADA; POR CUALQUIER DAÑO ESPECIAL, INDIRECTO,
  • Page 15 – • un ensemble de ferrures; Installation de la pile alcaline 12 V de type; Figure 1
  • Page 16 – Plage d’essai. Positionnez temporairement
  • Page 17 – Ding; et la porte avant, le timbre; AVERTISSEMENT : Débrancher le carillon de la source d’alimen-; Réglage de la mélodie
  • Page 18 – Dépannage; • Assurez-vous que le carillon enfichable est bien alimenté.
  • Page 19 – Arrière du carillon
  • Page 20 – Service Technique; obtenir de l’aide avant de retourner l’article au magasin.; Renseignements de règlements
  • Page 21 – GARANTIE LIMITÉE; et ne s’étend; NE POURRA ÊTRE TENUE RES-; Modèle
Loading the manual

© 2008

598-1067-03

Wireless Plug-In

Chime

This package includes (Style of push button and
chime may vary from illustration):
• Wireless plug-in chime
• Wireless push button with battery (Specific

models include 2)

• Hardware pack

1. Install alkaline type A23 12 volt push button

battery (included). Remove back of case by
pushing in tab on bottom with a small screw-
driver (see Figure 1). See diagram inside push
button for correct battery orientation. Note: If
batteries are preinstalled, remove orange
battery tab.

2. Plug in wireless chime. To reduce the risk of

electrical shock, this equipment has a polar-
ized plug (one blade is wider than the other).
This plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet.
Do not attempt to bypass this safety feature.

3. Test range. Temporarily position push button

where you want it mounted. Press push button
to verify chime and push button work properly. If
chime does not sound, see Troubleshooting.

Figure 1

WA R N I N G : To p r e v e n t p o s s i b l e

SERIOUS INJURY or DEATH:

• N E V E R a l l o w s m a l l c h i l d r e n n e a r

batteries.

• If battery is swallowed, immediately

notify doctor.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Mount push button. Use either screws or; Figure 3

-2- 598-1067-03 4. Adjust volume control (Available on se- lected chimes). Unplug chime and adjust volume control to desired volume (see Figure 2). Plug chime back into wall outlet. 5. Mount push button. Use either screws or double sided tape to mount push button.• Screw Mounting: To mount with scre...

Page 3 - Your wireless chime has different selectable tunes:; Ding tune and the front door use the Ding-Dong tune; Figure 4; Back of Chime; WARNING: Disconnect chime unit from power source before; Tune Settings

-3- 598-1067-03 Your wireless chime has different selectable tunes: Ding (one note), Ding-Dong (two note), or Westminster (eight note) (Available on selected chimes). The factory setting is for the Ding-Dong tune (or Westminster, when available). This tune can be changed by following the instruction...

Page 4 - Troubleshooting; C. Batteries seem OK, but the chime does not work when installed:; • Do not mount chime or push button on metal or near metal studs. This; positions 1 through 7 are used for setting the code.

-4- 598-1067-03 Troubleshooting A. Chime does not sound: • Make sure push button and chime codes are the same (see Figure 5).• Check orientation of push button battery (See diagram inside push button for correct battery orientation.) • Check charge of push button battery, replace if necessary.• Make...

Other Heath Zenith Models

All Heath Zenith Other