Heath Zenith 2LBL4 - Manual
Heath Zenith 2LBL4 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Mode Switching Summary; Flip light switch; MANUAL MODE; Timer; INSTALLATION; NOTE: If fixture is mounted higher than
- Page 3 – Twist the junction box wires and fixture wires together; Wire the Light Control; WARNING: Turn power off at circuit breaker
- Page 4 – Bottom of Sensor; TEST AND ADJUSTMENT; Maximum
- Page 5 – SPECIFICATIONS; Vertical; VAC; TROUBLESHOOTING GUIDE; YEAR LIMITED WARRANTY:
- Page 6 – FUNCIONAMIENTO; Nota: Cuando lo prenda por primera vez espere 1; Requisitos; Manual de Instrucciones y Partes
- Page 7 – Mueva el interruptor de; Resumen de las modalidades del interruptor; Apague el interruptor; PRUEBA; Luz de Adorno; INSTALACION
- Page 8 – ADVERTENCIA: Desconecte la energía en el
- Page 9 – Parte de abajo del detector; PRUEBA Y AJUSTE; Angulo de
- Page 10 – ESPECIFICACIONES; GUIA DE INVESTIGACION DE AVERIAS; MODO MANUAL; cher al amanecer
- Page 11 – Caractéristiques; à détecteur de; ESSAI; FONCTIONNEMENT; Note: A p r è s m i s e e n c i r c u i t , a t t e n d r e e n f i r o n; AUTOMATIQUE; Mode d’emploi et guide des pièces; Exigences
- Page 12 – Placer l’interrupteur ON-; Résumé du mode de commutation; Mettre l’interrupteur; PRIORITÉ MANUELLE; Minuterie D
- Page 13 – MISE EN GARDE : Coupez l’alimentation au
- Page 14 – Bas du détecteur; ESSAIS ET RÉGLAGES; Portée maximale
- Page 15 – FICHE TECHNIQUE; GUIDE DE DÉPANNAGE; manuelle; GARANTIE LIMITÉE D’UN AN :
D
ual
B
rite
®
Motion Sensor
Light Control
Light Control
2 Lamps
(installed)
Cover Plate
Sensor
Lamp Holders
This package includes:
TEST
TEST 1 5 20
ON-TIME
Off 3 6 Dusk to
Dawn
D
ual
B
rite
®
Put ON-TIME switch
on the sensor bottom
to TEST and the D
ual
-
B
rite
®
switch OFF.
OPERATION
* resets to Auto Mode at dawn.
ON-TIME
TEST
1 5 20
... back on.
1 Second OFF
then...
Put the ON-TIME switch in the 1, 5,
or 20 minute position.
Manual mode only works at night
because daylight returns the sensor
to AUTO.
Flip the light switch off for one second
then back on to toggle between AUTO
and MANUAL MODE.
Manual mode works only with the
ON-TIME switch in the 1, 5, or 20
position.
Note: When first turned on wait about 1
1
/
2
minutes for
the circuitry to calibrate.
Requirements
• The light control requires 120-volts AC.
• If you want to use Manual Mode, the control must be
wired through a switch.
•
S o m e c o d e s r e q u i r e i n s t a l l a t i o n b y a
qualified electrician.
• This product is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
Mode:
On-Time
Works: Day Night
Test
5 Seconds
x
x
Auto
1, 5, or 20 Min
x
Manual
To Dawn*
x
Accent
3, 6 Hr, to Dawn
x
AUTO
MANUAL MODE
Features
• D
ual
Z
one
™ Technology.
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• D
ual
B
rite
®
Timer.
• Photocell keeps the lighting off during daylight hours.
• LED indicates motion was sensed (day or night).
Plastic Hanger
Rubber Plug
Gasket
6 Screws
(3 sizes included)
Mounting Strap
Mounting Bolt
2 Wire
Connectors
598-1325-00
LPG-5597
®
Operating Instructions & Parts Manual
2LBL3, 2LBL4
HEA 009
Printed in China
09/07
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or main-
tain the product described. Protect yourself and others by observing all safety information. Failure to comply
could result in personal injury and/or property damage! Save these instructions for future reference.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 598-1325-00 CAUTION: To Avoid Fire Or Burn Hazards: • Allow fixture to cool before touching. The bulb and the fixture operate at high temperatures. • Keep fixture at least 2" (51 mm) from combustible materials. Do not aim at objects closer than 3' (1 m). • Use only T4 100W (max.), G8 tungsten ...
3 598-1325-00 Keep lamps at least 2" (51 mm) from the sensor and 2" (51 mm) from combustibles. Lock Nuts Mount the Light Control ❒ Place the mounting bolt through the front of the junction box cover. Push the small gasket hole over the mounting screw. ❒ Make sure the wire connectors and wire...
4 598-1325-00 Bottom of Sensor Avoid aiming the control at: • Objects that change temperature rapidly, such as heating vents and air conditioners. These heat sources could cause false triggering. • Areas where pets or traffic may trigger the control. • Nearby large, light-colored objects reflecting ...
