Jura 15372 - Manuals

2 For your safety 8 U Never allow the mains cable to loosely hang down� The mains cable could pose a tripping hazard or become damaged� U Protect the E8 from weather and direct sun-light� U Only connect the E8 to a mains voltage corre-sponding to that stated on the rating plate� The rating plate is ...

2 For your safety 9 cloth rather than a wet one, and protect it from prolonged exposure to water splash� The E8 must not be cleaned with a jet of water� U The E8 is not suitable for installation on a surface where a jet of water can be used� U Do not touch the spouts during operation� Use the handle...

3 Preparing and using for the first time 10 3 Preparing and using for the first time When setting up your E8, please note the following: U Choose a spot for your E8 which protects the machine against overheating� Ensure that the ventilation slots are not covered� U Place the E8 on a horizontal surfa...

3 Preparing and using for the first time 11 If the machine is operated with a defective mains cable, there is a danger of potentially fatal electric shock� T   Never use a machine which is damaged or has a defective mains cable� Milk, sparkling mineral water or other liquids can damage the water tan...

3 Preparing and using for the first time 12 ‘System is filling’‘Empty drip tray’ T   Empty the drip tray and coffee grounds container and put them back into the machine� T   Place one receptacle under the coffee spout and another under the fine foam frother� ‘Rinse the coffee system’‘Rinse the milk ...

4 Preparation 13 4 Preparation Basic information about preparing drinks: Aim What to do Change the coffee strength of a single product Press the 9 or 0 button during grinding Change the amount for a single product Press the 9 or 0 button during preparation E The longer you press the 9 and 0 buttons,...

4 Preparation 14 E If you press your preselection briefly, the next product will be prepared according to your preselection� E If you press and hold your preselection (for two seconds), the preselection will be active until you switch off your E8� Example:  Coffee T   Place a cup under the coffee sp...

4 Preparation 15 ‘Doppio’ is Italian for ‘double’� When you select Espresso doppio, two espressi are prepared one after the other� The result is an extra full-bodied and aromatic speciality coffee� You can choose to use a second coffee variety, for example decaf-feinated coffee, with the filter funn...

4 Preparation 17 Press the button of a product on the start screen for about two seconds to view the list of settings ( ‘Product settings’ )� Permanent settings in programming mode always follow the same model� Example:  Proceed as follows to change the coffee strength for one coffee� T   Press the ...

5 Daily operation 18 5 Daily operation T   Place one receptacle under the coffee spout and another under the fine foam frother� T   Press the On/Off button Q � E When the machine is switched off, the system is only rinsed if a speciality coffee has been prepared� E If milk has been prepared before s...

5 Daily operation 19 Maintenance action Daily If necessary Note Clean the fine foam frother (if heavily soiled, also dismantle it) x (see chapter 7 ‘Maintenance – Dismantling and rinsing the fine foam frother’) Rinse the milk pipe x – Rinse the water tank x – Wipe the surface of the machine with a c...

6 Machine settings 20 6 Machine settings Press the f button to enter the Cockpit� In the ‘Machine setting’ f section, you can make the following settings: Programme item Explanation ‘Choose language’ Set language ‘Switch off after’ Set the automatic switch-off time to save energy (switch-off after 1...

7 Maintenance 21 7 Maintenance Basic information about maintenance: U Press the f button to enter the Cockpit� This area consists of a ‘Maintenance status’ c section and a ‘Machine setting’ f section� You can manage the maintenance of your E8 in the c section� U If a maintenance programme needs to b...

7 Maintenance 22 T   Place a receptacle under the fine foam frother� T   Press the f button� T   Press the c button� T   Press the ‘Rinse the milk system’ button to start the rinse operation�The fine foam frother is rinsed� The fine foam frother must be cleaned daily if milk has been pre- pared to m...

7 Maintenance 23 If insufficient foam is produced when the milk is frothed or milk sprays out of the fine foam frother, this may get dirty� If this hap-pens, dismantle and rinse the fine foam frother� T   Remove the milk pipe and rinse it thoroughly under running water� T   Remove the fine foam frot...

7 Maintenance 24 Precondition:  The start screen is displayed� (Alternatively, the filter symbol $ is displayed in red in the Cockpit if you are already using a filter�) T   Remove and empty the water tank� T   Turn the filter cartridge anticlockwise and remove it along with the extension from the w...

7 Maintenance 25 T   Press the ‘Next’ button� Water flows out of the coffee spout and the fine foam frother�The operation is interrupted, ‘Add cleaning tablet’ � T   Open the cover of the filler funnel for ground coffee� T   Insert a JURA cleaning tablet into the filler funnel� T   Close the filler ...

7 Maintenance 26 T   Press the ‘Start’ button� ‘Empty drip tray’ T   Empty the drip tray and coffee grounds container and put them back into the machine� ‘Agent in tank’ T   Remove and empty the water tank� T   Completely dissolve 3 JURA descaling tablets in a receptacle holding 500 ml of water� Thi...

7 Maintenance 27 Limescale deposits may form in the water tank� To ensure correct function of the machine, descale the water tank from time to time� T   Remove the water tank� T   If you use a CLARIS Smart filter cartridge, remove this� T   Completely fill the water tank and dissolve 3 JURA descalin...

8 Display messages 28 8 Display messages Messages on the start screen Message Cause/Result Action ‘Fill water tank’ The water tank is empty� You cannot prepare any products� T Fill the water tank (see chapter 5 ‘Daily operation – Filling the water tank’)� ‘Empty grounds’ / ‘Empty drip tray’ The coff...

9 Troubleshooting 29 9 Troubleshooting Problem Cause/Result Action Insufficient foam is produced when the milk is frothed or milk sprays out of the fine foam frother� The fine foam frother is dirty� T Clean the fine foam frother (see chapter 7 ‘Maintenance – Cleaning the milk system’)� T Dismantle a...

10 Transport and environmentally friendly disposal 30 10 Transport and environmentally friendly disposal Keep the packaging for your E8� It should be used to protect the machine during transport� In order to protect the E8 from frost during transport, the system must be emptied� Precondition:  The s...

11 Technical data 31 11 Technical data Voltage 220–240 V ~, 50 Hz Power 1450 W Conformity mark A Pump pressure static, max� 15 bar Holding capacity of water tank (without filter) 1�9 l Holding capacity of bean container 280 g Holding capacity of coffee grounds container max� 16 portions Cable length...

13 JURA contact details / Legal information 36 13 JURA contact details / Legal information JURA Elektroapparate AGKaffeeweltstrasse 10CH-4626 NiederbuchsitenTel� +41 (0)62 38 98 233 E You can find additional contact details for your country at jura.com. E If you need assistance with using your machi...