Page 2 - Your Z8
2 Table of contents Your Z8 Control elements 4 Important information 6 Proper use ...................................................................................................................................................... 6For your safety .....................................................
Page 3 - ‘Coffee’; Symbol description
3 Table of contents Warnings J WARNING J CAUTION Always take note of any information marked with the words CAUTION or WARNING and a warning sign. The signal word WARNING draws your attention to potential serious injury, and the signal word CAUTION to potential minor injury. CAUTION CAUTION draws you...
Page 4 - Control elements
4 Control elements Control elements 4 7 3 6 11 10 8 9 5 12 13 2 1 1 Cover for powder chute for ground coffee 2 Powder chute for ground coffee 3 Water tank 4 Mains cable (permanently connected or disconnectable) (back of the machine) 5 Hot-water spout 6 Coffee grounds container 7 Drip tray 8 Cover ca...
Page 5 - Touchscreen display
5 Control elements 2 1 1 Touchscreen display 2 Rotary Switch Back of the machine: Service socket for JURA Smart Connect Accessories Container for milk system cleaning Measuring spoon for ground coffee Filler funnel for ground coffee
Page 6 - Important information; To avoid danger of potentially fatal electric shock:
6 Important information Important information The machine is designed and intended for private domestic use. It should only be used for coffee preparation and to heat milk and water. Use for any other purpose will be deemed improper. JURA Elektroapparate AG cannot accept any responsibil-ity for the ...
Page 7 - There is a risk of scalds or burns on the spouts.
7 Important information which is available directly from JURA or from authorised JURA service centres. U Make sure that the Z8 and the mains cable are not located close to hot surfaces. U Be careful to ensure that the mains cable is not trapped and does not rub against sharp edges. U Never open and ...
Page 8 - Only fill the water tank with fresh, cold water.
8 Important information U Protect the Z8 from environmental influences such as rain, frost and direct sunlight. U Do not immerse the Z8, mains cable or con-nections in water. U Do not put the Z8 or any individual parts in the dishwasher. U On models with glass cup grille: Do not sub-ject the glass c...
Page 9 - Do not allow children to play with the machine.
9 Important information U Children may not clean or service the machine unless supervised by a responsible person. U Do not allow children to play with the machine. U Keep children under the age of 8 away from the machine, or supervise them constantly. U Children aged 8 and over may only operate the...
Page 10 - Preparing and using for the first time; Visit us on the Internet. You can download; JURA on the Internet
10 1 Preparing and using for the first time 1 Preparing and using for the first time Visit us on the Internet. You can download short operating instruc- tions for your machine from the JURA website (www.jura.com). You will also find interesting and up-to-date information on your Z8 and on every aspe...
Page 11 - Setting up the machine; CAUTION
11 1 Preparing and using for the first time When setting up your Z8, please note the following: U Place the Z8 on a horizontal surface that is not sensitive to water. U Choose a spot for your Z8 which protects the machine against overheating. Ensure that the ventilation slots are not covered. The be...
Page 13 - without
13 1 Preparing and using for the first time Operation without filter cartridge: see Chapter 1 ‘Preparing and using for the first time – First-time use without filter cartridge acti-vation’. Milk, sparkling mineral water or other liquids can damage the water tank or the machine. T Only fill the wat...
Page 14 - ‘No filter’
14 1 Preparing and using for the first time E If the filter is active, this is indicated by a blue filter symbol at the top of the display. Milk, sparkling mineral water or other liquids can damage the water tank or the machine. T Only fill the water tank with fresh, cold water. T Touch ‘No filt...
Page 15 - Connecting milk
15 1 Preparing and using for the first time Your Z8 creates fine, creamy, feather-light milk foam with a perfect consistency. The most important requirement for frothing milk is a milk temperature of 4–8 °C. We would therefore recommend using a milk cooler or a vacuum milk container. T Connect the...
Page 16 - Preparation; ‘Cancel’
16 2 Preparation 2 Preparation Basic information about preparing drinks: U During the grinding operation you can change the coffee strength of single products : To do this, move your finger across the display or turn the Rotary Switch. U During preparation you can change the preset amounts (e.g. amo...
Page 17 - Only some of
17 2 Preparation Using the product selector view (Rotary Selection): Only some of the products you can prepare are shown on the start screen. As soon as you turn the Rotary Switch, more products are displayed in a product selector view . Turn the Rotary Switch or move your finger across the display ...
Page 18 - two ristretti
18 2 Preparation Example: Proceed as follows to prepare two ristretti (using product selector view). Precondition: The start screen is displayed. T Place two cups under the dual spout. T Turn the Rotary Switch to view the product selector. T Move your finger across the display until ‘2 x Ris...
Page 19 - ‘Not enough ground coffee’; Ground coffee
19 2 Preparation For the ‘caffè Barista’ and ‘lungo Barista’, the Z8 blends the coffee with hot water using a special preparation method. This results in a full-bodied speciality coffee which is particularly light and digestible. You can change the amount of this additional water (see Chapter 4 ‘Per...
Page 20 - ‘Please select product’; Adjusting the grinder
20 2 Preparation T Fit the filler funnel for ground coffee. T Place one level measuring spoon of ground coffee into the filler funnel. T Remove the filler funnel and close the cover of the powder chute. ‘Please select product’ T Touch ‘Espresso’ . Preparation starts. ‘Espresso’ appears and t...
Page 21 - ‘Hot water’; Hot water
21 2 Preparation The Z8 allows you to prepare different variants of hot water: U ‘Hot water’ U ‘Hot water for black tea’ U ‘Hot water for green tea’ There is a danger of scalding from hot water splashes. T Avoid direct contact with the skin. Example: Proceed as follows to prepare hot water for gr...
Page 22 - Daily; Filling the water tank; Daily maintenance
22 3 Daily operation 3 Daily operation Daily maintenance of the machine and hygiene when handling milk, coffee and water are key to a perfect coffee result in the cup every time. You should therefore change the water daily. Milk, sparkling mineral water or other liquids can damage the water tank or ...
Page 23 - regularly; Regular maintenance
23 3 Daily operation T Refit the coffee grounds container and the drip tray. T Rinse the water tank with clean water. T Clean the milk system in the dual spout (see Chapter 5 ‘Maintenance – Cleaning the milk system’). T Remove the milk pipe and rinse it thoroughly under running water. T Di...
Page 24 - tem’
24 3 Daily operation When the Z8 is switched off, the system is automatically rinsed if a speciality coffee has been prepared. If milk has been prepared, you will also be prompted to clean the milk system. Precondition: The start screen is displayed. (Or ‘Clean the milk sys- tem’ is displayed if mi...
Page 25 - Permanent settings in programming mode; Programme item
25 4 Permanent settings in programming mode 4 Permanent settings in programming mode Touch ‘ P ’ to enter programming mode. Move your finger across the display to navigate through the programme items and permanently save the desired settings. The following settings can be made: Programme item Sub-it...
Page 26 - Product settings
26 4 Permanent settings in programming mode Touch a product for about 2 seconds to view the list of setting options: U ‘Product settings’ : Specify individual settings such as coffee strength, amount of water etc. U ‘Product name’ : Change the name of the product. U ‘Delete’ : Remove a product from ...
Page 27 - Product
27 4 Permanent settings in programming mode Product Coffee strength Amount More settings Latte macchiato 10 levels Coffee: 25 ml – 240 mlMilk foam: 0 sec. – 120 sec.Milk: 0 sec. – 120 sec.Interval: 0 sec. – 60 sec. Milk and milk foam tempera-ture, temperature (low, normal, high), product name, delet...
Page 28 - Automatic switch-off
28 4 Permanent settings in programming mode T Now move your finger to the left or right to change the set- ting for the coffee strength. T Touch ‘Save’ . ‘Saved’ appears briefly on the display. T Touch ‘Back’ the number of times needed to display the start screen again. By instructing your Z8 ...
Page 29 - All user settings; Restore factory settings
29 4 Permanent settings in programming mode U ‘Inactive’ U All speciality coffees, speciality coffees with milk and hot water can be prepared without having to wait. Example: Proceed as follows to switch energy-saving mode off. Precondition: The start screen is displayed. T Touch ‘ P ’ . ‘Machin...
Page 30 - Unit for amount of water
30 4 Permanent settings in programming mode In the programme item ‘Machine settings’ / ‘Units’ you can select the unit used for the amount of water. Example: Proceed as follows to change the unit for the amount of water from ‘ml’ to ‘oz’ . Precondition: The start screen is displayed. T Touch ‘...
Page 31 - Language
31 4 Permanent settings in programming mode T Touch ‘Back’ the number of times needed to display the start screen again. The harder the water is, the more frequently the Z8 needs to be descaled. It is therefore important to set the water hardness accu-rately. The water hardness was set when the ma...
Page 32 - Water tank illumination
32 4 Permanent settings in programming mode T Touch ‘Choose language’ . ‘Choose language’ T Move your finger across the display until the desired lan- guage, e.g. ‘Deutsch’ , is displayed in the centre. T Touch ‘Save’ . ‘Gespeichert’ appears briefly on the display. ‘Sprachauswahl’ T Touch ‘Z...
Page 33 - Querying information
33 4 Permanent settings in programming mode In the programme item ‘Machine settings’ you can view the follow- ing information: U ‘Product counter’ : Number of prepared coffee speciality cof- fees, speciality coffees with milk and hot water U ‘Maintenance counter’ : Number of maintenance programmes p...
Page 34 - Maintenance; daily; Rinsing the machine
34 5 Maintenance 5 Maintenance Your Z8 has the following integrated maintenance programmes: U Rinsing the machine ( ‘Rinse’ ) U Rinsing the milk system in the dual spout U Cleaning the milk system in the dual spout ( ‘Clean the milk system’ ) U Changing the filter ( ‘Change the filter’ ) (only if fi...
Page 35 - automatically; Cleaning the milk system
35 5 Maintenance 15 minutes after milk preparation, the milk system is automatically rinsed. Therefore always place a receptacle under the dual spout after preparing milk. To ensure that the milk system in the dual spout always works prop-erly, you must clean it daily when you have been preparing mi...
Page 37 - Inserting the filter
37 5 Maintenance T Fit the assembled individual parts back in the dual spout and press it firmly. T Fit the cover of the dual spout. Make sure the cover of the dual spout is correctly fitted. T Connect the milk pipe to the dual spout. Your Z8 no longer has to be descaled if you are using the C...
Page 38 - new; Changing the filter
38 5 Maintenance ‘Filter operation’ / ‘Saved’ ‘Filter is being rinsed’ , the filter is rinsed. The water flows directly into the drip tray. ‘Empty drip tray’ T Empty the drip tray and put it back into the machine. ‘Filter operation’ / ‘Filter rinsing complete’ The start screen is displayed. Your Z...
Page 39 - Cleaning the machine
39 5 Maintenance After 180 preparations or 80 switch-on rinses, the Z8 will prompt you to clean it. If the wrong cleaning agent is used, the machine could be damaged and/or traces could be left behind in the water. T Use only original JURA maintenance products. E The cleaning programme lasts appro...
Page 40 - Descaling the machine
40 5 Maintenance T Empty the drip tray and coffee grounds container and put them back into the machine.Cleaning is now complete. The start screen is displayed. The Z8 builds up deposits of limescale over time and automatically prompts you to descale it when necessary. The degree of calcifica-tion ...
Page 41 - empty
41 5 Maintenance T Empty the drip tray and coffee grounds container and put them back into the machine. ‘Pour descaling agent into water tank’ T Remove and empty the water tank. T Completely dissolve 3 JURA descaling tablets in a receptacle holding 600 ml of water. This may take several minute...
Page 42 - ‘Fill bean container’; Descaling the water tank
42 5 Maintenance Limescale deposits may form in the water tank. To ensure correct function of the machine, descale the water tank from time to time. T Remove the water tank. T If you use a CLARIS Smart filter cartridge, remove this. T Completely fill the water tank and dissolve 3 JURA descalin...
Page 43 - Display; Message
43 6 Display messages 6 Display messages Message Cause/Result Action ‘Fill water tank’ The water tank is empty. You can-not prepare any products. T Fill the water tank (see Chapter 3 ‘Daily operation – Filling the water tank’). ‘Empty coffee grounds container’ / ‘Empty drip tray’ The coffee grounds ...
Page 44 - Troubleshooting; Problem
44 7 Troubleshooting 7 Troubleshooting Problem Cause/Result Action Insufficient foam is produced when the milk is frothed or milk sprays from the dual spout. The dual spout is dirty. T Make sure the cover of the dual spout is correctly fitted. T Clean the milk system in the dual spout (see Chapter 5...
Page 45 - Transport and environmentally friendly disposal; Disposal
45 8 Transport and environmentally friendly disposal 8 Transport and environmentally friendly disposal Keep the packaging for your Z8. It should be used to protect the machine during transport. In order to protect the Z8 from frost during transport, the system must be emptied. Precondition: The sta...
Page 46 - Technical; ‘Save energy’
46 9 Technical data 9 Technical data Voltage Art. 15063 220–240 V ~, 50 Hz Art. 15062 230 V ~, 50 Hz Art. 15147 240 V ~, 50 Hz Power Art. 15063 2450 W Art. 15062 /Art. 15147 2300 W Conformity mark A Energy consumption ‘Save energy’ / ‘1’ approx. 8 Wh Energy consumption ‘Save energy’ / ‘0’ approx. 25...
Page 52 - 1 JURA contact details / Legal information; You will find additional contact details for your country at
52 11 JURA contact details / Legal information 11 JURA contact details / Legal information JURA Elektroapparate AGKaffeeweltstrasse 10CH-4626 NiederbuchsitenTel. +41 (0)62 38 98 233 @ You will find additional contact details for your country at www.jura.com. The machine complies with the following d...