Jura 15268 - User Manual

6 Important information Important information The machine is designed and intended for private domestic use. It should only be used for coffee preparation and to heat milk and water. Use for any other purpose will be deemed improper. JURA Elektroapparate AG cannot accept any responsibil-ity for the ...

7 Important information which is available directly from JURA or from authorised JURA service centres. U Make sure that the E8 and the mains cable are not located close to hot surfaces. U Be careful to ensure that the mains cable is not trapped and does not rub against sharp edges. U Never open and ...

8 Important information U Protect the E8 from environmental influences such as rain, frost and direct sunlight. U Do not immerse the E8, mains cable or con-nections in water. U Do not put the E8 or any individual parts in the dishwasher. U Before cleaning, switch your E8 off with the On/Off button. ...

9 Important information U Do not allow children to play with the machine. U Keep children under the age of 8 away from the machine, or supervise them constantly. U Children aged 8 and over may only operate the machine without supervision if they have been instructed in how to use it safely. Chil-dre...

10 1 Preparing and using for the first time 1 Preparing and using for the first time Visit us on the Internet. You can download short operating instruc- tions for your machine from the JURA website (www.jura.com). You will also find interesting and up-to-date information on your E8 and on every aspe...

11 1 Preparing and using for the first time T   You will then be able to read the degree of water hardness from the discolouration of the Aquadur® test strip and the description on the packaging. If the machine is operated with a defective mains cable, there is a danger of potentially fatal electric...

12 1 Preparing and using for the first time T   Place a receptacle (at least 300  ml) under the fine foam frother. T   Remove the water tank and rinse it with cold water. T   Fit the filter cartridge extension supplied on top of a CLARIS Smart filter cartridge. T   Insert the filter cartridge with i...

13 1 Preparing and using for the first time Your E8 creates fine, creamy, feather-light milk foam with a perfect consistency. The most important requirement for frothing milk is a milk temperature of 4–8 °C. We would therefore recommend using a milk cooler or a vacuum milk container. T   Remove the ...

14 2 Preparation 2 Preparation Basic information about preparing drinks: U The display shows four products you can prepare. Press the ‘ > ’ button to display more products. U During the grinding operation you can select the coffee strength of single products by pressing the ‘ < ’ and ‘ > ’ ...

15 2 Preparation T   If you are using the professional fine foam frother, turn the selector switch to the Milk Foam position (see image). T   Press the ‘Latte macchiato’ button. ‘Latte macchiato’ appears and the preset amount of milk foam flows into the glass. E There is a short interval while the h...

16 2 Preparation To prepare two speciality coffees, press the appropriate preparation button twice (within approximately 1 second). Example:  Proceed as follows to prepare two espressi. Precondition:  The start screen ( ‘1/3’ ) is displayed. T   Place two cups under the coffee spout. T   Press the ‘...

17 2 Preparation To ensure that the fine foam frother always works properly, you must clean it daily when you have been preparing milk (see Chap- ter 5 ‘Maintenance – Cleaning the fine foam frother’). You can choose to use a second coffee variety, for example decaf-feinated coffee, with the filter f...

18 2 Preparation It is easy to permanently adjust the amount of water for all single products to the cup size. Adjust the amount once as shown in the following example. Every time you prepare a drink in the future, this amount will be dispensed. Example:  Proceed as follows to permanently set the am...

19 2 Preparation T   Place a cup under the coffee spout. T   Open the cover of the grinder adjustment switch. T   Press the ‘Espresso’ button to start preparation. T   Turn the grinder adjustment switch to the desired position while the grinder is running. The preset amount of water flows into the c...

20 3 Daily operation 3 Daily operation Daily maintenance of the machine and hygiene when handling milk, coffee and water are key to a perfect coffee result in the cup every time. You should therefore change the water daily. Milk, sparkling mineral water or other liquids can damage the water tank or ...

21 3 Daily operation T   Clean the fine foam frother (see Chapter 5 ‘Maintenance – Cleaning the fine foam frother’). T   Remove the milk pipe and rinse it thoroughly under running water. T   Dismantle and rinse the fine foam frother (see Chapter 5 ‘Maintenance – Dismantling and rinsing the professio...

22 4 Permanent settings in programming mode 4 Permanent settings in programming mode Press the ‘ P c  ’ button to enter programming mode. You can navi- gate through the programme items and permanently save the required settings using the multi-function buttons. The following settings can be made: Pr...

23 4 Permanent settings in programming mode Product Coffee strength Amount Temperature Cappuccino,Flat white 8 levels Coffee: 25 ml – 240 mlMilk: 3 sec. – 120 sec. normal, high Latte macchiato 8 levels Coffee: 25 ml – 240 mlMilk: 3 sec. – 120 sec.Interval: 0 sec. – 60 sec. normal, high Espresso macc...

24 4 Permanent settings in programming mode By instructing your E8 to automatically switch itself off, you can cut down your energy consumption. If this function is activated, your E8 switches off automatically after the preset time following the last action on the machine. You can set the automatic...

25 4 Permanent settings in programming mode In the programme item ‘4/5’ / ‘Rinse the milk system’ you can make the following settings: U ‘Manual’ : You are prompted to perform milk system rinsing 10 minutes after preparation of a speciality coffee with milk. U ‘Automatic’ : The milk system rinsing i...

26 4 Permanent settings in programming mode Example:  Proceed as follows to change the language from ‘English’ to ‘Deutsch’ . T   Press the ‘ P c  ’ button. T   Press the ‘ > ’ button several times until ‘4/5’ is displayed. T   Press the ‘Choose language’ button. ‘Choose language’ E To display mo...

27 5 Maintenance 5 Maintenance Your E8 has the following integrated maintenance programmes: U Rinsing the machine ( ‘Rinse the coffee system’ ) U Rinsing the fine foam frother ( ‘Rinse the milk system’ ) U Cleaning the fine foam frother ( ‘Clean the milk system’ ) U Changing the filter ( ‘Change the...

31 5 Maintenance T   Re-assemble the fine foam frother. E Ensure that all individual parts are correctly and firmly connected to ensure optimum operation of the fine foam frother. T   Re-fit the fine foam frother on the milk system. Your E8 no longer has to be descaled if you are using the CLARIS Sm...

32 5 Maintenance Rinsing of the filter stops automatically. The start screen is displayed. After 180 preparations or 80 switch-on rinses, the E8 will prompt you to clean it. If the wrong cleaning agent is used, the machine could be damaged and/or traces could be left behind in the water. T   Use onl...

33 5 Maintenance The E8 builds up deposits of limescale over time and automatically prompts you to descale it when necessary. The degree of calcifica-tion depends on the hardness of your water. E If you are using a CLARIS Smart filter cartridge, you will not be prompted to descale. If the descaling ...

35 5 Maintenance Coffee beans may be covered with a slight oil film which remains on the walls of the bean container. These traces may negatively affect the coffee result. For this reason clean the bean container from time to time. Precondition:  ‘Fill bean container’ is displayed. T   Switch the ma...

36 6 Display messages 6 Display messages Message Cause/Result Action ‘Fill water tank’ The water tank is empty. You cannot prepare any products. T Fill the water tank (see Chapter 3 ‘Daily operation – Filling the water tank’). ‘Empty coffee grounds container’ The coffee grounds container is full. Yo...

37 7 Troubleshooting 7 Troubleshooting Problem Cause/Result Action Insufficient foam is produced when the milk is frothed or milk sprays out of the fine foam frother. The fine foam frother is dirty. T Clean the fine foam frother (see Chapter 5 ‘Maintenance – Cleaning the fine foam frother’). T Disma...

38 8 Transport and environmentally friendly disposal 8 Transport and environmentally friendly disposal Keep the packaging for your E8. It should be used to protect the machine during transport. In order to protect the E8 from frost during transport, the system must be emptied. Precondition:  The sta...

39 9 Technical data 9 Technical data Voltage 220–240 V ~, 50 Hz Power 1450 W Conformity mark A Pump pressure static, max. 15 bar Holding capacity of water tank (without filter) 1.9 l Holding capacity of bean container 280 g Holding capacity of coffee grounds container max. 16 portions Cable length a...

42 10 Index T Technical data 39Tel 44Transport 38Troubleshooting 37Two products 16 U Unit for amount of water 25Use, First-time 11 W Warm milk 16Water hardness Determining the water hardness 10Setting the water hardness 24 Water tank 4 Descaling 35Filling 20 Website 10Wireless connection 13

44 11 JURA contact details / Legal information 11 JURA contact details / Legal information JURA Elektroapparate AGKaffeeweltstrasse 10CH-4626 NiederbuchsitenTel. +41 (0)62 38 98 233 @ You will find additional contact details for your country at www.jura.com. @ If you need assistance with using your ...