Transition Networks SBFTF1010-130 - Manual
Transition Networks SBFTF1010-130 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Product Features; Front panel; Data Transfer rate; AutoCrossTM; Redundancy
- Page 3 – Installation; Jumper; Note
- Page 4 – Cable Specifications; Operation
- Page 5 – Troubleshooting
- Page 6 – Technical specifications; Contact Us; Technical support
- Page 7 – Compliance Information
User’s Guide
SBFTF1010-130
10/100 Fault-Tolerant Redundant Link
Protector
• 10/100 Base-T(x) to 10/100 Base-T(x)
• Ethernet/Fast Ethernet
The SBFTF1010-130 is a fault-tolerant redundant link protector provides redundant
paths for fast Ethernet devices. It has three ports: main, primary, and backup. Typically,
the main port connects to a critical 10/100 fast Ethernet device. The primary port and the
backup port connect to two different switch ports or two different ports on separate
switches. When the unit powers up, it checks the primary port for a link signal; if the
signal is present, the main and primary ports connect and the signal from the backup port
is then disabled. Any device connected to the backup port will not detect a signal at this
time. However, if the device does not detect a signal on the primary port, then the main
port and backup port connect.
Product features . . . . . . . . . . . . . . . .2
Installation . . . . . . . . . . . . . . . . . . . .4
Operation . . . . . . . . . . . . . . . . . . . . .7
Cable Specifications . . . . . . . . . . . . .7
Troubleshooting . . . . . . . . . . . . . . . .8
Technical Specifications . . . . . . . . .10
Contact Us . . . . . . . . . . . . . . . . . . .11
Compliance Information . . . . . . . . .12
*Typical maximum cable distance. Actual distance is dependent upon the physical
characteristics of th network.
Part Number
Port One - Copper
10/100Base-T(x)
Port Two Copper
10/100Base-T(x)
Port Three - Copper
10/100Base-T(x)
SBFTF1010-130
RJ-45 100 M
(328 ft*)
RJ-45 100 M
(328 ft*)
RJ-45 100 M
(328 ft*)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Product Features Front panel The SBFTF1010-130 bridging media converter has three 10/100Base-TX ports. Auto-Negotiation (selectable) The Auto-Negotiation feature automatically configures the bridging mediaconverter to achieve the best possible mode of operation over a link. The bridgingmedia convert...
4 SBFTF1010-130 Tech Support: 1-800-260-1312 International: 00-1-952-941-7600, 24 hours Installation CAUTION: Do Not install the SBFTF1010-130 fault-tolerant redundant link protectorin location where it might be exposed to wetness. Failure to observe this caution couldresult in damage to the device....
6 SBFTF1010-130 Tech Support: 1-800-260-1312 International: 00-1-952-941-7600, 24 hours Connecting power to the bridging media converter AC/DC: 1. Connect the barrel connector of the adapter to the power port of the bridging media converter (located on the back of the converter shown below). 2. Conn...
