Transition Networks E-TX-FX-1200 - Manual
Transition Networks E-TX-FX-1200 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TECHNICAL SPECIFICATIONS; Humidity
- Page 3 – CABLE SPECIFICATIONS; COPPER CABLE; Each RJ-45 connector requires 2 pairs of Category 5 rated cable.; TELCO CONNECTOR; Media Converter Port in Full-Duplex Network; The 512-Bit Rule applies separately to each collision domain.; USING THE 512-BIT RULE; the result is less than or equal to 512 bit-times, the path is good.
- Page 4 – INSTALLATION; Separate rubber feet.; Fiber Cable; MULTIMODE
- Page 5 – FAULT ISOLATION and CORRECTION; YES; Install Cable; COPPER; Connect to Power
- Page 6 – OPERATION; Steady green LED indicates good link on; ACTIVITY; Flashing; green; LED indicates; POWER; Using LinkAlertTM
COMPLIANCE INFORMATION
UL Listed
C-UL Listed (Canada)
CISPR/EN55022 Class A
FCC Regulations
This equipment has been tested and found to comply with the limits for a class A digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at the user’s own expense.
Canadian Regulations
This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on
the radio interference regulations of the Canadian Department of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables
aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique
édicté par le ministère des Communications du Canada.
European Regulations
Warning
This is a Class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures.
Achtung !
Dieses ist ein Gerät der Funkstörgrenzwertklasse A. In Wohnbereichen können bei Betrieb dieses Gerätes
Rundfunkstörungen auftreten, in weichen Fällen der Benutzer für entsprechende Gegenmaßnahmen
werantwortlich ist.
Attention !
Ceci est un produit de Classe A. Dans un environment domestique, ce produit risque de créer des
interférences radioélectriques, il appartiendra alors à l’utilsateur de prende les measures spécifiques
appropriées
Trademark Notice
All registered trademarks and trademarks are the property of their respective owners.
Copyright Restrictions
© 1999 TRANSITION Networks.
All rights reserved. No part of this work may be reproduced or used in any form or by any means –
graphic, electronic, or mechanical – without written permission from TRANSITION Networks.
Printed in the U.S.A.
33134.B
CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE
PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in
damage to the public telephone network.
Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten
verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur
Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen
einschliesslich der gegenseitigen Anerkennung ihrer Konformität.
The rack-mountable E-TX-FX-1200, E-TEL-1200, and E-TX-FX-0600 series
multi-port media converters with
LinkAlert™*
allow the network
administrator of a large and complex network to extend the distances
between multiple sets of 100BASE-TX and 100BASE-FX devices.
E-TX-FX-1200
(shown)
Provides twelve (12) independent media converter
connections between Fast Ethernet
™
over twisted-pair copper (twelve RJ-45
connectors) and Fast Ethernet
™
over singlemode or multimode fiber (twelve
fiber connectors, selected as a set according to network requirements).
E-TEL-1200
(not shown)
Provides twelve (12) independent media converter
connections between Fast Ethernet
™
over twisted-pair copper (one 50-pin Telco
connector) and Fast Ethernet
™
over singlemode or multimode fiber (twelve fiber
connectors, selected as a set according to network requirements).
E-TX-FX-0600
(not shown)
Provides six (6) independent media converter
connections between Fast Ethernet
™
over twisted-pair copper (six RJ-45
connectors) and Fast Ethernet
™
over singlemode or multimode fiber (six fiber
connectors, selected as a set according to network requirements).
*The LinkAlert™ feature allows each
media converter port to pass link faults
between connected 100BASE-TX and
100BASE-FX devices.
Minneapolis, MN 55344 USA
100BASE-TX/100BASE-FX
Multi-Port Media Converter
E-TX-FX-1200, E-TEL-1200, E-TX-FX-0600
USER’S GUIDE
Fiber Cable/Connector Options* by Model:
E-TX-FX-xx00/E-TEL-1200: multimode fiber, ST connectors
E-TX-FX-xx00(SC)/E-TEL-1200(SC): multimode fiber, SC connectors
E-TX-FX-xx00(MT)/E-TEL-1200(MT): multimode fiber, MT-RJ connectors
E-TX-FX-xx00(SM)/E-TEL-1200(SM): singlemode fiber, SC connectors
E-TX-FX-xx00(LH)/E-TEL-1200(LH): singlemode fiber, SC connectors
*See page 9 for detailed specifications.
E-TX-FX-xx00 in the Network . . . . . .2
Installation . . . . . . . . . . . . . . . . . . . .4
Operation . . . . . . . . . . . . . . . . . . . . .6
Fault Isolation and Correction . . . . .8
Cable Specifications . . . . . . . . . . . . .9
Technical Specifications . . . . . . . . .11
Compliance Information . . . . . . . . .12
1
4
3
2
5
6
ACT
FBR LINK
TP LINK
ACT
FBR LINK
TP LINK
ACT
FBR LINK
TP LINK
ACT
FBR LINK
TP LINK
ACT
FBR LINK
TP LINK
ACT
FBR LINK
TP LINK
7
10
9
8
11
12
ACT
FBR LINK
TP LINK
ACT
FBR LINK
TP LINK
ACT
FBR LINK
TP LINK
ACT
FBR LINK
TP LINK
ACT
FBR LINK
TP LINK
ACT
FBR LINK
TP LINK
POWER
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
E-TX-FX-XX00 IN THE NETWORK Each media converter port in the multi-port media converter operatesindependently over one isolated twisted-pair copper/fiber-optic cablelink. The media converter port receives and transmits network signals ineither full-duplex or half-duplex, depending upon the network d...
CABLE SPECIFICATIONS (continued) COPPER CABLE Each RJ-45 connector requires 2 pairs of Category 5 rated cable. The 50-pin Telco connector requires 24 pairs of Category 5 ratedcable. Either shielded twisted-pair (STP) or unshielded twisted-pair (UTP) canbe used. DO NOT USE FLAT OR SILVER SATIN WIRE. ...
INSTALLATION Install E-TX-FX-xx00 at Site WARNING: During the site installation, handle the E-TX-FX-xx00 in such away that the E-TX-FX-xx00 does not fall. Failure to observe this warningcould result in injury to personnel and/or equipment damage. To install the E-TX-FX-xx00 in 19-inch rack cabinet: ...
