Transition Networks SSDTF1029-106 - Manuals

Transition Networks SSDTF1029-106 – Manual in PDF format online.

Manuals:

Manual Transition Networks SSDTF1029-106

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9

Summary

Page 2 - Optional Accessories; (includes universal internal power supply); Installation; Set the hardware/software jumper; The device mode is determined by the

2 SSDTF10xx-10x (TX) = transmit (RX) = receive * Typical maximum cable distance. Actual distance is dependent upon the physical characteristics of the network. ** SSDTF1029-105 and -106 are intended to be installed in the same network where one is the local device and the other is the remote device....

Page 3 - Set the loop-back switch; CL; fiber; Select T1 configuration

4 SSDTF10xx-10x Installation -- Continued Set the loop-back switch Hardware mode: The loop-back switch is located on the front panel of the device and is used forinstallation and network debugging procedures. To set the switch, use a small flat-blade screwdriver or asimilar device (see the drawing t...

Page 4 - Settings for T1 configuration

6 SSDTF10xx-10x Installation -- Continued Settings for T1 configuration (right switch set, SW 1) T1/long-haul signal Use switches 3 and 4 on the left switch set to select T1/long-haul signal (see the drawing below). Use switches 1 and 2 on the right switch set to select the proper network cablesetti...

Transition Networks Manuals