Transition Networks E-TX-FX-0600 - Manuals

Transition Networks E-TX-FX-0600 – Manual in PDF format online.

Manuals:

Manual Transition Networks E-TX-FX-0600

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6

Summary

Page 2 - TECHNICAL SPECIFICATIONS; Humidity

E-TX-FX-XX00 IN THE NETWORK Each media converter port in the multi-port media converter operatesindependently over one isolated twisted-pair copper/fiber-optic cablelink. The media converter port receives and transmits network signals ineither full-duplex or half-duplex, depending upon the network d...

Page 3 - CABLE SPECIFICATIONS; COPPER CABLE; Each RJ-45 connector requires 2 pairs of Category 5 rated cable.; TELCO CONNECTOR; Media Converter Port in Full-Duplex Network; The 512-Bit Rule applies separately to each collision domain.; USING THE 512-BIT RULE; the result is less than or equal to 512 bit-times, the path is good.

CABLE SPECIFICATIONS (continued) COPPER CABLE Each RJ-45 connector requires 2 pairs of Category 5 rated cable. The 50-pin Telco connector requires 24 pairs of Category 5 ratedcable. Either shielded twisted-pair (STP) or unshielded twisted-pair (UTP) canbe used. DO NOT USE FLAT OR SILVER SATIN WIRE. ...

Page 4 - INSTALLATION; Separate rubber feet.; Fiber Cable; MULTIMODE

INSTALLATION Install E-TX-FX-xx00 at Site WARNING: During the site installation, handle the E-TX-FX-xx00 in such away that the E-TX-FX-xx00 does not fall. Failure to observe this warningcould result in injury to personnel and/or equipment damage. To install the E-TX-FX-xx00 in 19-inch rack cabinet: ...

Transition Networks Manuals