Transition Networks CGETF10XX-10X - Manual
Transition Networks CGETF10XX-10X – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Part Number; Set the 3-position jumper; Installation; Set the 4-position switch; Pause
- Page 3 – Install the Fiber Cable; Install the copper cable; Operation; Status LEDs
- Page 4 – Operation - Continued; SNMP
- Page 5 – Fiber Cable; Fiber Cable; Technical Specifications
- Page 6 – Troubleshooting; Declaration of Conformity; Contact Us; Technical support
- Page 7 – Compliance Information; FCC regulations
User’s Guide
CGETF10xx-10x
Slide-in-Module Media Converter
• Gigabit Ethernet
• Copper to Fiber
• 1000Base-T to 1000Base-SX/LX
Transition Networks CGETF10xx-10x Gigabit
Ethernet media converter connects 1000Base-T
shielded or unshielded twisted-pair copper cable to
1000Base-SX or 1000Base-LX, fiber-optic cable.
The CGETF10xx-10x is also designed to be
installed in the Transition Networks
PointSystem™
chassis.
Installation . . . . . . . . . . . . . . . .2
Operation . . . . . . . . . . . . . . . .5
Cable Specifications . . . . . . . . .8
Technical Specifications . . . . .9
Troubleshooting . . . . . . . . . . .10
Contact Us . . . . . . . . . . . . . . .11
Compliance Information . . . .12
Part Number
Port One - Copper
Port Two - Duplex Fiber-Optic
CGETF1013-105
RJ-45 1000Base-T
100 m
(328 ft)*
SC, 1000Base-SX, 850 nm multimode
300 m
(984 ft)* (62.5/125
µ
m cable)
500 m
(1,640 ft)* (50/125
µ
m cable)
CGETF1014-105
RJ-45 1000Base-T
100 m
(328 ft)*
SC, 1000Base-LX, 1310 nm single mode
10 km
(6.2 miles)
*
CGETF1015-105
RJ-45 1000Base-T
100 m
(328 ft)*
SC, 1000Base-LX, 1310 nm single mode
25 km (15.5 miles)*
CGETF1017-105
RJ-45 1000Base-T
100 m
(328 ft)*
SC, 1000Base-LX, 1550 nm single mode
65 km
(40.4 miles)
*
CGETF1018-105
RJ-45 1000Base-T
100 m
(328 ft)*
MT-RJ, 1000Base-SX, 850 nm multimode
300 m
(984 ft)* (62.5/125
µ
m cable)
500 m
(1,640 ft)* (50/125
µ
m cable)
CGETF1024-105
RJ-45 1000Base-T
100 m
(328 ft)*
SC, 1000Base-SX, 1300 nm extended
multimode, 2 km
(1.2 miles)*
Note:
62.5/125
µ
m
(fiber only)
CGETF1035-105
RJ-45 1000Base-T
100 m
(328 ft)*
SC, 1000Base-LX, 1550 nm single mode
125 km
(77.5 miles)*
CGETF1039-105
RJ-45 1000Base-T
100 m
(328 ft)*
LC, 1000Base-SX, 850 nm multimode
300 m
(984 ft)* (62.5/125
µ
m cable)
500 m
(1,640 ft)* (50/125
µ
m cable)
*Typical maximum cable distance. Actual
distance is dependent upon the physical
characteristics of the network installation.
NOTE:
The stand-alone version of the media
converter is SGETF10xx-10x. For more
information, see the SGETF10xx-10x user’s
guide on-line at: www.transition.com.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 CGETF10xx-10x 24-hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600 Part Number Port One - Copper Port Two - Single Fiber-Optic CGETF1029-105 RJ-45 1000Base-T100 m (328 ft)* SC, 1000Base-LX, 1310 TX/1550 RX single mode, 20 km (12.4 miles)* CGETF1029-106 RJ-45 1000Base-T100 m (...
4 CGETF10xx-10x 24-hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600 Installation -- Continued Install the slide-in-module CAUTION: Slots in the PointSystem™ chassis without a slide-in-moduleinstalled MUST have a protective plate covering the empty slot for Class Acompliance. T...
6 CGETF10xx-10x 24-hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600 Operation - Continued Link Pass-Through The Link Pass-Through feature allows the media converter to monitor both thefiber and copper RX (receive) ports for loss of signal. In the event of a loss ofan RX signal...
