Husqvarna SD22B5DSA - Manual

SYMBoLS AND DECALS 6 1 2 4 5 7 8 9 6 3 WARNING!Xxxx xxx xxxx xx xxxx x xxxx. IMPORTANT INFORMATION Xxxx xxx xxxx xx xxxx x xxxx. Used in this publication to notify the reader of a risk of personal injury , particularly if the reader should neglect to follow instructions given in the manual. Used in ...

SYMBoLS AND DECALS 7 Decal Locations Height setting 1. Seeder Dial 2. DANGER watch your feet 3. Seed application chart 4. Warning for carbon monoxide 5. open/Close (Seedbox) 6. Caution graphics 7. Warning for bagger 8. Handle folding instructions 9. 1 1 2 3 3 3 4 5 5 5 6 7 8 9 9

SAFETY 8 General Use The object of this manual is to help you use your Husqvarna machine safely and to give you information about how to maintain your machine. Please read the manual carefully before attempting to use the machine.If after reading the operator’s manual you are still unsure about the ...

SAFETY 9 Check that the machine is in serviceable condition • prior to use; see the chapter “Maintenance/Maintenance Schedule”.only use the machine in daylight or in other well-lit • conditions. Keep the machine a safe distance from holes or other irregularities in the ground. Pay attention to other...

SAFETY 10 Operating Do not use the machine on grades of more than • 20°. We recommend working across slopes rather than up and down. This will yield a more even result. Do not leave the machine standing on a slope unattended.Do not use the machine if you are tired, if you • have consumed alcohol, or...

SAFETY 11 Movement/Transport To turn and steer the machine, press down on the • handle and turn on the back wheels.Turn off the engine and allow it to cool at least 2 • minutes before transport.Collapse the handle if the machine is equipped • with a collapsible handle.Be careful and use safe lifting...

SAFETY 12 Fuel System only store fuel in containers approved for that • purpose.Never remove the fuel cap and fill the fuel tank • when the engine is running.Always stop the engine when refueling. • Do not smoke when filling the gasoline tank and • do not pour gasoline in the vicinity of sparks or o...

SAFETY 13 Maintenance Never make adjustments with the engine running. • Disengage the drive units, shut off the engine and • wait until all moving parts come to a complete stop before making adjustments, performing maintenance or cleaning the machine.Disconnect the spark plug cable before beginning ...

CoNTRoLS 15 The dethatcher is available in two basic designs 18" and 22" widths.The machine is equipped with a 5.5 hp Briggs & Stratton, four-cycle engine.* * The power rating of the engines indicated is the average net power output (at specified rpm) of a typical production engine for t...

CoNTRoLS 16 Engine Refer to your engine manual. Fueling Read the safety instructions before fueling. Keep the fuel and fuel tank clean. Avoid filling the machine with dirty fuel. Make sure the fuel cap is properly tightened and the gasket is not damaged, particularly before washing the machine.Use u...

CoNTRoLS 17 Blade versatility Flail Blades Thatch is the dense layer of clippings, roots and stems that forms between the soil and the base of the grass. As thatch builds up, it prevents water, air and fertilizer from being absorbed into the soil. This causes shallow root development leading to vuln...

oPERATIoN 18 IMPORTANT INFORMATIONClear the lawn of any debris.Clearly mark rocks and other fixed objects.Be especially sure to check for hidden electrical cables or similar in the surface of the lawn. Before Starting Mow the lawn ½" shorter than normal. • Allow the lawn to dry. Wet conditions c...

oPERATIoN 19 2 3 1 2 1 Seed Application Preparing the Lawn Cut the grass to approximately ½" (1-1.5 cm) lower • than you normally would.Do not water before sowing. • Remove the layer of old grass cuttings (thatch). • Aerate the lawn with a core-type ground aerator. • Fertilize the lawn. • Seed A...

MAINTENANCE 20 1) First change after 20 hours. 2) In dusty conditions maintenance is required at shorter intervals. 3) Performed by authorized service workshop. 4) Performed every second year. With daily use, the machine shall be lubricated twice weekly. Maintenance Schedule The following is a list ...

MAINTENANCE 21 Drive Belt When checking the drive belt, allow the engine to 1. cool.Remove the spark plug cable. 2. Remove the belt guard (see illustration) on the left 3. side of the machine.Check that the belt is running in the proper track; 4. the pulleys should guide the belt in a straight line....

MAINTENANCE 23 Replacing worn flail blades Allow the engine to cool. 1. Disconnect the spark plug. 2. Tip the machine forward; see the section “Two 3. minute rule”. Remove e-rings (1) (locking washer type) that hold 4. the blade shaft (2) in place (see the illustration).Inspect the blade shafts and ...

MAINTENANCE 24 Spring Tines Wear/Replacing over time and due to wear, the tines will diminish in length. When the tines can no longer be adjusted to comb ¼" (6 mm) into the soil, the tines must be replaced. Delta Blades Wear/Replacing over time and due to wear, the blades will diminish in length...

MAINTENANCE 25 Two Minute Rule The machine may be tipped forward to facilitate access for cleaning or service, but no longer than 2 minutes . If the machine is held in this position for too long, the engine can be damaged by gasoline draining into the crankcase. Should this happen, perform an extra ...

LUBRICATIoN 26 2 4 3 3 1 2 Stop the engine and remove the ignition cable before attempting to lubricate the machine.Wipe away excessive grease after lubrication. It is important to avoid getting lubricant on the belt or the drive surfaces on the belt pulleys. Should this happen, attempt to clean the...

LUBRICATIoN 27 DT06 Blades Cover the blades with a thin coat of oil to avoid rust. This is particularly important prior to winter storage or if the machine will not be used for a period of longer than 30 days. Handle Lubricate the joints at both sides of the handle with an oil can.

TRoUBLESHooTING 28 Symptom Cause Action Engine will not start User error Fuel valve closed. open the fuel valve. Choke valve open Close the choke with cold engine. Engine switch in oFF position Turn the engine switch to oN Fuel system Fuel tank empty Fill with fuel Machine stored without observing p...

SToRAGE 29 Winter Storage At the end of the season, the machine should be readied for storage (or if it will not be in use for longer than 30 days). Fuel allowed to stand for long periods of time (30 days or more) can leave sticky residues that can plug the carburetor and disrupt engine function.Fue...

TECHNICAL DATA 30 18" POWER RAKE Engine Briggs & Stratton Primary drive V-belt Dethatching width 18" Clutch control Handle-mounted with automatic safety declutching Clutch Belt tightener with spring return and idling pulley mechanism Depth setting Adjustable depth control with lever mech...

32 SERVICE JoURNAL Action Date, stamp, signature Delivery service Break the packaging and make sure the machine has not been 1. damaged in transport.Where applicable, assemble accompanying components. 2. Check that the machine design corresponds to the 3. customer order.Check that the right amount o...