Husqvarna 122L - Quick Guide
Husqvarna 122L – Quick Guide, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Quick-start guide
See Operator’s manual for detailed starting instructions.
Attach loop handle to bracket by inserting TAB (A) into SLOT (B)
in handle. Insert BOLT (C) through handle, shaft, bracket and into
wing nut (D). Attach the J-handle (E) to the loop handle in compli-
ance with the illustration and tighten.
Attach guide to bracket by inserting TAB (A) on shaft bracket into
SLOT(B) in guide. Rotate guide until guide is flush with bracket.
Insert BOLT (C) through bracket.
Only for
122RJ
Set unit on a flat surface. Mix gasoline and 2-cycle
oil at 50:1 ratio. Shake well. Pour into fuel tank.
Press primer bulb 10 times.
Set choke lever to FULL position.
Move choke lever DOWN to RUN
position.
Squeeze throttle trigger to operate.
Hold the body of the product on the ground
with your left hand. Pull the starter rope
handle slowly with your right hand until you
feel resistance. Then pull the starter rope
handle quickly and with force until engine
starts or tries to start.
If the engine starts, push the throttle trigger lightly
and warm-up 60 seconds. If the engine does not
start, pull the starter rope handle until engine starts,
push the throttle trigger lightly and warm-up 60
seconds.
114 41 60-27 Rev. A 2024-07-15
1
2
3
4
5
6
7
8
9
A
A
B
B
C
C
E
D
D
122L
122RJ
B
C
A
60 sec.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
