Husqvarna 122LKH - Quick Guide
Husqvarna 122LKH – Quick Guide, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Quick-start guide
See Operator’s manual for detailed starting instructions.
Remove the set screw from the
cutting head. Align the arrow on the
shaft to the hole the cutting head.
Push the shaft into the cutting
you see the hole (A) through the
cutting head. Install and tighten the
set screw (B). Tighten the clamp
screws (C).
Attach loop handle to bracket by
inserting TAB (D) into SLOT (E) in
handle. Insert BOLT (F) through
handle, shaft, bracket and into wing
nut (G).
Set unit on a flat surface. Mix gasoline and
2-cycle oil at 50:1 ratio. Shake well.
Pour into fuel tank.
Press primer bulb 10 times.
Set choke lever to FULL position.
Move choke lever DOWN to RUN
position.
Squeeze throttle trigger to operate.
Hold the body of the product on the ground
with your left hand. Pull the starter rope
handle slowly with your right hand until you
feel resistance. Then pull the starter rope
handle quickly and with force until engine
starts or tries to start.
If the engine starts, push the throttle trigger lightly
and warm-up 60 seconds. If the engine does not
start, pull the starter rope handle until engine starts,
push the throttle trigger lightly and warm-up 60
seconds.
14 41 56-27 Rev. A 2024-07-15
1
2
3
4
5
6
7
8
9
60 sec.
Push the shaft into
the coupling until it
clicks in position.
E
D
G
F
C
B
A
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
