Husqvarna B1100028 - Manual
Husqvarna B1100028 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – SERVICE; Sub System Software; before; Demo mode
- Page 3 – New message codes in display
- Page 4 – Installation; able, install it before continue to step 3.
- Page 5 – Programming finished appears under the heading Status.
SERVICE
5
B1100028
2
3
4
5
1
90˚
90˚
3020-017
English 1 (5)
SB, Automower, New Software for 305, 305, 2011-04
General information
New Main software, MMI (Man Machine Interface) software and Sub System software have been
released for Automower
®
305. It is recommended to update all Automower
®
305 before delivery to
end customer.
• New Main Software (MSW): 1.01.00
• New MMI Software (MMI): 1.04.00
• New Sub System Software (SUB): 1.01.00
The new softwares includes the following changes:
• Calibration of guide has been improved
• Test Out and Test In procedure has been improved
• Demo mode has been introduced
• New message codes in display
• Sub System Software introduced
• Several minor SW improvements (not described in detail in this SB)
Detailed information
Calibration of guide
Improvements have been done in the calibration of guide. The purpose of calibration of guide is
that the guide width setting should have the same width (50 cm and 100 cm), irrespective of
garden layout.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
SERVICE 5 B1100028 English 2 (5) Calibration of guide is done automatically first time the mower leaves the charging station in the following situations: • New mower first start up • Always at Test Out • After changing guide width to Medium or Wide • After performing Factory reset • After changing m...
SERVICE 5 B1100028 English 3 (5) New message codes in display For improved diagnostic some extra message-codes have been added to the message “Electronic problem”. The message code appears within parenthesis after the message in mower display. The message code is not stored in the message history li...
SERVICE 5 B1100028 English 4 (5) Installation Use Autocheck EXP (part number 577 85 81-01) to make an automatic programming of the new main software and MMI software. Former Autocheck 9.X can not be used with Automower ® 305. Please follow below guide for how to make an automatic programming in Auto...
