Husqvarna 115 24 05-95 - Manual

Page 2 - English; REPAIR OR REPLACEMENT OF PARTS; FEDERAL EMISSION CONTROL WARRANTY STATEMENT

English 2 YOUR WARRANTY RIGHTS AND OBLIGATIONS The EPA (The US Environmental Protection Agency), CARB (California Air Resources Board), Environment Canada and Husqvarna Forest & Garden are pleased to explain the emissions control system warranty on your 2007 and later small nonroad engine. In U....

Page 3 - Contents

English 3 Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 SAFETY FIRST . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4Notes on types of warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 ...

Page 4 - SAFETY FIRST; Notes on types of war nings; Symbols; War ning labels on the machine

English 4 SAFETY FIRST Instructions contained in warnings within this manual and warning seals marked with a symbol on the blower concern critical points which must be taken into consideration to prevent possible serious bodily injury, and for this reason you are requested to read all such instructi...

Page 5 - Never let a child use the machine.; Safety Precautions

English 5 For safe operation and maintenance, symbols are carved in relief on the machine. Using to these indications, please be careful not to make a mistake. (a) The port to refuel the "MIX GASOLINE" Position: FUEL TANK CAP (b) The direction to close the choke Position: INTAKE CUP (c) The ...

Page 6 - WORKING CONDITIONS; WORKING PLAN

English 6 WORKING CONDITIONS 1. Refrain from operating the blower if you are tired, ill, or upset, or if you are under the influence of alcohol, drugs or medication 2. To reduce the risk of hearing loss associated with sound levels, hearing protection is required. 3. To reduce the risk of injury ass...

Page 7 - If cracked, be sure to replace without delay.; USING THE PRODUCT

English 7 BEFORE STARTING THE ENGINE Each time before starting the engine, inspect the entire unit to see if every part is in good order and is securely tightened in place. If any damage is found in the fuel line, the exhaust line, or the ignition wiring, do not use the blower until it has been repa...

Page 8 - MAINTENANCE; TRANSPORTATION

English 8 MAINTENANCE 1. In order to maintain your product in proper working order, perform the maintenance and checking operations described in the manual at regular intervals. 2. Always be sure to turn off the engine and disconnect the spark plug before performing any maintenance or checking proce...

Page 10 - MODEL; Technical data

English 10 - The data shown above are those in the case of one straight pipe. - Specifications are subject to change without notice. MODEL 150BT Dimensions (L x W x H) mm (in) 351x446x479 (13.8x17.6x18) Dry Weight kg (lbs) (including pipe) 10.2 (22.5) Dry Weight kg (lbs) (without accessories) 9.5 (2...

Page 11 - THROTTLE LEVER; THROTTLE CABLE; BLOWER TUBES; A light lubricant may be used to ease assembly of blower tube.; HARNESS; Assembly

English 11 SWIVEL JOINT 1. Connect the blower and swivel joint with flexible hose. Clamp both ends of the flexible hose securely with the hardware supplied with the unit. NOTE A light lubricant may be used to ease assembly of flexible hose to blower elbow. THROTTLE LEVER 1. Set up the clamp to the s...

Page 13 - RECOMMENDED MIXING RATIO; HOW TO MIX FUEL; Pay attention to agitation.; FUELING THE UNIT; fueling point before starting the engine.; Fuel

English 13 FUEL WARNING - Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 10ft (3m) away from the fueling point before starting the ...

Page 14 - Do not let a person stand near the blower or the exhaust port.; When the engine fails to start after several attempts due to; Air comes out as soon as the engine is started, even at idle speed.; Operation

English 14 STARTING ENGINE IMPORTANT - Avoid operating the blower with the flexible tube and swivel joint disconnected. That will reduce the cooling air and the engine could be damaged by overheating. 1. Push the primer bulb until fuel flows out in the clear tube.2. When the engine is cool, close th...

Page 16 - AIR CLEANER; FUEL FILTER; Maintenance

English 16 Maintenance, replacement, or repair of the emission control device and systems may be performed by any non-road engine repair establishment or individual. WARNING Make sure that the engine has stopped and is cool before performing any service to the blower. Contact with rotating blower fa...

Page 17 - MUFFLER; SPARK ARRESTER; Fastening Torque: 8 to 12 N·m; AIR INLET NET

English 17 SPARK PLUG - The spark plug may gather carbon deposits on its firing end with reasonable use. Remove and inspect the spark plug every 25 hours and clean the electrodes as necessary with a wire brush. The spark gap should be adjusted to .025 in (0.6 to 0.7mm). - Plug manufacturers recommen...

Page 18 - BEFORE STORING THE BLOWER:; Storage

English 18 IGNITION COIL AIR GAP INSPECTION - If the gap is not accurate or when installing the coil or rotor, adjust the air gap between the ignition coil and the iron core of the rotor. Air Gap: 0.40 mm (0.35 to 0.45 mm) / 0.016 in (0.014 to 0.017 in) (1) Rotor(2) Ignition coil SHOLDER STRAP - If ...

Husqvarna 115 24 05-95 - Manual

Table of Contents:

Summary

Other Husqvarna Models