Heath Zenith SL-4100 - Manual
Heath Zenith SL-4100 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INSTALLATION; CAUTION: When handling the sensor be; Mode Switching Summary; Flip light; Dimmer Control
- Page 3 – SPECIFICATIONS; MANUAL OVERRIDE; TESTING; Maximum Range; Avoid aiming the control at:; • Areas where; pets or traffic may trigger; Sensor has a 1; Least Sensitive; Sensor
- Page 4 – TROUBLESHOOTING GUIDE; WARNING: Turn power off at circuit
- Page 5 – TEN YEAR LIMITED WARRANTY; TECHNICAL SERvICE; No Service Parts Available for this Product
- Page 6 – Características; PRUEBA; Requisitos; MODO MANUAL; Prueba; Hasta el; Adorno; el amanecer; FUNCIONAMIENTO; segundo
- Page 7 – Luz de Adorno; Mueva el interruptor de; Resumen de las modalidades del; ADvERTENCIA: Desconecte la; INSTALACION; CUIDADO: Cuando trabaje con el detector,
- Page 8 – ESPECIFICACIONES; Evite apuntar el control hacia:; Lo menos sensible
- Page 9 – GUIA DE INvESTIGACION DE AvERIAS
- Page 10 – GARANTÍA LIMITADA A 10 AÑOS; SERvICIO TÉCNICO; antes de devolver el producto a la tienda.
- Page 11 – Caractéristiques; ESSAI; Exigences; Essai; FONCTIONNEMENT; Après mise en circuit, attendre enfiron; puis; PRIORITÉ MANUELLE
- Page 12 – AvERTISSEMENT : Manipulez le détecteur; Placer l’interrupteur ON-; Résumé du mode de commutation; tation au disjoncteur ou au fusible.
- Page 13 – FICHE TECHNIQUE; priorité manuelle; ESSAIS; Éviter de pointer l’appareil:; des flaques d’eau ou des objets dont; • Vers; des zones où des animaux ou la; • Sur; des objets avoisinants de grande; Le capteur doit se réchauffer 1
- Page 14 – FIxATION DES
- Page 15 – GUIDE DE DÉPANNAGE
- Page 16 – GARANTIE LIMITÉE DE 10 ANS; SERvICE TECHNIQUE; l’aide avant de retourner l’article au magasin.
Model SL-4100
Features
• Light comes on when motion is detected.
• Automatically controls existing post light.
• D
ual
B
rite
®
Timer.
• Photocell keeps the light off during daylight
hours.
This package includes:
© 2007 HeathCo LLC
595-5657-04
TEST
Requirements
• The light control requires 120 volts AC.
• If you want to use Manual Override, the
control must be wired through a switch.
•
Some codes require installation by a
qualified electrician.
Motion Sensing Post
Light Adapter
3 Wire Connectors
3 Screws
Post Light
Adapter
ON-TIME
MINUTES
ACCENT
Put ON-TIME switch on the sensor bottom
to TEST and the D
ual
B
rite
®
(ACCENT)
switch OFF.
MANUAL MODE
... back on.
1 Second
OFF
then...
OPERATION
AUTO
Set ON-TIME switch to
1, 5, or 20 minutes.
Manual mode only works at
night because daylight re-
turns the sensor to AUTO.
Flip the light switch off for
one second then back on to
toggle between AUTO and
MANUAL MODE.
Manual mode works only
with the ON-TIME switch in
the 1, 5, or 20 position.
* resets to Auto Mode at dawn.
Note:
When first turned on wait about 1
1
/
2
minutes for the circuitry to calibrate.
Mode:
On-Time
Works: Day Night
Test
5 Seconds
x
x
Auto
1, 5, or 20 Min
x
Manual
To Dawn*
x
Accent
3, 6 Hr, to Dawn
x
DUSK TO DAWN
6 HOUR
3 HOUR
OFF
20
5
1
TEST
20
5
1
TEST
Before installation, record the model number
from back of fixture below. Attach receipt in
case of possible warranty issues.
Meets the ENERGY STAR
®
guidelines when D
ual
B
rite
®
function is off and ON-TIME
is 1 or 5 minutes.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 595-5657-04 INSTALLATION 4. Twist the wires from the post and the bottom sensor wires together as shown. Secure with wire connectors provided. 5. Make sure the wires and connectors are all inside the post, then set the sensor onto the post. 6. Start and temporarily tighten the three screws previou...
3 595-5657-04 SPECIFICATIONS Range ..................... Up to 30 ft. (9.1 m) [varies with surround-ing temperature] Sensing Angle ........ Up to 150°Sensor Capacity ..... Up to 360 Watts (3.0 A.) Maximum Tungsten Incandescent PowerRequirements ......... 120 VAC, 60 HzOperating Modes .... TEST, AUTO...
4 595-5657-04 1. Walk through the coverage area noting where you are when the lights turn on. Loosen the 3 clamp screws slightly and turn the sensor head left or right to change the coverage area. 2. When you have the desired coverage angle make a pencil mark on the sensor and post to mark the senso...
