Heath Zenith 7101 - Manual

Heath Zenith 7101

Heath Zenith 7101 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
Page: / 12

Table of Contents:

  • Page 2 – teSt anD aDJuStMent; Least Sensitive; Maximum Range; adjustment of coverage area; OPeratiOn; test; thingS tO reMeMber
  • Page 3 – keep sensor switch in the “OFF”
  • Page 4 – FiVe Year LiMiteD WarrantY; technicaL SerVice; If the; no Service Parts available for this Product; trOubLeShOOting guiDe; SYMPtOM
  • Page 5 – DeSeMPaque; Monte la base del panel solar sobre una superficie só-; Monte la caja de la batería sobre una superficie sólida; caracteríSticaS; • No prenda la luz antes que la batería esté comple-
  • Page 6 – Prueba Y aJuSte; regulación del Área de cobertura
  • Page 7 – FunciOnaMientO; Prueba; caMbiO De La batería; antes de la prueba mantenga el in-; PuntOS que Se Deben
  • Page 8 – guía De anÁLiSiS De aVeríaS; SíntOMa; SerViciO tÉcnicO; producto a la tienda.; garantía LiMitaDa a 5 aÑOS
  • Page 9 – À suivre; DÉbaLLage; caractÉriStiqueS
  • Page 10 – eSSai et rÉgLage; réglage de la Zone de couverture; Le moins sensible
  • Page 12 – garantie LiMitÉe De 5 anS; SerVice technique; l’article au magasin.; guiDe De DÉPannage; SYMPtÔMe
Loading the manual

Solar Powered
Motion Sensor Light

Model 7101

FeatureS

• Turns on light when motion is detected.
• Automatically turns light off.
• Photocell keeps the light off during daylight hours.
• Battery Protection Circuitry. Unit will shut down when

battery is low. Unit will automatically resume operation
when battery is recharged to a safe level.

requireMentS

• Do not turn the light on before the battery is fully charged.

Charge the battery by keeping the switch in the OFF
position. Plug the solar panel cable into the bottom of
the battery case. Point the solar panel directly at the
noon sun for 3 sunny days. If not fully charged, the unit
will not work.

• When FULLY charged, the solar light will operate a

maximum of 15 days without sunlight. Actual operating
time will vary depending upon how frequently the light
is triggered.

Light

Battery Case

Sensor

3. Mounting Screws (2 sizes)

1. Solar Light Fixture

2. Solar Panel

Tapered Screw (3)

Round Head Screw (2)

unPacking

Be sure to remove all contents from packaging and verify
all items are present before assembling this light fixture.
This package includes the following items:

inStaLLatiOn

For best performance, mount the fixture about 8 feet (2.4
m) above the ground.

1. Mount solar panel base on a solid surface using three

tapered screws. Adjust the panel to point directly at
the noon sun. Avoid obstructions such as trees or
buildings that may block sun light. Allow for enough
wire to reach the case.

Note: You will want to re-aim the solar panel as the
seasons change to keep it pointed directly at the noon
sun.

Three Mounting Holes for Solar Panel Base

2. Mount the battery case on a solid surface using two

round-head screws and the keyholes on the back of
the case.

3. Adjust sensor. For proper operation, the sensor head

must be rotated so that the sensor controls face down-
ward as shown below.

5

3

/

4

"

Mounting Holes (3)

Mounting
Holes (2)

4. Plug the solar panel cable into the bottom of the battery

case.

IMPORTANT:

allow the battery to charge

with three days of sunshine before testing.

Controls

Light

Battery Case

Sensor Joint
Clamp

IMPORTANT:

the controls must face downward to

avoid damage from rain.

If controls face upward, move

sensor to the original down position, rotate 180°, then
raise to the position shown below.

Light Joint Clamps

Lens Removal
Tab

Sensor

© 2008 HeathCo LLC

598-1344-00

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - teSt anD aDJuStMent; Least Sensitive; Maximum Range; adjustment of coverage area; OPeratiOn; test; thingS tO reMeMber

2 598-1344-00 teSt anD aDJuStMent NOTE: Sensor has a 30 second warm up period before it will detect motion. When switching modes wait 30 seconds. 1. Slide the sensor switch to the TEST position.2. Place the RANGE adjustment in the medium position (halfway between MIN and MAX position). Least Sensiti...

Page 3 - keep sensor switch in the “OFF”

3 598-1344-00 SPeciFicatiOnS Range ........................... Up to 70 ft. (21 m); [varies with surrounding temperature] Sensing Angle .............. Up to 180°LED (x3) ....................... 7.8 wattsBattery Type .................. Sealed lead acid, 6 V 6.0 A-Hr.On Time ........................ T...

Page 4 - FiVe Year LiMiteD WarrantY; technicaL SerVice; If the; no Service Parts available for this Product; trOubLeShOOting guiDe; SYMPtOM

4 598-1344-00 FiVe Year LiMiteD WarrantY This is a “Limited Warranty” which gives you specific legal rights. You may also have other rights which vary from state to state or province to province.For a period of five years from the date of purchase, any malfunction caused by factory defective parts o...

Other Heath Zenith Models

All Heath Zenith Other