Heath Zenith 6180 - Manual
Heath Zenith 6180 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Chime with sawtooth hanger attached to back:
- Page 3 – Chime with separate cover and base:; Code and Tune Settings; Code Settings; jumper positions 1 through 7 are used for setting the code.
- Page 5 – Troubleshooting; Chime does not sound:; • Do not mount chime or push button on metal or near metal studs. This; Regulatory Information; If the problem persists, call* for assistance at; No Service Parts Available for this Product
- Page 6 – LIMITED WARRANTY; Batteries are not covered.
- Page 7 – Usted deberá comprar 3 pilas alcalinas “D” para el timbre.; Campanilla Decorativa Inalámbrica; Análisis de Averías; Figura 1
- Page 8 – Colgador dentado; Instale el pulsador y el timbre.
- Page 9 – Campana con tapa y base separadas; apuntando hacia arriba.; Programaciones del código y del tono; Programaciones del código
- Page 11 – No hay piezas de servicio disponibles para este producto
- Page 12 – GARANTÍA LIMITADA; Las pilas no están cubiertos banjo de esta garantia
- Page 13 – Carillon décoratif sans fil; Installation de la pile alcaline; « Dépannage »; Vous aurez besoin de trois piles alcalines « D » (R20) pour le carillon.; Figure 1
- Page 14 – Carillon doté du support dentelé :
- Page 15 – Carillon avec socle et couvercle distinct; carillon sur le socle.; Réglages du code et de la mélodie; Réglage du code
- Page 17 – Le carillon ne sonne pas:; carillon des planchers.; Service Technique; Aucune pièce de rechange n’est disponible pour ce produit
- Page 18 – GARANTIE LIMITÉE; Les piles ne sont pas incluses.; Exclusions de la garantie -
- Page 22 – No de modelo / N° de modèle
-
+
-
+
-
+
Battery
Battery
Battery
© 2005 DESA Specialty Products™
595-5506-10
This package includes (Style of push button and chime may vary from illustra-
tions):
• Wireless chime
• Wireless push button w/battery
• Hardware pack
You'll need to buy 3 "D" alkaline batteries for the chime.
In typical use,
alkaline batteries will last up to three years.
6180 Series, 6270 Series, and 6280 Series
Decorative Wireless Chime
Cover
Mounting
Tabs
1.
Install alkaline type A23 12
volt push button battery.
Re-
move back of case by pushing
in tab on bottom with a small
screwdr iver (see Figure 1).
Make sure battery is oriented
properly (See page 4).
2.
Install 3 alkaline “D” batteries.
Make sure batteries are oriented
properly (see Figure 2).
3. Test range.
Temporarily posi-
tion chime and push button
where you want them mounted.
Press push button to ver ify
chime and push button work
proper ly. If chime does not
sound, see
Troubleshooting
.
Chime
Volume
Jumpers
Figure 2
Figure 1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
-2- 595-5506-10 12345 678 4. Mount push button. Use either screws or double sided tape to mount push button. To mount with screws, remove back of case by pushing in tab on bottom with a small screw-driver.Attach back of case to door jamb or wall. Snap front of push button on.When attaching push butt...
-3- 595-5506-10 Chime with separate cover and base: The chime base can be mounted in two different ways. The base can be mounted using the keyholes or the three mounting holes. The base may be mounted hori-zontally or vertically depending upon the specific model purchased.1. Remove batteries from chi...
-5- 595-5506-10 Troubleshooting Chime does not sound: • Make sure push button and chime codes are the same (See pages 3 and 4).• Check orientation of push button battery (See page 4).• Check charge of push button and chime batteries, replace if necessary. Batteries seem OK, but the chime does not wo...