Heath Zenith 6168 - Manual
Heath Zenith 6168 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Installation; Important considerations:; Troubleshooting; WARNING: To prevent possible SERIOUS INJURY or DEATH:
- Page 4 – Tune Settings; Ding
- Page 5 – • Red light on the sensor does light. Make sure sensor and chime codes; C. Battery seems OK, but the chime does not work when installed:; positions 1 through 7 are used for setting the code.
- Page 6 – Jumpers in positions 1 through 7 must be exactly the same for both
- Page 7 – before returning product to store.; If the problem persists, call* for assistance; No Service Parts Available for this Product; FIVE YEAR LIMITED WARRANTY
- Page 9 – Instalación; Consideraciones importantes:; Guía de Análisis; ADVERTENCIA: Para evitar una posible LESIÓN SERIA o la MUERTE:
- Page 11 – Programación del tono; Tilín
- Page 12 – Análisis de Averías; Configuración de Códigos; C. La pilas parecen estar buenas pero la campana no funciona una vez
- Page 13 – Los puentes en las posiciones del 1 al 7 deben ser exactamente los
- Page 14 – pedir ayuda antes de devolver el producto a la tienda.; Si el problema continúa, llame al; No hay piezas de servicio disponibles para este producto.
- Page 15 – GARANTÍA LIMITADA A 5 AÑOS; Servicio de reparación, ajuste y calibración debido al mal
- Page 16 – Branchez le carillon sans fil dans
- Page 17 – Considérations importantes :; pannage; MISE EN GARDE : Pour éviter les risques de BLESSURES GRAVES,
- Page 18 – Au moyen de ruban adhésif.; Appliquez le
- Page 19 – Réglage de la mélodie
- Page 20 – Dépannage; Réglage
- Page 22 – obtenir de l’aide avant de retourner l’article au magasin.
- Page 23 – GARANTIE LIMITÉE DE 5 ANS; Exclusions de la garantie -; Réparations, réglage et calibrage dus à une
- Page 24 – No de modelo / N° de modèle
© 2007 HeathCo LLC
595-5724-04
Wireless Door
Sensor Chime
Model 6168
1. Plug wireless chime into wall
outlet.
Note:
The volume control is on the back
of the wireless chime. Unplug chime to
adjust volume.
To reduce the risk of electrical shock,
this equipment has a polarized plug
(one blade is wider than the other). This
plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to
install the proper outlet. Do not attempt
to bypass this safety feature.
Chime
Volume
Control
Wireless Plug-in
Chime
Sensor
Magnet
Magnet
Spacer
This package includes:
• Wireless plug-in chime
• Door sensor with battery
• Door magnet
• Magnet spacer
• Hardware pack
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
-2- 595-5724-04 Installation Important considerations: The sensor must be mounted to the door jamb. The magnet should be attached to the door. Sensor is for indoor use only. 2. Install alkaline type A23 12 volt push button battery (included). Remove back of case by pushing in tab on bottom with a sm...
-4- 595-5724-04 12345678 1 2 3 4 5 6 7 8 Inside Sensor Remove screw to open access door Back of Chime Tune Setting Tune Setting (Not used on all models) Note: Some models might require the use of tweezers to remove and replace the jumpers. Tune Settings Your Heath ® /Zenith wireless chime has differ...
-5- 595-5724-04 Troubleshooting A. Chime does not sound: • Red light on the sensor does not light. Check battery polarity. Replace the sensor battery. • Red light on the sensor does light. Make sure sensor and chime codes are the same (see Code Setting below). Make sure the plug-in chime has power g...
