SIIG 5090S - Manuals - manualsarea.com

Page 2 - System Requirements; Desktop or notebook PC with an available; Package Contents; Installation kit; Layout

2 System Requirements • Desktop or notebook PC with an available USB 2.0/3.0 port • Windows ® 7 (32-/64-bit) ) / Vista (32-/64- bit) / XP (32-/64-bit) / Server 2003 & 2008 (32-/64-bit) / 2000 SP4 Package Contents • 2.5" USB 2.0 to SATA Enclosure • USB Y-split (data & power) cable • Insta...

Page 3 - Hardware Installation; The following section guides you through the; Figure; . Slide the top cover out of the case, then; Figure 4

3 Figure 2: USB cable Hardware Installation The following section guides you through the installation of your drive kit. Installing a 2.5" Hard Drive 1 . Remove the 2 screws in each side, see Figure 3 . Slide the top cover out of the case, then slide the lower cover out of the case, see Figure 4...

Page 4 - Take off the PCB and connect it to the hard; and; Figure 6

4 2 . Take off the PCB and connect it to the hard disk drive, see Figure 5 and Figure 6 . Figure 5 Figure 6

Page 5 - Hold onto the hard disk drive and turn the; Figure 8

5 3 . Put the installed PCB with hard disk drive into the hard disk drive tray, see Figure 7 . Figure 7 4. Hold onto the hard disk drive and turn the hard disk drive tray over. Secure the hard disk drive with four mounting screws, see Figure 8 . Figure 8 Screwholes Screwholes

Page 6 - Driver Installation

6 5 . Slide the lower cover back into the case and secure it with the two mounting screws, then slide the upper cover back into the case and secure it with the two mounting screws. 6 . Use the included USB 2.0 data cable to plug the 2.5" USB 2.0 to SATA Enclosure into the computer. 7 . Plug the ...

Page 7 - Using the; Disconnecting From The Computer; Enclosure

7 Using the 2.5" USB 2.0 to SATA Enclosure An additional drive icon will appear in My Computer or Computer when the enclosure is plugged into a USB port. The drive acts just like a conventional hard drive in your system. Disconnecting From The Computer Before unplugging the 2.5" USB 2.0 to S...

Page 9 - USB 2.0 to SATA Enclosure

9 Windows 2000 SP4 1 . Verify that the HDD LED is ON or not blinking. 2 . Double click the Unplug or Eject Hardware icon located in the system tray by the system clock. 3 . Highlight USB Mass Storage Device , click Stop , OK , OK , then click Close . 4 . You can now unplug or turn off the 2.5" U...

Page 10 - Blank Page

Page 11 - Technical Support and Warranty

1 1 Technical Support and Warranty QUESTIONS? SIIG ’ s Online Support has answers! Simply visit our web site at www.siig.com and click Support . Our online support database is updated daily with new drivers and solutions. Answers to your questions could be just a few clicks away. You can also submit...