SIIG SATA II-150 - Manual
SIIG SATA II-150 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Hardware Installation
- Page 3 – Hard Disk Drive Connection; SATA II-150 PCI RAID; RAID Arrays; RAID
- Page 6 – Deleting RAID Arrays
- Page 7 – Low Level Format; BIOS Configuration; Driver Installation; contents
- Page 10 – Windows VistaTM
- Page 12 – To Verify Windows Installation
- Page 13 – Initio SATA RAID Manager GUI; Windows Vista /Server 2008 Installation
- Page 14 – Blank Page
- Page 15 – Technical Support and Warranty; O n l i n e S u p p o r t
1
SATA II-150 PCI RAID
Quick Installation Guide
Introducing the
SATA II-150 PCI RAID
The
SATA II-150 PCI RAID
is an ultra high-speed two
channel Serial ATA Generation II RAID controller for use
in PCI enabled systems.
Features and Benefits
•
Compliant with PCI 2.3
•
Compliant with Serial ATA 1.0 specifications and
complement of SATA II optional features
•
Supports RAID 0 (stripe) for performance and RAID
1 (mirror) for data protection
•
Supports two SATA channels and data transfer rate
up to 1.5Gb/s (150MB/s)
•
Supports Native Command Queuing (NCQ) and
SATA TCQ commands
•
Onboard bus master engine relieves the system
processor and enhances system performance
•
Features independent 256-byte FIFOs per channel
for host reads and writes
•
Breaks the 137GB barrier! Works with various
brands of large capacity Serial ATA hard disks
•
Supports SATA hard disk hot-plugging
System Requirements
•
Pentium
®
or equivalent PC with an available PCI
slot
•
Windows
®
2000 / XP (32-/64-bit) / Server 2003 &
2008 (32-/64-bit) / Vista (32-/64-bit)
0 4 - 0 4 1 2 C
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Package Contents • SATA II-150 PCI RAID board • 2 SATA data cables and one dual-connector SATA power cable • Spare low profile bracket • Driver CD and Quick Installation Guide Layout Figure 1. SATA II-150 PCI RAID Hardware Installation General instructions for installing the card are provided belo...
3 1. Turn OFF the power to your computer and any other connected peripheral devices. 2. Unplug the power cord from the back of the computer, remove the cover. 3. Remove the slot bracket from an available PCI slot. 4. To install the card, carefully align the card's bus connector with the selected PCI...
6 6. When asked, All data in selected drive will lost! Continue (Yes/No)? , select Yes , then press Enter . 7. Select RAID , then select Rebuild . 8. Press Enter . The mirror will begin rebuilding. Do not interfere with the process. 9. When rebuilding is finished, select Exit , then press Enter 10. ...
