SIIG 04-0528C - Manual
SIIG 04-0528C – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INSTALLATION AND OPERATING INSTRUCTIONS; Caution
- Page 3 – a) Wood Stud Installation; Step1: Wall Plate Installation
- Page 4 – The concrete anchors must be used for concrete installation.; Step 2 Display Bracket Installation; Check the mounting screws every two months for tightness.; Step 3 Final Installation & Adjustment
- Page 5 – Blank Page
- Page 7 – Technical Support and Warranty
- Page 8 – PRODUCT NAME
04-0528C
Low Profile Universal TV Mount - 32" to 60"
IMPORTANT: If you don't understand the installation instructions, please consult an installation
specialist
Fixed LCD / TFT TV Wall Mount
Material: 2.0mm Cold Rolled Steel Plate
TV Size: 32" - 60"
Max load capacity:165 lbs / 75 kgs
Installation Instructions
Wall distance: 30mm / 1.2"
Bubble level system included
Universal Mounting Pattern
1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
A G B H C I D J E K F L M (×4) M8 Spacer (×4) M8×35 screw (×4) M4×12 screw When mounting to a wall that contains wood studs, confirm dead center of the wood stud prior to installation, it isrecommended that the wood studs be a minimum of 16" apart. (×6) M8 concrete anchor (×4) M4×35 screw (×6) M...
1234 a) Wood Stud Installation 3 4 5 6 7 8 CAUTION: Do not over-tighten bolts-doing so many cause unnecessary damage to the wall. Avoid excessive torque. Mark the right (upper and lower) and the left (upper and lower) positionsof the small horizontal slots that are in alignment with the studs (figur...
NOTE: 1 2 3 4 5 6 7 8 5 6 1 2 If your display has a curved back or a recessed thread mounting point, a spacer (M) must be used. Then choose screw(F/G/H) to match.Place the spacer (M) between the mounting bracket and display. Next, drill holes using an electric drill and 5/16" masonry bit to a de...
