Husqvarna ZTH5223A - Manuals

Page 2 - Congratulations; on the purchase of your; Husqvarna; mower. This manual has been prepared; TECHNICAL ASSISTANCE

2 Continuous dedication to improve our products require that specifications and design aresubject to change without notice. Congratulations on the purchase of your Husqvarna mower. This manual has been prepared for the owners and operators of the Zero Turn Large Frame 52" and 61" commercial ...

Page 4 - mow excessively steep slopes

4 SAFETY TRAINING: 1. Read this manual carefully and question your dealer if something is not clear.2. Be thoroughly familiar with the controls and proper use of the equipment.3. Never allow children, teenagers, or people unfamiliar with these instructions to use themower.4. Do not mow while people,...

Page 5 - Use only authentic; replacement parts to insure the safety and quality of your; cornering, turning & slopes can be unsafe if caution isn’t used.

5 SAFETY TRANSPORTATION: Use a heavy duty trailer to haul mower. Set park brake, turn off fuel valve and strap mower totrailer. NOTE: Park brake will not hold mower in place when transporting. Be sure to tie downthe mower to the trailer. Always back onto the trailer to prevent possible tipover. 1. K...

Page 6 - EQUIPMENT SETUP AND ADJUSTMENTS; Figure 1

6 EQUIPMENT SETUP AND ADJUSTMENTS 1. Uncrate mower2. Mount drive wheels using the four lug nuts installed on the hub.3. Check tire pressure in all four tires. Pressure for all four tires is 15 psi4. Remove the motion control levers and install on the outside of the control arms (See figure1). Tabs o...

Page 8 - Figure 3; THROTTLE LEVER TENSION:

8 ADJUSTMENTS MULE DRIVE BELT TENSION: 1. Stop engine and remove the key.2. Check to make sure the bolt head in the spring loaded idler pulley, on the left side of theengine deck is positioned between the two alignment holes in the left support plate(See Fig 4).3. If adjustment is necessary, loosen ...

Page 9 - ADJUSTMENTS

9 Figure 5A Figure 5B 5. If adjustment is necessary, loosen the nut against the yoke. Apply slight rearward pres-sure to the motion control lever and turn the head of the adjustment bolt in the proper direc-tion until the lever is centered in the neutral slot. NOTE: if properly adjusted the motionco...

Page 12 - Figure 6; WARNING; Mow only in daylight or good artificial

12 OPERATING INSTRUCTIONS STARTING AND OPERATION:1. Operator must be sitting in the seat. Engage park brake, blades off and place the motioncontrol levers in the neutral slots. (See figure 6)2. Adjust throttle to 1/2 and set choke (if needed) turn key and release as soon as enginestarts.3. Release p...

Page 13 - Remove oil drain cap; Quaker State Super Blend 10w-30

13 MAINTENANCE 1. Engine oil level: Check daily with engine cold and on a flat surface. Remove the dipstick and wipeclean. Reinsert the dipstick all the way. Remove the dipstick and check oil level. If oil level is lowremove oil fill cap and add oil. Use engine manufacturers specifications for type ...

Page 14 - MAINTENANCE; (Clean grease zerk thoroughly before greasing)

14 MAINTENANCE 9. Tire pressure: Check every 25 to 50 hours. All four tires require 15 psi. 10. Battery: Check every 25 hours. Check electrolyte level. If needed fill to the full line marked onthe side of the battery. Fill with distilled water. Do not try starting the engine with a weak battery.Rech...

Page 16 - WIRING DIAGRAM

Page 17 - SERVICE RECORD; DESCRIPTION OF WORK DONE

17 SERVICE RECORD DESCRIPTION OF WORK DONE DATE SERVICE DONE BY