Husqvarna WS 440 HF - Manuals

English – 5 SAFETY INSTRUCTIONS Steps before using a new wall saw • Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. • This machine is only intended for use together with a Husqvarna PP 440 HF. All other use is forbidden. • Read thro...

6 – English SAFETY INSTRUCTIONS General safety precautions Do not use the machine without first reading and understanding the contents of this Operator’s Manual. • Never use the machine if you are tired, if you have drunk alcohol, or if you are taking medication that could affect your vision, your j...

English – 7 SAFETY INSTRUCTIONS • Always check and mark out where gas pipes are routed. Cutting close to gas pipes always entails danger. Make sure that sparks are not caused when cutting in view of the risk of explosion. Remain concentrated and focused on the task. Carelessness can result in seriou...

8 – English PRESENTATION WS 440 HF It is our wish that you will be satisfied with your product and that it will be your companion for a long time. Think of this operator ′ s manual as a valuable document. By following its ′ content (using, service, maintenance etc) the life span and the second-hand ...

English – 9 ASSEMBLY Mount wall mountings and rail Fit the wall mounting as set out below: 1 Mark off the cutting line and mark off the expander bolts holes 165 mm (6.5") from the cutting line. 2 Drill 15 mm (5/8”) holes for the M12 (1/2”) expander bolts. 3 Hang the wall mountings loosely from t...

10 – English ASSEMBLY Fit the blade 1 Start by removing any dirt from the contact surfaces on the blade flange and blade. 2 Check the blade’s direction of rotation. The blade shall rotate with the exposed part of the diamond in the rotational direction of the blade. Since the blade rotation directio...

English – 11 ASSEMBLY Fit the blade guard 1 Slip in the blade guard guide between the stays on the blade guard. Place the blade guard guide in the middle. Lock the plastic heel on the handle to the upper stay on the blade guard. 2 Make sure that the pivot arm is positioned vertically. Lift the blade...

12 – English STARTING AND STOPPING Before starting • Enclose the area to be cut so that unauthorised persons can not be injured or disturb the operator. • Check that the blade and th blade guard is not damaged or cracked. Replace the blade or the blade guard if it is exposed to impact or is cracked....

English – 13 SETTINGS AND ADJUSTMENTS Adjusting the guide wheels In order for the saw to run stably and saw a straight cut, the four guide wheels must rest against the rail and not have too much play. When there is too much play between the saw carriage and rail the guide wheels must be adjusted: Th...

14 – English MAINTENANCE Service After 100 hours of operation, the message "Time for servicing" is displayed. The entire equipment shall then be taken to an authorized Husqvarna dealer for servicing. Maintenance Oil change cutting arm There is an oil plug for draining the oil located on the ...

English – 15 TECHNICAL DATA WS 440 HF Max. peripheral speed, m/s *Recommended blade size. Never use blades other than original blades designed for the machine. Dimensions Weight Saw carriage, kg/lbs 3,7/8,2 Saw unit, kg/lbs 25/55,1 Blade guard 800 mm, kg/lbs 13/28,7 Blade guard 1000 mm, kg/lbs 16/35...

16 – English TECHNICAL DATA EC-declaration of conformity Husqvarna Construction Products , SE-433 81 Göteborg, Sweden, tel: +46-31-949000, declares under sole responsibility that the wall saw Husqvarna WS 440 HF , from 2008´s serial numbers and onwards (the year is clearly stated in plain text on th...