Husqvarna WG4815P - Manuals

Page 2 - TABLE OF CONTENTS

2 TABLE OF CONTENTS SAFETY : Training Preparation Operation Maintenance EQUIPTMENT SETUP AND ADJUSTMENTS : Front casters Axle adjustment Cutting height chart Brake adjustment Operator presence switches Belt adjustments OPERATING INSTRUCTIONS : Emergency stopping Normal stopping Pre-start Operating i...

Page 4 - Safety

4 OPERATION 1. Do not change engine governor settings or overspeed the engine.2. Keep hands, feet, and clothing away from rotatingparts when operating mower.3. Disengage blade drive when crossing gravel drives,walks, roads or under any condition where thrownobjects might be a hazard.4. After strikin...

Page 7 - CUTTING HEIGHT ADJUSTMENT CHART

7 Setup & Adjustments CUTTING HEIGHT ADJUSTMENT CHART AXLE POSITION NUMBER OF SPACERS BELOW CASTER ARM NUMBER OF 1/4" BLADE SPACERS UNDER CUTTER HOUSING CUTTING HEIGHT (IN INCHES) 1 1/21 3/4 22 1/42 1/21 3/4 22 1/42 1/22 3/42 1/22 3/4 33 1/43 1/2 33 1/43 1/23 3/4 43 1/43 1/23 3/4 44 1/43 1/2...

Page 8 - Figure 3

8 BRAKE / TRACTION ADJUSMENT 1. Disconnect the brake linkage from the brake bandarm. 2. With the mower in gear, place the traction levers inthe drive position. Firmly pull back on the handlesuntil the tires slide to seat the wheel drive belts intothe pulleys. 3. Measure the clearance between the bot...

Page 9 - Figure 4

9 Setup & Adjustments BLADE ENGAGEMENT LEVER The blade engagement lever needs to be adjusted sothe lever does not come in contact with control panelwhen the lever is in the off position. To adjust, remove the clevis pin from the yoke andadjust by turning the yoke. The clevis pin connectsthe blad...

Page 10 - Operating Instructions; Figure 7

10 Operating Instructions BEFORE OPERATING Be thoroughly familiar with all controls and how to usethem before operating the mower. Know beforehandhow to stop the engine, drive wheels, and mowerblades in preparation for possible emergency. EMERGENCY STOP Pull both traction levers firmly against handl...

Page 12 - Service

12 SERVICE ASSISTANCE -REPLACEMENT PARTS To retain the quality of your mower, use genuineHUSQVARNA replacement parts only. Contact yourlocal HUSQVARNA dealer for parts and serviceassistance. For the correct part or information for yourparticular mower, always mention model and serialnumber. We recom...

Page 13 - Figure 8

13 CUTTER HOUSING SPINDLE ASSEMBLIES The cutter housing assembly is designed with a slipfit inner race and pulley. The sole purpose of thesetscrew in the pulley is to hold the housing assem-bly together. The setscrew is not meant to secure thepulley. The pulley is secured by pinching the pulleyto th...

Page 15 - Maintenance

15 ITEM REAR TIRES FRONT TIRES UNDERSIDE OF MOWING DECK MOWER DECK UNDERSIDE OF REAR DECK BLADE PULLEYS ENGINE PULLEY FRONT WHEEL BEARINGS CASTER SHAFTS ENGINE OIL LEVEL REAR WHEELS BRAKE ARMS BLADE ENGAGEMENTBELLCRANK BLADE ENGAGEMENTFRICTION WASHER TRANSMISSION SHAFTS BLADES ENGINE AIR FILTER LINK...