Husqvarna MC18 - Manuals

11 SAFETY FIRST! WARNINGS DO’s and DO NOT’s WARNING: FAILURE TO COMPLY WITH THESE WARNINGS AND OPERATING INSTRUCTIONS COULD RESULT IN DEATH OR SERIOUS BODILY INJURY. DO NOT DO NOT operate this machine unless you have read and understood this operator’s manual. DO NOT operate this machine without the...

12 FIGURE 2 2A. BLADE SHAFT NUT: Use to tighten the outer flange against the diamond blade. 2B. OUTER FLANGE: Use to hold the diamond blade in position. 2C. NOT USED 2D. LOCKING PIN: Use to prevent the diamond blade from rotating on the shaft during operation. 2E. DIAMOND BLADE: Use as the cutting t...

13 PRE OPERATION CHECKLIST Before leaving our factory, every machine is thoroughly tested. Follow our instructions strictly and your machine will give you long service in normal operating conditions. Before starting up the machine, make sure you read this entire operations manual and are familiar wi...

14 • T h e H a n d l e m u s t b e a t t a c h e d . P l a c e H a n d l e in position and securely tighten Knobs. • Check the engine oil level. Service before using. Refer to the engine operation manual for detailed information. These signs will give advice for your safety Before leaving our factor...

15 Always pay extreme care and attention to the preparation of the machine before starting. Remove all wrenches and tools from the floor and the machine. Always keep blade guard and transmission guard in place. (See Fig. 1 and 2) Always set the Engine Switch (1D) to the "OFF" position before...

17 SPECIAL OUTER FLANGE ASSY 1/2" (12.7mm)WIDE CUT (P/N 167963) • A Special Outer Flange Assembly is available as a fieldinstalled accessory. It enables the MC 18 to cut7/16" - 1/2" (11-12.7mm) wide. WARNING: This special outer flange assemblyis for use with blade width stacks of 7/16...

18 It is critical that the Governor and throttle on all internalcombustion engines be adjusted properly. The engine speedis preset at the factory for the proper sawing speed. It isNOT normally necessary to change this setting. It should beperiodically verified after the saw is placed into service. T...

27 Diagram 4 – Pointer & Belt Guard BILL OF MATERIAL INDEX P/N DESCRIPTION QTY 1 174328 Guard, Shaft - Weldment 1 2 020785 Lockwasher, Split .313 2 3 020399 Capscrew, Hex Hd .312-18UNC x 3.25 2 4 174977 Bracket, Pointer Mount 1 5 167908 Bar, Pointer - Offset 1 6 167906 Bar, Pointer - Straight 1 ...

22 WARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. ! ! Target Corporate Office Customer Service...………………….... 800-288-5040Corp. Office...………………………..... 913-928-1000Cust. Service FAX …………………… 8...