Husqvarna MC 18 9H - Manuals

9 SAFETY FIRST! WARNINGS DO’s and DO NOT’s WARNING: FAILURE TO COMPLY WITH THESE WARNINGS AND OPERATING INSTRUCTIONS COULD RESULT IN DEATH OR SERIOUS BODILY INJURY. DO NOT DO NOT operate this machine unless you have read and understood this operator’s manual. DO NOT operate this machine without the ...

10 FIGURE 2 2A. BLADE SHAFT NUT: Use to tighten the outer fl ange against the diamond blade. 2B. OUTER FLANGE: Use to hold the diamond blade in position. 2C. NOT USED 2D. LOCKING PIN: Use to prevent the diamond blade from rotating on the shaft during operation. 2E. DIAMOND BLADE: Use as the cutting ...

11 PRE OPERATION CHECKLIST Before leaving our factory, every machine is thoroughly tested. Follow our instructions strictly and your machine will give you long service in normal operating conditions. Before starting up the machine, make sure you read this entire operations manual and are familiar wi...

12 • T h e H a n d l e m u s t b e a t t a c h e d . P l a c e H a n d l e in position and securely tighten Knobs. • Check the engine oil level. Service before using. Refer to the engine operation manual for detailed information. These signs will give advice for your safety Before leaving our factor...

13 Always pay extreme care and attention to the preparation of the machine before starting. Remove all wrenches and tools from the fl oor and the machine. Always keep blade guard and transmission guard in place. (See Fig. 1 and 2) Always set the Engine Switch (1D) to the "OFF" position befor...

14 • Screw Feed Version: Raise the blade out of the cut by pulling up on the depth control lock and slowly turning the hand wheel clockwise. Raise the blade (2E) high enough out of the cut to clear the pavement when maneuvering the saw. • Turn off the Water Valve (1A). • Turn the Engine Throttle to ...

15 SPECIAL OUTER FLANGE ASSY 1/2" (12.7mm)WIDE CUT (P/N 167963) • A Special Outer Flange Assembly is available as a fi eld installed accessory. It enables the MC 18 to cut7/16" - 1/2" (11-12.7mm) wide. WARNING: This special outer fl ange assembly is for use with blade width stacks of 7/1...

16 It is critical that the Governor and throttle on all internal combustion engines be adjusted properly. The engine speed is preset at the factory for the proper sawing speed. It is NOT normally necessary to change this setting. It should be periodically verifi ed after the saw is placed into servi...

23 Diagram 3 – Pointer & Belt Guard BILL OF MATERIAL INDEX P/N DESCRIPTION QTY 1 502469601 Guard, Shaft - Weldment 1 2 020785 Lockwasher, Split .313 2 3 020399 Capscrew, Hex Hd .312-18UNC x 3.25 2 4 502469701 Bracket, Pointer Mount 1 5 502437601 Bar, Pointer - Offset 1 6 502437701 Bar, Pointer -...

Customer Service: 800-288-5040 Customer Serv. Fax: 800-825-0028 Printed in the USA DUST WARNING Cutting, especially when DRY cutting, generates dust that comes from the material being cut,which frequently contains silica . Silica is a basic component of sand, quartz, brick clay, granite and numerous...