Husqvarna K 750 - Manuals - manualsarea.com

Page 2 - TABLE OF CONTENTS; Section; Husqvarna Construction Products, North America; Corporate Office; CONTACT INFORMATION

SpeedMill TABLE OF CONTENTS Section Page No. Table of Contents.............................................. 2Contact Information.......................................... 2Symbols............................................................. 3Introduction................................................

Page 3 - SAFETY SYMBOLS & DECALS; KEY TO SYMBOLS; Key to symbols

SpeedMill 3 SAFETY SYMBOLS & DECALS 2 – English KEY TO SYMBOLS Key to symbols WARNING! The machine can be a dangerous tool if used incorrectly or carelessly, which can cause serious or fatal injury to the operator or others. Please read the operator’s manual carefully and make sure you understan...

Page 4 - Introduction; SAFETY INSTRUCTIONS

4 SpeedMill WARNING! Before starting up machine make sure you completely read these instructions and the power cutter operation manual. Be familiar with operation of the machine before operation!Your SpeedMill comes with two Operator’s Manual’s. This one for the SpeedMill attach- ment and one for th...

Page 6 - WHAT IS WHAT; C. Blade Arbor Spacer

6 SpeedMill WHAT IS WHAT WHAT IS WHAT (PARTS IDENTIFICATION) A. SpeedMill BLADE GUARD: Designed specifically for the SpeedMill. One side is open to allow mounting of the SpeedMill Bowls. Read this Operation Manual for more information. See SpeedMill Spare Parts List in this docu- ment for part numbe...

Page 7 - Uses; Tools Required

SpeedMill 7 WARNING! ONLY CUT or BEVEL PVC plastic pipe with a machine equipped with a Speed Mill Accessory! DO NOT cut other materials with this machine!DO NOT cut or bevel ductile iron pipe with a machine equipped with a Speed Mill Accessory!DO NOT use machine as a standard power cutter with- out ...

Page 8 - ASSEMBLY AND OPERATION; EVACUATE PIPE CONTENTS

8 SpeedMill ASSEMBLY AND OPERATION Mount the SpeedMill Bowl Assembly. Align the slot in the SpeedMill Hub with the face of the shaft. Make sure the flange face of the SpeedMill Hub con- tacts the face of the blade. Install the blade shaft bolt into the Hub Assembly. Using Combination Spanner, Suppli...

Page 9 - OPERATION

SpeedMill 9 OPERATION Rotate Pipe and repeat this cut- ting process until pipe circum- ference is cut. WARNING! HOLD MACHINE ONLY at front and rear handles! NEVER bevel or cut material while holding the pipe with your hands! DO NOT use blade guard pivot handle as a hand hold while operating machine!...

Page 10 - MAINTENANCE; Inspect the SpeedMill Bowls; CONVERTING THE SPEEDMILL TO A REGU-

0 SpeedMill MAINTENANCE: CAUTION! Allow SpeedMill Bowls to cool before performing any main- tenance. NOTICE! DO NOT hold SpeedMill Bowls using a screwdriver or other device through the slots in the bowl. Damage to the bowls or abrasive coating could occur. DO NOT use a screw driver or similar in the...

Page 11 - SPARE PARTS