Husqvarna CA 150 - Manuals - manualsarea.com

Page 2 - KEY TO SYMBOLS; Symbols

2 – English KEY TO SYMBOLS Symbols WARNING! The machine can be a dangerous tool if used incorrectly or carelessly, which can cause serious or fatal injury to the operator or others. Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. Al...

Page 3 - CONTENTS; Contents

English – 3 CONTENTS Contents Note the following before starting: Husqvarna AB has a policy of continuous product development and therefore reserves the right to modify the design and appearance of products without prior notice. Long-term exposure to noise can result in permanent hearing impairment....

Page 4 - SAFETY INSTRUCTIONS; Personal protective equipment; Cutting attachment guard

4 – English SAFETY INSTRUCTIONS Personal protective equipment GLOVESGloves should be worn when necessary, e.g., when fitting cutting attachments. HEARING PROTECTION Wear hearing protection that provides adequate noise reduction. EYE PROTECTION Always wear approved eye protection. If you use a visor ...

Page 5 - General safety precautions; Safety instructions before starting work

English – 5 SAFETY INSTRUCTIONS General safety precautions • Never allow children to use the machine. • Ensure that no-one comes closer than 15 m while you are working. • Never allow anyone else to use the machine without first ensuring that they have understood the contents of the operator’s manual...

Page 6 - General working instructions; Basic safety rules; Basic working techniques; Safety instructions after completing work

6 – English SAFETY INSTRUCTIONS General working instructions Basic safety rules 1 Look around you: - To ensure that people, animals or other things cannot affect your control of the machine. - To ensure that people, animals, etc., do not come into contact with the cutting attachment or loose objects...

Page 7 - What is what on the cultivator attachment?

English – 7 WHAT IS WHAT? What is what on the cultivator attachment? 1 2 3 4 5 6 7 8 1 Blade guard 2 Shaft 3 Blades 4 Split pin 5 Cotter pin 6 Grease filler cap, bevel gear 7 Bevel gear 8 Operator ′ s manual

Page 8 - ASSEMBLY; Fitting the bevel gear; Assembling the guard.

8 – English ASSEMBLY Fitting the bevel gear • Assembling the angle gear on the shaft. Turn the shaft so that the splines on the drive axle mate in the angle gear. • First tighten the screw H and then the screw M. Assembling the guard. • Remove the four screws C and the two screws F from the bracket ...

Page 9 - STARTING AND STOPPING; Check before starting

English – 9 STARTING AND STOPPING Check before starting For safety reasons follow these recommendations! • Inspect the working area. Remove any objects that could be thrown out. • Check that the machine is in perfect working order. Check that all nuts and screws are tight. • Check the tines and tine...

Page 10 - MAINTENANCE; Bevel gear; Maintenance schedule; Daily maintenance

10 – English MAINTENANCE Bevel gear The bevel gear is filled with the right quantity of grease at the factory. However, before using the machine you should check that the bevel gear is filled three-quarters (40g) full with grease. Use HUSQVARNA special grease. CAUTION! The gear housing must not be f...

Page 11 - TECHNICAL DATA

English – 11 TECHNICAL DATA Technical data Technical data CA 150 Weight Weight, Lbs/kg 2,9 Blades Diameter tines, mm 220 Working width, mm 150 Tine speed at engine speed 10,500 r/min 215