Husqvarna AUTOMOWER 550H EPOS - Manuals

2 Introduction Serial number: Product number: PIN code: The serial number and the product number are on the product rating plate and on the product carton.• Register your product on www.husqvarna.com. Enter the serial number of the product, the product number and the date of purchase to register you...

2.5 Product overview 13 1 4 6 10 15 9 12 19 14 5 7 8 2 3 17 16 18 11 20 1. Body 2. LED indicator lamp of the product 3. STOP/START button 4. Ultrasonic sensors 3 5. Front wheels 6. Rear wheels 7. Cutting system 8. Chassis box with electronics, battery and motors 9. Handle 10. Main switch11. Rating p...

2.9 General manual instructions The following system is used in the Operator’s Manual to make it easier to use:• Text written in italics is a text that is in the Automower ® Connect app, or is a reference to another section in the Operator’s manual. • Text written in bold is one of the buttons on th...

3 Installation 3.1 Introduction - Installation WARNING: Read and understand the safety chapter before you install the product. CAUTION: Use original spare parts and installation material. Note: Refer to www.husqvarna.com for more information about installation. 3.2 Primary components for installatio...

CAUTION: Make sure that the blades on the product do not cut the low-voltage cable. CAUTION: Do not put the low-voltage cable in a coil or below the charging station plate. The coil causes interference with the signal from the charging station. • Put the power supply in an area with a roof and prote...

• Make sure that a passage between one object lower than 1 m / 3.3 ft. and one object higher than 1 m / 3.3 ft. has a minimum width (A) of 2 m / 6.6 ft. • Make sure that the distance between objects (B) lower than 1 m / 3.3 ft. is minimum 1 m / 3.3 ft. A A B 3.7.3 To install the map objects in a slo...

1. Install the reference station. Refer to the Operator's manual for the reference station. 2. Install the charging station. Refer to To install the charging station on page 16. 3. Install the Automower ® Connect app on your mobile device. Refer to Automower ® Connect on page 17. 4. Do a pairing ope...

4 Settings The product has factory settings but the settings can be adapted to each work area. 4.1 Schedule In the Schedule menu you can change the schedule settings for the product. You can set separate schedule settings for each work area. Secondary areas cannot be scheduled. The schedule function...

4.11 Messages In this menu the previous fault and information messages can be found. For some of the messages, there are tips and advice to help to rectify the fault.If the product is disrupted in any way, for example it is trapped or the battery is low, a message is saved relating to the disruption...

5 Operation 5.1 Main switch WARNING: Read and understand the safety chapter before you use the product. • Set the Main switch to the 1 position to start the product. • Set the Main switch to the 0 position to set the product to OFF. 5.2 To start the product 1. Push the STOP button on the product. 2....

6 Maintenance 6.1 Introduction - maintenance WARNING: Set the product to OFF before you do maintenance on the product. WARNING: Use protective gloves. For better operation and lifetime of the product, make sure to clean the product regularly and replace worn parts.When the product is new, examine th...

To prepare Weekly Every year Every third year Examine the rubber grommets on the chassis to make sure that it is sealed correctly. O Examine the skid plate and skid plate bearing. O Examine the rubber bellows in the cutting height adjustment system. O Examine the rubber bellows for the collision col...

6.4 Replacement of the blades WARNING: Husqvarna can only guarantee safety if you use Husqvarna original blades with the embossed crowned H-mark logotype. WARNING: You must replace the screws when you replace the blades. The used screws can wear quickly and make the blade come loose, this can cause ...

7 Troubleshooting 7.1 Messages The messages in the table below are shown in the app. Speak to your Husqvarna representative if the same message shows frequently. Message Cause Action Cutting system blocked The blade disc is blocked by grass or other objects. Examine the blade disc and remove the gra...

Message Cause Action No power in charging station Incorrect or damaged power supply. Examine the power supply. If it is neces- sary, replace the power supply. Power failure. Examine and correct the cause for the power failure of the reference station. The connection between the charging plates on th...

7.3 LED indicator on the product The LED indicator on the control panel of the product shows the current product status: LED indicator light Product status Constant green The product cuts the lawn or moves out of the charging station. Pulsates green The product is preparing to start its operation. F...

8 Transportation, storage and disposal 8.1 Transportation The supplied Li-ion batteries obey the Dangerous Goods Legislation requirements.• Obey all applicable national regulations. • Obey the special requirement on package and labels for commercial transportations, including by third parties and fo...

9 Technical data 9.1 Technical data Dimensions Automower ® 520H EPOS Automower ® 550H EPOS Length, cm / in. 75 / 29.5 75 / 29.5 Width, cm / in. 63 / 24.8 63 / 24.8 Height, cm / in. 35 / 13.8 35 / 13.8 Weight, kg / lbs 15.1 / 33.3 15.6 / 34.4 Electrical system Automower ® 520H EPOS Automower ® 550H E...

Frequency Band Support Bluetooth ® Frequency range 2400.0-2483.5 MHz Automower ® Connect 2G GSM 850 MHz, E-GSM 900 MHz, DCS 1800 MHz, PCS 1900 MHz Automower ® Connect 4G Band 12 (700 MHz), Band 17 (700 MHz), Band 28 (700 MHz), Band 13 (700 MHz), Band 20 (800 MHz), Band 26 (850 MHz), Band 5 (850 MHz)...

10 Applicable to US/CA market 10.1 Supplier's Declaration of Conformity Responsible party: Husqvarna Consumer Outdoor Products N.A., Inc, 8825 Statesville Road, Charlotte, NC 28269, Tel: +1 704 597 5000, www.husqvarna.com/us/ support/e-mail/. 10.2 Compliance requirements FCC ID: MCQ-XBSX (Short rang...

EN pt Para obter mais informações, leia o manual do operador da estação de referência e o manual do operador do cortador de relva robótico. A Uma visão geral do sistema O sistema EPOS contém um cortador de grama robótico, uma estação de carregamento e uma estação de referência. O cortador de grama r...