Husqvarna AUTOMOWER 450X EPOS - Manuals

2 Introduction Serial number: Product number: PIN code: The serial number and the product number are on the product rating plate and on the product carton.• Register your product on www.husqvarna.com. Enter the serial number of the product, the product number and the date of purchase to register you...

2.5 Product overview 13 1 4 6 10 15 9 12 19 14 5 7 8 2 3 17 16 18 11 20 1. Body 2. LED indicator lamp of the product 3. STOP/START button 4. Ultrasonic sensors 5. Front wheels 6. Rear wheels 7. Cutting system 8. Chassis box with electronics, battery and motors 9. Handle 10. Main switch11. Rating pla...

2.9 General manual instructions The following system is used in the Operator’s Manual to make it easier to use:• Text written in italics is a text that is in the Automower ® Connect app, or is a reference to another section in the Operator’s manual. • Text written in bold is one of the buttons on th...

3 Installation 3.1 Introduction - Installation WARNING: Read and understand the safety chapter before you install the product. CAUTION: Use original spare parts and installation material. Note: Refer to www.husqvarna.com for more information about installation. 3.2 Primary components for installatio...

CAUTION: Do not put the low-voltage cable in a coil or below the charging station plate. The coil causes interference with the signal from the charging station. • Put the power supply in an area with a roof and protection from the sun and rain. • Put the power supply in an area with good airflow. • ...

A A B 3.7.3 To install the map objects in a slope The product can operate in 45% slopes. Virtual boundaries can be installed in maximum 15% slopes. The slope (%) is calculated as height for each m. Example: 10 cm / 100 cm = 10%. 10 cm / 4" 100 cm / 40" 10% • For slopes more than 45% in the w...

4 Settings The product has factory settings but the settings can be adapted to each work area. 4.1 Schedule In Schedule menu you can change the schedule settings for the product. The Schedule is set for each work area that is connected to the charging station. Secondary areas cannot be scheduled.The...

If the same message is repeated several times, this may indicate that an adjustment to the installation or the product is required. Refer to Installation on page 11. 4.12 Download firmware over the air (Firmware over the air FOTA) The product has a function that automatically downloads new firmware....

5 Operation 5.1 Main switch WARNING: Read and understand the safety chapter before you use the product. • Set the Main switch to the 1 position to start the product. • Set the Main switch to the 0 position to set the product to OFF. 5.2 To start the product 1. Push the STOP button on the product. 2....

6 Maintenance 6.1 Introduction - maintenance WARNING: Set the product to OFF before you do maintenance on the product. WARNING: Use protective gloves. For better operation and lifetime of the product, make sure to clean the product regularly and replace worn parts.When the product is new, examine th...

7 Troubleshooting 7.1 Messages The messages in the table below are shown in the app. Speak to your Husqvarna representative if the same message shows frequently. Message Cause Action Cutting system blocked The blade disc is blocked by grass or other objects. Examine the blade disc and remove the gra...

Message Cause Action No power in charging station Incorrect or damaged power supply. Examine the power supply. If it is neces- sary, replace the power supply. Power failure. Examine and correct the cause for the power failure of the reference station. The connection between the charging plates on th...

7.3 LED indicator on the product The LED indicator on the control panel of the product shows the current product status: LED indicator light Product status Constant green The product cuts the lawn or moves out of the charging station. Pulsates green The product is preparing to start its operation. F...

8 Transportation, storage and disposal 8.1 Transportation The supplied Li-ion batteries obey the Dangerous Goods Legislation requirements.• Obey all applicable national regulations. • Obey the special requirement on package and labels for commercial transportations, including by third parties and fo...

9 Technical data 9.1 Technical data Dimensions Automower ® 450X EPOS Automower ® 450XH EPOS Length, cm / in. 72 / 28.3 75 / 29.5 Width, cm / in. 56 / 22.0 63 / 24.8 Height, cm / in. 32 / 12.6 35 / 13.8 Weight, kg / lbs 14.4 / 31.7 16 / 35.3 Electrical system Automower ® 450X EPOS Automower ® 450XH E...

Power Class Bluetooth ® Output power 8 dBm Automower ® Connect 2G Power Class 4 (GSM/E-GSM) 33 dBm Power Class 1 (DCS/PCS) 30 dBm Power Class E2 (GSM/E-GSM) 27 dBm Power Class E2 (DCS/PCS) 26 dBm Automower ® Connect 4G Power Class 3 23 dBm SRD915 13 dBm Full compatibility cannot be guaranteed betwee...

10 Applicable to US/CA market 10.1 Supplier's Declaration of Conformity Responsible party: Husqvarna Consumer Outdoor Products N.A., Inc, 8825 Statesville Road, Charlotte, NC 28269, Tel: +1 704 597 5000, www.husqvarna.com/us/ support/e-mail/. 10.2 Compliance requirements FCC ID: MCQ-XBSX (Short rang...

EN pt Para obter mais informações, leia o manual do operador da estação de referência e o manual do operador do cortador de relva robótico. A Uma visão geral do sistema O sistema EPOS contém um cortador de grama robótico, uma estação de carregamento e uma estação de referência. O cortador de grama r...