Husqvarna AR19 - Manuals

5 MODEL AR25 - FEATURES AND CONTROLS Figure 2 Operator’s Guide

6 MODEL TA36 - FEATURES AND CONTROLS Operator’s Guide

8 The following decals are found on Model AR19 and AR25 or TA36 aerators. If any are missing or notlegible, replace them before operating aerator. SAFETY AND INSTRUCTION DECALS A - Model AR19 only (1 ea) B - Model AR19 & AR25 only (2 ea) I - Model AR19 & AR25 only (1 ea) J - Model AR25 only ...

9 Throttle CableModel AR25 withHonda Only I (On back ofhousing overtine rotor) D2 E (on deckbehindengine D1 G H J (For Model AR25)A (For Model AR19) B C (For Model AR25) DECAL PLACEMENT - MODELS AR19 AND AR25 F K Figure 3

10 ASSEMBLY INSTRUCTIONS Model AR19 1. Wear eye protection. Remove wooden blocks. NOTE: Watch for nails and wood splinters.2. Carefully cut open side of carton.3. Lawn Aerator is shipped with handle folded. Lock handle in position using the cam lock lever. Model AR25 1. Wear eye protection. Remove w...

11 AERATION TIPS Should I water before aerating? Best aerating condition is a soft and moist ground. If you are unsure of the ground conditions, as insoil with high clay content, a simple test will determine whether it is necessary to water beforeaerating. Using a garden hand spade or a large screw ...

14 When operating on hills you should consider the following: (A) Operate the machine up and down the hills rather than across them.(B) Use the rear wheel depth/stability control knob to set the rear wheels for extra stability. This can be a great benefit when you do choose to run the aerator across...

15 ENGINE SERVICE AND MAINTENANCE Follow the engine manufacturers maintenance instructions. Should any malfunction occur with theengine during the warranty period, take it to an Authorized Service Dealer. DO NOT tear down theengine, as this may void the Engine Manufacturers Warranty NOTE: Refer to e...

17 HANDLE - MODEL AR19 ONLY Inspection 1. The handle cam lock must lock shut under moderately heavy hand pressure. Handle frame should be tightly secured to the aerator body. 2. Check the cam rod lock nut. If it turns freely by hand when cam is released, the locking strength of the nut has been reli...

18 Drive Wheel Shaft Removal and Replacement (Continued)7. Pull sprocket and bearing from shaft. NOTE: Sprocket is double set screwed. To remove the bearings, you must first remove the collar by loosening the set screw, then insert pin punch intothe hole next to the set screw and, using a hammer, wi...

19 TINE AND TINE SHAFT Tine Replacement1. Turn off engine and remove weights.2. Fold handle on the AR19 Model.3. Note direction of tine bolt.4. Remove and replace tines by loosening stop bolt. Remove retaining bolt and old tine, insert new tine and fasten with retaining bolt in the same direction as...

20 What is Aeration?For healthy growth, grass roots need air space in the soil to absorb oxygen, water, and nutrients. Airspace in turf soils is reduced when soils are compacted by foot traffic, rainfall, irrigation, duringbuilding construction and landscaping. Aeration by mechanically removing smal...