Husqvarna 968999211 / CZ48 - Manuals

Page 2 - SAFETY RULES; SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS; Tall

2 SAFETY RULES DANGER ! THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWINGOBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULDRESULT IN SERIOUS INJURY OR DEATH. SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS I. GENERAL OPERATION • Read, understand and follow all in...

Page 4 - DO NOT

4 SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS CAUTION WARNING Look for this symbol to point out impor-tant safety precautions. It means CAU-TION!!! BECOME ALERT!!! YOUR SAFETYIS INVOLVED. CAUTION In order to prevent accidental starting whensetting up, transporting, adjusting or mak-ing ...

Page 5 - CONGRATULATIONS; TABLE OF CONTENTS; KNOW YOUR GRASS CATCHER

5 CONGRATULATIONS on your purchase of a new Grass Catcher. It has been designed, engi-neered and manufactured to give you the bestpossible dependability and performance. Should you experience any problem you cannoteasily remedy, please contact your nearest au-thorized service center/ department. The...

Page 6 - CAUTION

6 UNPACKING INSTRUCTIONS • Remove all parts and packing materialsfrom carton. • Check carton contents against list. Be sureall parts are there. TOOLS REQUIRED FOR ASSEMBLY (2) 1/2" Wrenches(1) 9/16" Wrench(1) 9/16" Socket wrench CARTON CONTENTS: 3 - Container Tops 2 - Straps 3 - Containe...

Page 7 - ASSEMBLY; FIGURE 1A

7 ASSEMBLY 1 BAGGER SUPPORT ASSEMBLY(See Figures 1A and 1B) 1. Remove rear engine guard by removing the six bolts that attach the guard to the frame. 2. Attach hitch (Part No. 539108014) to the frame using the same holes and same sixbolts that attached the rear engine guard. * NOTE: If your unit doe...

Page 8 - FIGURE 3; FIGURE 4; WARNING

8 3 CONTAINER ASSEMBLY(See Figure 3) 1. Place bottom half inside of top half, as shown.2. Place one foot inside bottom half and lift top half to meet bottom half. 3. Press halves tightly together while lifting top to lock into place as shown. IMPORTANT: BEFORE LOCKING THE TABS, HOOKED EDGES ON BOTH ...

Page 9 - FIGURE 5; FIGURE 6A; LEVEL MOWER DECK

9 5 LOWER CHUTE(See Figure 5) 1. Turn mower engine off.2. Raise and hold deflector shield in upright position. 2. Place slot in lower chute over tab on mower deck and position lower chute over deckopening as shown. 3. Hook rear latch into flange hole on back of mower deck. 4. Hook front latch into t...

Page 10 - FIGURE 8

10 ASSEMBLY 8 FRONT WEIGHTS(See Figure 8) 1. Turn casters so they are facing the front as shown. 2. Bolt the weights to the front tube of the frame as shown. FIGURE 8 539990546(NUT, 3/8-16, CENTERLOC) 539108154 (WHEEL WEIGHT) 539108156 (STRAP) 539108156 (STRAP) 539108154 (WHEEL WEIGHT) 539990591(BOL...

Page 11 - OPERATION; TIPS FOR IMPROVED BAGGING OPERATION:; • DO NOT operate mower with grass

11 OPERATION TIPS FOR IMPROVED BAGGING OPERATION: Follow the mower operation instructions in youmower operator’s manual. When operating your grass catcher on a lawnwhere grass and leaf bagging equipment has notbeen used, you are picking up thatch and debristhat has accumulated for long periods of ti...

Page 12 - CUSTOMER RESPONSIBILITIES; GENERAL RECOMMENDATIONS:; have completely stopped.

12 CUSTOMER RESPONSIBILITIES GENERAL RECOMMENDATIONS: Always observe safety rules when performing anymaintenance.• Before each use check for loose fasteners.• Clean unit thoroughly after each use. BLADE CARE: For best results mower blades must be kept sharp.Replace bent or damaged blades.• See BLADE...

Page 13 - PARTS ILLUSTRATION

Page 14 - PARTS

14 PARTS 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 21 21 23 30 16 16 16 30 30 16 30 30 31 31 31 16 18 16 16 7 10 12 7 14 13 32 32 33 33 33 33 34 34 35 36 36 37 37 38 39 39 40 40 40