Page 2 - Product description
Contents Introduction..................................................................... 2Safety..............................................................................4Assembly...................................................................... 17Operation....................................
Page 4 - Product liability
Double insulation. Product liability As referred to in the product liability laws, we are not liable for damages that our product causes if: • the product is incorrectly repaired.• the product is repaired with parts that are not from the manufacturer or not approved by the manufacturer. • the produc...
Page 12 - Product overview on
ability to hear sounds and warning signals. • Use approved eye protection. If you use a visor, you must also use approved protective goggles. Approved protective goggles must comply with the ANSI Z87.1 standard in the USAs or EN 166 in EU countries. • Use a visor for face protection. A visor is not ...
Page 14 - Accessories on page
3. Make sure that the power trigger and the lock moves freely and that the return spring works properly. 4. Start the product, see To start the product on page 19. 5. Apply full throttle.6. Release the power trigger and make sure that the cutting attachment stops and remains still. To do a check of ...
Page 17 - Introduction
• Do not put objects into the cooling slots of the battery charger. • Do not connect the battery charger terminals to metal objects as this can short circuit the battery charger. • Use approved mains sockets that are not damaged. Make sure that the cord of the battery charger is not damaged. If exte...
Page 18 - To attach the loop handle; Operation
To attach the loop handle 1. Attach the loop handle to the shaft in compliance with the illustration and tighten. 2. Make sure that the loop handle attaches between the arrows on the shaft. Operation Introduction WARNING: Read and understand the safety chapter before you use the product. Before you ...
Page 19 - To start the product
4. When all LEDs on the battery come on, the battery is fully charged. 5. To disconnect the battery charger from the mains socket, pull the plug. Do not pull the cable. 6. Remove the battery from the battery charger. Note: Refer to the battery and battery charger manuals for more information. To con...
Page 20 - To stop the product
2. Decrease the length of the trimmer line by 10-12 cm / 4-4.75 in. 3. Decrease the engine speed to decrease the risk of damage to plants. 4. Use 80 % throttle when you cut grass near objects. To clear grass 1. Keep the trimmer head above the ground.2. Tilt the trimmer head.3. Cut with the end of th...
Page 21 - Maintenance
Maintenance Introduction WARNING: Read and understand the safety chapter before you do maintenance work on the product. WARNING: Remove the battery before you do maintenance on the product. Maintenance schedule WARNING: Remove the battery before you do maintenance. The following is a list of the mai...
Page 22 - To do a check of the trimmer line; Troubleshooting; Keypad
To do a check of the trimmer line Only use the recommended trimmer line. See the illustration on the last pages of the manual.1. Put the cord into the hole on the cover of the product to make sure it follows the recommendation. To replace the trimmer headNote: To increase the life of the cord it can...
Page 23 - Transportation, storage and disposal; Transportation and storage
LED display Possible faults Possible action Error LED is lit with red light The product needs servicing. Contact your servicing agent. Battery Problem Possible faults Possible solution Green LED flashes. Low battery voltage. Charge the battery. Red error LED flashes. The battery is empty. Charge the...
Page 24 - Technical data
approved persons to touch the equipment. Keep the equipment in a space that you can lock. • Clean the product and do a full servicing before you put the product in storage for a long time. • Use the transportation guard on the product to prevent injuries or damage on the product during transportatio...
Page 25 - Accessories; Approved accessories
315iC Vibration levels 3 Vibration levels (a h ) at handles, measured refer to EN 11806 and ISO 22867, m/s 2 Equipped with trimmer head (original), left/right 1.9/1.3 Approved batteries Only use original BLi batteries for this product. Approved battery chargers Battery charger QC330 QC500 Input volt...
Page 26 - Declaration of Conformity; EU Declaration of Conformity
Declaration of Conformity EU Declaration of Conformity We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declare on our sole responsibility that the product: Description Battery-operated Grass Trimmer Brand Husqvarna Type / Model 315iC Identification Serial numbers dating from 2021 ...
Page 27 - Declaration of conformity
Declaration of conformity We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declare on our sole responsibility that the product: Description Battery-operated Grass Trimmer Brand Husqvarna Type / Model 315iC Identification Serial numbers dating from 2021 and onwards complies fully wi...