Page 2 - CONTENTS; Content; UNPACKING
CONTENTS Content Page Table of contents ………………………….. 2Unpacking .................................................. 2Transporting ............................................... 2Sound Data ................................................ 2 I ntroduction, personal safety ...................... 3 Regi...
Page 3 - INTRODUCTION; PERSONAL SAFETY EQUIPMENT
INTRODUCTION Common sense: The focus of this manual is HOW to operate and service the equipment safely. It is not possible to cover every conceivable situation you can face when using this equipment. Therefore use this product only in a manner described in this manual. Operation or handling the mach...
Page 4 - CAUTION; WARNING; SAFETY DEFINITIONS
4 REGISTER THE PRODUCT Please register your new 150 with Husqvarna Construction Products by mailing in the registration card that came with the machine or you can register on the internet site www.husqvarnawarranty.com Registration will allow us to contact in case of any critical updates or recalls ...
Page 5 - SAFETY WARNINGS
5 SAFETY WARNINGS WARNING Failure to comply with the following warnings could result in serious bodily injury or death! PERSONAL SAFETY • Read and understand instructions before operating saw. • Always wear safety approved hearing, eye, head and respiratory protection. • Wear boots with non-slip sol...
Page 6 - EXCEL SERIES BLADES; BLADE AND SKID PLATE INSTALLATION
6 EXCEL SERIES BLADES The Excel Series of diamond blades have been designed specifically for the Soff-Cut Ultra Early Entry dry cutting system of green concrete. These specialty blades are designed to increase speed and life while cutting a wide range of aggregates. Choose the correct specification ...
Page 7 - WHAT IS WHAT
WHAT IS WHAT D C E B A J F What is what? A. Oil dipstick or fill B. Oil drainC. Fuel shut off leverD. Choke leverE. Throttle leverF. Starter rope G. Air cleanerH. Fuel tankJ. Engine on/off switch Model number and serial number 7 G H H A
Page 8 - OPERATING INSTRUCTIONS
8 OPERATING INSTRUCTIONS Experience is very important when running the 150 saw. A skilled worker is highly recommended. Always do an inspec-tion of the saw before starting the engine. Check the fuel (H) and oil level (A) per the enclosed engine manual. SAE 10W/30 oil and unleaded gasoline with an 87...
Page 9 - OIL HANDLING; ENGINE OIL
9 FUEL HANDLING PROPER FUEL Taking the following precautions will lessen the risk of injury and property damage: - Use extreme care in handling gasoline. It is extremely flammable and the vapors are explosive. - Extinguish all cigarettes, cigars, pipes, and other sources of ignition.- Use only appro...
Page 10 - Engine Oil; Checking, Adding and Changing Oil; MAINTENANCE; NOTICE
10 Engine Oil Checking, Adding and Changing Oil Check the engine oil level (A) daily with saw fully lowered and the engine level. See the enclosed Robin manual for more details.Use SAE 10W-30 viscosity detergent automotive type with API service class SE or higher grade oil. Note: Engine holds approx...
Page 11 - SAWING CONTRACTION JOINTS
11 As concrete hydrates or cures and begins to set, it develops internal stresses which may cause random cracks. Random cracks cast doubt on the quality and workmanship of the concrete. Contraction joints are cut in concrete to relieve these stresses before they seek their own relief in the form of ...
Page 12 - MAXIMIZING THE SOFF-CUT SYSTEM
12 “ The timing of concrete operations - especially finishing and jointing - is critical” , states a quote from the foreword of the American Concrete Institute (ACI) 302.1 R-96. It goes on to say that “Failure to address this issue can contribute to unde-sirable characteristics in the wearing surfac...
Page 13 - TROUBLESHOOTING
13 TROUBLESHOOTING ENGINE WILL NOT START - Check if there is fuel in the tank and it is the correct fuel. Make sure there is no water in the fuel. - Check if the fuel valve is turned to the “on” position. - Check if the kill switch is in the “on” position. - Check that the spark plug wire is connect...
Page 14 - TECHNICAL SPECIFICATIONS; EC DECLARATION OF CONFORMITY; TECHNICAL DATA
TECHNICAL SPECIFICATIONS Engine Model Robin EX 13 Engine oil volume, quarts/liters 0.6/0.6 Gasoline tank volume, gal/liters 0.7/2.7 Type Air cooled, 4-cycle, single slant cylinder, overhead camshaft, gasoline engine Air fi lter Cyclonic type Oil system Oil alert with auto shut down sensor Muf fl er ...
Page 15 - WARRANTY
15 WARRANTY HUSQVARNA EQUIPMENT WARRANTY New 150 sold by Husqvarna Construction Products are warranted to be free from manufacturing defects in normal service for a period of six (6) months for labor and up to one (1) year on parts from date of purchase by the original consumer purchaser or date of ...
Page 16 - Original instructions
1153478-26 2009-12-29 www.husqvarnacp.com ´®z+UOr¶6h¨ ´®z+UOr¶6h¨ Original instructions