Husqvarna 1365GN - Manuals - manualsarea.com

Page 2 - Hazard Symbols and Meanings; Safety Rules; WARNING

2 TABLE OF CONTENTS Safety Rules . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-4Know Your Generator . . . . . . . . . . . . . . . . . . . . . . . . . . . 5Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-7Operation . . . . . . . . . . . . . ....

Page 5 - KNOW YOUR GENERATOR

5 12 Volt DC,10 Amp Receptacle — Recharge a discharged12 Volt automotive type battery through this receptacle.120 Volt AC, 20 Amp GFCI Duplex Receptacles —May be used to supply electrical power for the operationof 120 Volt AC, 20 Amp, single phase, 60 Hz electrical,lighting, appliance, tool and moto...

Page 6 - ASSEMBLY; Remove Generator From Carton; Assembly

6 ASSEMBLY Your generator requires some assembly and is ready foruse after it has been properly serviced with therecommended oil and fuel. If you have any problems with the assembly of yourgenerator, please call the generator helpline at1–877–224–0458. Remove Generator From Carton 1. Set carton on a...

Page 7 - Add Engine Oil and Fuel; CAUTION

7 2. Slide axle through both axle mounting brackets oncradle frame, as shown in Figure 1. 3. Slide a wheel over the axle. NOTE: Be sure to install both wheels with the airpressure valve on the outboard side. 4. Place the e-ring onto the groove in the axle. You mayadd the flat washer if desired. NOTE...

Page 8 - Starting the Engine; Operation

8 GROUNDING THE GENERATOR The National Electrical Code requires that the frame andexternal electrically conductive parts of this generator beproperly connected to an approved earth ground. Localelectrical codes may also require proper grounding of theunit. For that purpose, a GROUNDING FASTENER ispr...

Page 9 - DANGER

9 4. Start engine according to instructions given in engineowner’s manual. NOTE: If engine starts after 3 pulls but fails to run, or ifunit shuts down during operation, make sure unit is on alevel surface and check for proper oil level in crankcase.This unit may be equipped with a low oil protection...

Page 10 - COLD WEATHER

10 6. Connect battery charge cable clamp with black handleto the negative (–) battery terminal (Figure 5). 7. Start engine. Let engine run while battery recharges. 8. When battery has charged, shut down engine NOTE: Use an automotive hydrometer to test batterystate of charge and condition. Follow th...

Page 11 - RECEPTACLES; Receptacle

11 RECEPTACLES 120/240 Volt AC, 30 Amp, Locking Receptacle Use a NEMA L14–30 plug with this receptacle. Connect a4–wire cord set rated for 250 Volt AC loads at 30 Amps (orgreater) (Figure 7). You can use the same 4–wire cord if youplan to run a 120 Volt load. This receptacle powers 120/240 Volt AC, ...

Page 13 - GENERATOR; Capacity

13 DON'T OVERLOAD GENERATOR Capacity You must make sure your generator can supply enoughrated (running) and surge (starting) watts for the items youwill power at the same time. Follow these simple steps:1. Select the items you will power at the same time. 2. Total the rated (running) watts of these ...

Page 14 - Maintenance

14 SPECIFICATIONS Maximum Surge Watts . . . . . . . . . . . . . . . . .8,125 wattsContinuous Wattage Capacity . . . . . . . . . . .6,500 wattsPower Factor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.0Rated Maximum Continuous AC Load Current: At 120 Volts . . . . . . . . . . . . . . ...

Page 15 - STORAGE; Generator Storage; Storage

15 STORAGE The generator should be started at least once every sevendays and allowed to run at least 30 minutes. If this cannotbe done and you must store the unit for more than30 days, use the following guidelines to prepare it forstorage. Generator Storage • Clean the generator as outlined in “Gene...

Page 17 - Problem

17 TROUBLESHOOTING Troubleshooting Problem Engine is running, but no ACoutput is available. Engine runs good but bogs downwhen loads are connected. Engine shuts down duringoperation. Engine lacks power. Cause 1. Circuit breaker is open. 2. Poor connection or defectivecord set. 3. Connected device is...

Page 21 - PARTS LIST – MAIN UNIT; Exploded Views

21 PARTS LIST – MAIN UNIT Item Part # Description 1 N192958AGS CRADLE 2 82857GS MOUNT, Vibration 3 N92531GS SUPPORT, Engine 4 190220GS HOUSING, Engine Adapter 5 45771GS NUT 6 NSP ASSY, Alternator (see page 22) 7 N92731GS SUPPORT, Eng/Muffler 8 96796GS WASHER 9 92609GS MOUNT, Vibration 10 190274BGS S...

Page 23 - EXPLODED VIEW AND PARTS LIST – CONTROL PANEL

23 EXPLODED VIEW AND PARTS LIST – CONTROL PANEL Item Part # Description 1 NSP PANEL, Control2 B192836GS BOX, Control Panel 3 23897GS WASHER 4 49226GS WASHER, Lock 5 91526GS SCREW 6 22447GS WASHER 7 82538GS SWITCH, Rocker 8 90418GS OUTLET, 12VDC, Snap 9 77604GS METER, Hour 10 43182GS WASHER, Lock 11 ...