Husqvarna 1055 GN - Manuals

Husqvarna 1055 GN – Manual in PDF format online.

Manuals:

Manual

Manual Husqvarna 1055 GN

Summary

Page 2 - Assembly; Where to Find Us

www.usa.husqvarna.com Thank you for purchasing this quality-built Husqvarna generator. We are pleased that you’ve placed your confidence in the Husqvarna brand. When operated and maintained according to the instructions in this manual, your Husqvarna generator will provide many years of dependable s...

Page 3 - Table of Contents

3 Español Table of Contents Operator Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Equipment Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Safety Rules . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

Page 4 - Operator Safety; Equipment Description; NOTICE; Safety Rules; will; WARNING

4 www.usa.husqvarna.com Operator Safety Equipment Description Read this manual carefully and become familiar with your generator. Know its applications, its limitations and any hazards involved. The generator is an engine–driven, revolving field, alternating current (AC) generator. It was designed t...

Page 5 - The engine exhaust from this product contains; can result in death or injury to electric utility; Starter cord kickback (rapid retraction) can result; Fuel and its vapors are extremely flammable and

5 WARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. WARNING Generator produces hazardous voltage.Failure to isolate generator from power utility can result in death or injury to electric utilit...

Page 7 - Generator Controls; Unpack Generator; The generator is supplied with:; Install Wheel Kit; Install the wheel kit as follows:; CAUTION

7 Assembly Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended fuel and oil.If you have any problems with the assembly of your generator, please call the generator helpline at (877) 4-0458 . If calling for assistance, please have the mo...

Page 8 - Add Engine Oil; Oil; Add Fuel; Fuel must meet these requirements:; Storage; High Altitude

8 www.usa.husqvarna.com Add Engine Oil 1. Place generator on a flat, level surface. 2. Clean area around oil fill and remove yellow oil fill cap. NOTE: See the section Oil to review oil recommendations. Verify provided oil bottle is correct viscosity for current ambient temperature. 3. Using oil fun...

Page 9 - System Ground; Special Requirements; Connecting to a Building’s Electrical System; Generator Location; Clearances and Air Movement

9 System Ground The generator has a system ground that connects the generator frame components to the ground terminals on the AC output receptacles. The system ground is connected to the AC neutral wire (the neutral is bonded to the generator frame). Special Requirements There may be Federal or Stat...

Page 10 - Features and Controls

10 www.usa.husqvarna.com A - 10 Volt AC, 0 Amp, Duplex Receptacles — May be used to supply electrical power for the operation of 120 Volt AC, 20 Amp, single phase, 60 Hz electrical, lighting, appliance, tool, and motor loads. B - 10/40 Volt AC, 30 Amp Locking Receptacle — May be used to supply elect...

Page 11 - Cord Sets and Receptacles

11 Cord Sets and Receptacles Use only high quality, well-insulated, grounded extension cords with the generator’s 120 Volt duplex receptacle. Inspect extension cords before each use.Check the ratings of all extension cords before you use them. Extension cord sets used should be rated for 125 Volt AC...

Page 12 - Operation; Starting the Engine

1 www.usa.husqvarna.com Operation Starting the Engine Disconnect all electrical loads from the generator. Use the following start instructions: 1. Make sure unit is on a level surface. IMPORTANT: Failure to start and operate the unit on a level surface will cause the unit not to start or shut down d...

Page 13 - Connecting Electrical Loads; Don’t; Stopping the Engine; Off

13 Connecting Electrical Loads 1. Let engine stabilize and warm up for a few minutes after starting. 2. Plug in and turn on the desired 120 and/or 240 Volt AC, single phase, 60 Hz electrical loads. NOTE: • DO NOT connect 240 Volt loads to the 120 Volt duplex receptacles. • DO NOT connect 3-phase loa...

Page 15 - Maintenance; Maintenance Schedule; Emissions Warranty; Generator Maintenance

15 Maintenance Maintenance Schedule Follow the hourly or calendar intervals, whichever occurs first. More frequent service is required when operating in adverse conditions noted below. First 5 Hours • Change engine oil Every 8 Hours or Daily • Clean debris • Check engine oil level Every 5 Hours or y...

Page 16 - Checking Oil Level

1 www.usa.husqvarna.com Fuel Valve Maintenance The fuel valve is equipped with a fuel sediment cup, screen, retaining ring and o-ring that need to be cleaned every 100 hours or once a year (whichever occurs first). 1. Move fuel valve to “ Off ” position. 2. Remove sediment cup ( A ) from fuel valve....

Page 17 - Changing Engine Oil; Service Air Cleaner; Specifications; Service Spark Arrester

17 Changing Engine Oil Change the oil after the first 5 hours of operation. Change oil every 50 hours thereafter. If you are using your generator under extremely dirty or dusty conditions, or in extremely hot weather, change the oil more often. CAUTION Avoid prolonged or repeated skin contact with u...

Page 18 - Clean and inspect the spark arrester as follows:; Check Valve Clearance; Carburetor Adjustment

18 www.usa.husqvarna.com WARNING Contact with muffler area can result in serious burns.Exhaust heat/gases can ignite combustibles, structures or damage fuel tank causing a fire. • DO NOT touch hot parts and AVOID hot exhaust gases.• Allow equipment to cool before touching.• Keep at least 5 feet (1.5...

Page 19 - Generator Storage; Cleaning; Long Term Storage Instructions; Change Engine Oil; Oil Cylinder Bore; Other Storage Tips; Long Term Storage

19 Storage The generator should be started at least once every seven days and allowed to run at least 30 minutes. If this cannot be done and you must store the unit for more than 30 days, use the following guidelines to prepare it for storage. Generator Storage • Clean the generator as outlined in C...

Page 20 - Troubleshooting; Problem

0 www.usa.husqvarna.com Troubleshooting Problem Cause Correction Engine is running, but no AC output is available. 1. One of the circuit breakers is open. 2. Fault in generator. 3. Poor connection or defective cord set. 4. Connected device is bad. 1. Reset circuit breaker. 2. Contact authorized serv...

Page 21 - Warranties; Emissions Control System Warranty

1 Warranties Emissions Control System Warranty Briggs & Stratton Corporation (B&S), the California Air Resources Board (CARB) and the United States Environmental Protection Agency (U.S. EPA) Emissions Control System Warranty Statement (Owner’s Defect Warranty Rights and Obligations) Californ...

Page 22 - Emission Information; Emissions Durability Period

www.usa.husqvarna.com 2. Length of Coverage B&S warrants to the initial owner and each subsequent purchaser that the Warranted Parts shall be free from defects in materials and workmanship which caused the failure of the Warranted Parts for a period of two years from the date the engine is deliv...

Page 24 - Portable Generator; Product Specifications

4 www.usa.husqvarna.com Portable Generator Product Specifications Starting Wattage . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6,875 wattsWattage. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5,500 wattsAC Load Current: at 120 Volts . . . . . . . . . . . . . . . . . ...

Page 26 - Parts List; Description; PARTS LIST - MAIN UNIT

Parts List Item Part # Description 1 M204097GS KIT, Cradle (Includes Items 20, 31 & 61) 2 194150GS KIT, Vibration Mount, 45° 3 67989GS NUT, M8 Flange Serrated 4 190220GS ADAPTER, Engine 5 NSP ASSY., Alternator (see page 5) 6 * NUT, Hex M8 - 1.25 7 195398GS TPHMS, M8 1.25 x 35 8 96796GS WASHER, 8...

Page 27 - ASSY, Control Lid Panel

Exploded View and Parts List EXPLODED VIEW AND PARTS LIST – CONTROL PANEL Item Part # Description 1 195112GS ASSY, Control Lid Panel 2 196506AGS CONTROL PANEL, Compact 3 188890GS BOX, Rear Cover 4 * NUT, Palnut, Pushnut, 3/16 5 43437GS OUTLET, 120/240 Locking, 30A 6 68759GS OUTLET, 120V, 20Amp, Dupl...

Page 28 - ROTOR

Exploded View and Parts List EXPLODED VIEW AND PARTS LIST – ALTERNATOR Item Part # Description 1 186059GS ADAPTER, Mounting, Alternator 2 190032GS ROTOR 3 190079AGS STATOR 4 186060GS RBC, with O-Ring (p/n 189197GS) 5 86308HGS HHCS, M6 - 1.0 x 140 SEMS 6 91825GS ASSEMBLY, Holder, Rectifier/Brush 7 66...

Page 29 - WHEEL

Exploded View and Parts List EXPLODED VIEW AND PARTS LIST – WHEEL KIT Item Part # Description 1 B4966GS WHEEL 2 * WASHER, 5/8" 3 191267RGS AXLE 4 191265GS E-RING 5 * HHCS, M8 1.25 x 20 6 67989GS NUT, M8, Flange Serrated 7 203977GS ASSY, Support 8 198669GS GRIP 9 B193200GS ASSY, Handle w/Grip 10 ...