Zanussi ZWY61024SI- User Manual

Page 3 - SAFETY INSTRUCTIONS

• Old hose sets must not be reused. • If the mains power supply cable is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard. • Before any maintenance operation, deactivate the appliance and disconnect the mains...

Page 4 - PRODUCT DESCRIPTION

• Do not put flammable products or items that are wet with flammable products in, near or on the appliance. • Make sure that all metal objects are removed from the laundry. • Do not wash fabrics which are heavily soiled with oil, grease or other greasy substances. It can damage rubber parts of the w...

Page 5 - CONTROL PANEL DESCRIPTION; PROGRAMME CHART

CONTROL PANEL DESCRIPTION Cotton Cotton ECO Synthetics Delicates Wool/Handwash Refresh 20 min Mix 20° 90° 1000 800 600 60° 40° 30° Intensive Easy Iron Rinse Drain & Spin Quick 7 8 6 2 1 3 4 5 1 On/Off button 2 Programme selection touchpad 3 Temperature selection touchpad 4 Spin selection touchpa...

Page 7 - CONSUMPTION VALUES

Programme Quick 1) Intensive Easy Iron Rinse Drain & Spin Mix 20° ■ ■ ■ ■ ■ ■ ■ 1) When you set this option, we recommend that you decrease the quantity of the laundry. It is possible to keep the full load but the washing results can be unsatisfactory. Recommended load: cotton: 3 kg, syn- thetic...

Page 8 - OPTIONS

Off Mode (W) Left On Mode (W) 0.48 0.48 The information given in the chart above is compliant with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC OPTIONS TEMPERATURE With this option you can change the default temperature.Indicator = cold water.The indicator of the set tem...

Page 9 - DAILY USE

SETTINGS PERMANENT EXTRA RINSE With this option you can permanently have an extra rinse when you set a new programme.• To activate/deactivate this option touch the buttons and at the same time until theindicator comes on/goes off. CHILD LOCK With this option you can prevent that the children play wi...

Page 11 - HINTS AND TIPS

CANCELLING A PROGRAMME1. Press the button On/Off for some seconds to cancel the programme and to deactivate the appliance. 2. Press the same button again to activate the appliance. Now, you can set a new washing programme. Before starting the new programme the appliance could drain the water. In thi...

Page 12 - CARE AND CLEANING

• A very small load can cause balance problems with the spin phase. If this occurs, adjust manually the items in the tub and start the spin phase again. STUBBORN STAINSFor some stains, water and detergent is not sufficient.We recommend that you pre-treat these stains before you put the items in the ...

Page 14 - TROUBLESHOOTING

2. Disconnect the drain hose from a sink or spigot. 3. Put the ends of the drain and inlet hose in a container. Let the water flow out of the hoses. 4. Set the Drain programme and let it operate until the end of the cycle. 5. Turn the programme knob to Stop to disconnect the appliance from the power...

Page 15 - TECHNICAL DATA

Problem Possible solution The appliance does not drain the water. • Make sure that the sink spigot is not clogged. • Make sure that the drain hose has no kinks or bends. • Make sure that the drain filter is not clogged. Clean the filter, if nec- essary. Refer to 'Care and cleaning'. • Make sure that...

Page 16 - ENVIRONMENTAL CONCERNS

Electrical connection Voltage Overall power Fuse Frequency 220-230 V 2200 W 10 A 50 Hz Level of protection against ingress of solid particles and moisture ensured by the protective cover, except where the low voltage equipment has no protection against moisture IPX4 Water supply pressure Minimum Max...

Zanussi ZWY61024SI- User Manual

Table of Contents:

Summary

Other Zanussi Models