Page 2 - Installation; Child Safety; During use
2 Contents Safety Information Description of the appliance Before first use Operating instruction Accessories delivered with the appliance 2 3 4 4 8 Hints and tips Cleaning and care Something not working Technical data Installation 8 9 11 12 14 Subject to change without notice Safety Information It ...
Page 3 - Description of the appliance; Control panel
3 • The grill pan will become hot during use, always use oven gloves when removing or replacing a hot grill pan. • Ensure the control knobs are in the ‘OFF’ position when not in use. • When using other electrical appliances, ensure the cable does not come into contact with the hot surfaces of the co...
Page 4 - Hob; Before first use; Oven functions; Warning
4 Hob Hot plate ∅ 145 – 1000W Hot plate ∅ 180 – 1500W Hot plate ∅ 145 – 1000W Hot plate ∅ 180 – 2000W Before first use Remove all packaging, both inside and outside the oven, before using the oven. Before first use, the oven should be heated without food. Before the first use, ensure that the room i...
Page 5 - Using the Grill; When grilling, the accessible parts of the
5 I Off Maximum position Minimum position Grill function Oven ignition Attention: when turning on the oven burner the oven door has to be opened. • Open the oven door • Lift the small lid on the bottom of the cavity • Push the electronic ignition knob for obtaining sparkles or during a power cut hol...
Page 6 - Extinguishing of grill burner
6 • Push and turn the oven control knob to the grill symbol. Hold the knob pressed for maximum 10 seconds (time for the safety valve automatically keeps the burner lit) and than release the knob. If for any reason the flame should extinguish turn control knob to the off position, after at least 1 mi...
Page 7 - The Ignition electrode; Extinguishing of burners; Selecting the Correct burner
7 Oven light The oven is equipped with a lamp. To switch on the light in the oven press the switch on the control panel. The Hob Burners Each burner has a safety device. In case the flame dies out the safety device stops the gas supply. I Off Maximum position Minimum position Use the maximum level f...
Page 8 - Accessories delivered with the appliance; Oven grid; Hints and Tips; from the oven when opening the oven door
8 The following diameter pans can be used: Power Diameter (mm) Burner (kW) min. max. Rapid 2.60 165 260 Semi-Rapid 2.00 140 240 Auxiliary 1.00 120 180 Good use Bad use (Power waste) Accessories delivered with the appliance Beside the accessories delivered with the appliance we advise you to use only...
Page 9 - Cleaning and care; Cleaning materials
9 Cooking / baking parameters There are authoritative tables referring to the cooking and baking conditions. You can make same changes in it based on your cooking and baking experience. Remarks: The dripping pan can be introduced on the first level in order to reach more even browning. The cooking /...
Page 11 - Oven lamp replacement; Something not working; Symptoms
11 Burners The burner caps and crowns can be removed for cleaning. Wash the burners caps and crowns using hot soapy water, and remove marks with a mild paste cleaner. A well-moistened soap impregnated steel wool pad can be used with caution, if the marks are particularly difficult to remove. After c...
Page 12 - Technical data
12 Symptoms Solutions Cooking results are not satisfactory Check: The correct temperature has been selected The cooking time is adapted The grill is placed correctly in the oven The oven smokes Check: The oven does not need cleaning The food does not spill over There is no excessive fat / juice on t...
Page 13 - Advice for safety; Any electrical work required to install this; If the supply cable is damaged, it must be; Before connecting check that:
13 Advice for safety Gas connections • Before installation ensure that the local distribution conditions (gas type and pressure) and the pre-setting of the appliance are consistent. • This appliance must be installed only in a room with good ventilation. • This appliance must not connected to a chim...
Page 14 - The cooker should be placed only on the
14 Installation Positioning Remove all the packaging and install the cooker in a dry, ventilated room not near curtains, paper, alcohol, petrol etc. The cooker should be placed only on the floor, but not on the base. This appliance is approved to class “1” regarding overheating of surrounding surfac...
Page 15 - Connection using flexible, non metal pipes; IMPORTANT; Conversion of gas
15 Gas feeding pipe fitting is Gc1/2. For this type of installation, connection to the gas supply should be carried out using only and exclusively flexible metallic tubes in conformity with rules in force. Connection using flexible, non metal pipes When the connection can be easily inspected in its ...
Page 16 - S P E C I F I C A T I O N N O Z Z L E S; Replace the nozzles of the hob burners; Before any modifications or adapt the range
16 S P E C I F I C A T I O N N O Z Z L E S Table no.1 CAT: II 2H3B/P Burner Normal power (kW) Economi c power (kW) Gas Type Pressu re (mbar) By- pass (mm) Nozzle diameter (mm) Cons g/h Rapid 2,60 2,60 2,30 0,78 0,72 0,72 Natural Gas G20 Butan G20 Propan G30 13 20 28-30 0,42 - - - 1,24 1,13 0,77 - - ...
Page 17 - Hob burners; Replace the nozzles of the oven burners; Flame adjustment; Oven burner
17 no air correct adjusting excess of air Hob burners To adjust the minimum level: • Light the burner • Turn the knob to the position of the minimum flame; • Remove the knob; • Unscrew or screw the by-pass screw (on the right above of tap shaft or below of tap shaft) until a regular small flame is r...
Page 18 - air adjusting; Grill burner
18 • Tighten the fixing screw M. M A air adjusting Grill burner • Loosen the screw fixing the Venturi. • Move the adjusting collar left or right until achieving the correct flame picture. • Tighten the fixing screw. adjusting collar screw opening Adjustment of minimum level Oven burner • Remove the ...
Page 19 - Environmental Information
19 Environmental Information • After installation, please dispose of the packaging with due regard to safety and the environment. • When disposing of an old appliance, make it unusable, by cutting off the cable. In case of intervention on your appliance ask the Manufacturer after sales service only ...
