Zanussi ZCG62256XA- User Manual

Page 2 - Contents; Subject to change without notice.; Safety information

Contents Safety information 2 Safety instructions 3 Product description 6 Before first use 8 Hob - Daily use 8 Hob - Hints and tips 9 Hob - Care and cleaning 9 Oven - Daily use 10 Oven - Clock functions 12 Oven - Using the accessories 12 Oven - Hints and tips 13 Oven - Care and cleaning 17 Troublesh...

Page 3 - Safety instructions; Installation

• Unattended cooking on a hob with fat or oil can be dangerous and may result in fire. • Never try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket. • Do not store items on the cooking surfaces. • Do not use a steam cleaner to clean...

Page 6 - Product description; Cooker specification; Model denomination and

Disposal WARNING! Risk of injury or suffocation. • Contact your municipal authority for information on how to discard the appliance correctly. • Disconnect the appliance from the mains supply. • Cut off the mains cable and discard it. • Remove the door catch to prevent children and pets to get close...

Page 8 - Before first use; Initial Cleaning; Let the appliance operate for approximately; Ignition of the hob burner; Ignition of a hob burner with the

Before first use WARNING! Refer to Safety chapters. Initial Cleaning Remove all accessories from the appliance. Refer to "Care and cleaning" chapter. Clean the appliance before first use. Put the accessories back to their initial position. Preheating Preheat the empty appliance to burn off t...

Page 9 - Burner; Hob - Care and cleaning

Burner overview A B D C A) Burner cap B) Burner crown C) Ignition candle (if applicable) D) Thermocouple (if applicable) Turning the burner off To put the flame out, turn the knob to the offposition . WARNING! Always turn the flame down or switch it off before you remove the pans from the burner. Ho...

Page 10 - Remove the pan supports to easily clean; Periodic maintenance; Oven function

• Scratches or dark stains on the surface have no effect on how the hob operates. • Use a special cleaner applicable for the surface of the hob. • Wash stainless steel parts with water, and then dry them with a soft cloth. Cleaning the hob • Remove immediately: melted plastic, plastic foil, and food...

Page 11 - Hold the flame near the hole in the bottom; After igniting the oven gas burner; Release the knob for the oven functions.; Turning off the oven burner

Ignition of the oven gas burner CAUTION! When turning on the oven burner the oven door must be opened. CAUTION! Make sure that the lid is opened. When using the oven the lid has to be opened to avoid over-heating. Oven safety device: The gas oven has a thermocouple. It stops the gas flow if the flam...

Page 12 - Turning off the grill burner; Oven - Clock functions; Minute Minder; Oven - Using the accessories; Inserting the accessories

• For ignition on the spark generator button push and hold the spark generator button. Push and turn the knob for the grill to the flame position. Hold the knob pushed. Release the spark generator button when burner lights. 3. Hold the knob for the grill pushed for approximately 15 seconds. 4. Relea...

Page 13 - Oven - Hints and tips; General information

A B C D A) Support hook B) Forks C) Spit D) Handle The support hook is installed in the top of the oven cavity. You can leave the support hook in the oven, when the turnspit is not active. 1. Open the oven door. 2. Put the turnspit handle into the spit. 3. Put the baking tray on the lowest shelf lev...

Page 14 - Food

• Moisture can condense in the appliance or on the door glass panels. This is normal. Always stand back from the appliance when you open the appliance door while cooking. To decrease the condensation, operate the appliance for 10 minutes before cooking. • Clean the moisture after each use of the app...

Page 17 - Oven - Care and cleaning; Notes on cleaning; Set the oven temperature to 250 °C and let; Cleaning the oven door; Open the door fully and hold the two door

Oven - Care and cleaning WARNING! Refer to Safety chapters. Notes on cleaning • Clean the front of the appliance with a soft cloth with warm water and a cleaning agent. • To clean metal surfaces, use a usual cleaning agent. • Clean the appliance interior after each use. Fat accumulation or other foo...

Page 18 - Replacing the lamp; The back lamp; Troubleshooting

3. Close the oven door to the first opening position (halfway). Then pull forward and remove the door from its seat. 4. Put the door on a soft cloth on a stable surface. 5. Use a screwdriver to remove 2 screws from bottom edge of door. 1 1 6. Use a spatula made of wood or plastic or equivalent to op...

Page 19 - Service data

What to do if... Problem Possible cause Remedy There is no spark when you try to activate the spark generator. The hob is not connected to an electrical supply or it is connec- ted incorrectly. Check if the hob is correctly con- nected to the electrical supply. Refer to the connection diagram. There...

Page 20 - We recommend that you write the data here:; Location of the appliance; Technical data; Dimension; Other technical data

We recommend that you write the data here: Model (MOD.) ......................................... Product number (PNC) ......................................... Serial number (S.N.) ......................................... Installation WARNING! Refer to Safety chapters. Location of the appliance Yo...

Page 22 - A) Gas connection end; Hob injectors replacement; Remove the caps and crowns of the burner.

Flexible nonmetal pipes connection If you have an easy access to the connection, you can use a flexible pipe. The flexible pipe must be tightly attached by clamps.In installation always use the pipe holder and the gasket. The flexible pipe can be applied when:• it can not get hotter than room temper...

Page 23 - Changing from natural gas to liquid gas; Oven injector replacement

5. Replace the rating plate (it is near the gas supply pipe) with the one for the new type of gas supply. You can find this plate in the bag supplied with the appliance. If the supply gas pressure is not constant or it is different from the necessary pressure, install an applicable pressure adjuster...

Page 24 - Adjusting the minimum gas level on the; there is no access to the bypass screw

A B 3. Unscrew the screw and slowly pull out the burner. 1 2 4. Release the burner injector with a 7 mm socket spanner and replace it with a right one. Assemble the burner in a revers sequence.Replace the gas type sticker near the gas supply ramp with the one related to the new gas type. Adjusting t...

Page 25 - Changing from liquid gas to natural gas; Gas grill injector replacement

Changing from liquid gas to natural gas 1. Unscrew approximately one turn the bypass screw position A. 2. Put the knob for the oven functions back. 3. Connect the appliance to the electricity. WARNING! Put the mains plug into the mains socket only if all parts are back into their initial position. T...

Page 26 - If the floor is not equally flat, use the; Electrical installation; ENVIRONMENT CONCERNS

B 3. If the floor is not equally flat, use the adjustable feet on the bottom of the appliance to set a stable position for the appliance. To install all the accessories, do the first step in an opposite sequence. Electrical installation WARNING! The manufacturer is not responsible if you do not foll...

Zanussi ZCG62256XA- User Manual

Table of Contents:

Summary

Other Zanussi Models