Winegard RM-EX02 - Manual
Winegard RM-EX02 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Operation
- Page 3 – Things you need —; Winegard’s Digital Elevation Sensor has been; The system must be level for; RW-1000 can be trimmed to fit ceiling plate.; Carefully; Center Roof Line; Assembly & Installation; currently; Antenna Reflector at 90; Signal from satellite; look angle; Trouble Shooting
- Page 4 – INSIDE RV; DIGITAL ELEVATION SENSOR ROOF CONNECTIONS
- Page 5 – See template on reverse side.; cutting the directional handle.; CUTTING SHAFT LENGTH
- Page 6 – Roof Template; DRILL THROUGH CEILING.
- Page 7 – INITIAL INSTALLATION; APPROXIMATELY 360° FROM; POINT TO
- Page 8 – IMPROPER WIRING WILL; Check connectors and cable entry points; properly sealed to prevent; Digital Elevation Sensor Interior Wallplate
- Page 9 – Parts List
- Page 11 – Specifications
®
RV DIGITAL SATELLITE SYSTEM
with Digital Elevation Sensor
Model RM-EX02
Made in U.S.A.
Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000
319/754-0600 • FAX 319/754-0787 • www. winegard.com
Printed in U.S.A. © Winegard Company 2009 2452168 REV6 12/12
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Tuning Antenna STEP 1 . Your receiver should indicate it is receiving a signal. To tune your antenna for the best signal strength. SLOWLY move the antenna left, then right, until you have found the position that gives the highest signal strength. It is important to turn the antenna slowly. Because t...
4 5 Things you need — Screwdrivers (Phillips and slot) 1-3/4” hole saw 7/16” wrench ABS glue Drill with 1/8” bit Tape measure Non-hardening sealant (Check manufacturer’s specifications for compatibility with your roof material.) Winegard’s Digital Elevation Sensor has been INSTALLED and CALIBRATED a...
THREADED ROD, WASHER AND NUT FIGURE 8 INSIDE RV Special instructions: For roof thickness greater than 6-1/2”. Parts Needed: (not included) RP-4400 14” worm gear for roof 3200369 Directional handle extension2162031 Long threaded rod Instructions:STEP 8. Place nut on threaded rod. See Figure 8. STEP 9...
