Page 3 - Disclaimer; Interface is designed specifically for use with; Trademarks; product use, product specifications or procedures.; Important tip; Att: Technical Services
Disclaimer Although every effort has been made to insure the information in this manual is correct and complete, no company shall be held liable for any errors or omissions in this manual. All information contained in this manual is subject to change without notice. No warranty of any kind is made w...
Page 4 - Table of Contents; DirecTV Operation
Table of Contents . Introduction ..................................................................................................................................4 1.1 System Overview................................................................................................................4 1....
Page 5 - Appendices
3 8. Troubleshooting ............................................................................................................................31 8.1 LCD Error Messages ..........................................................................................................31 8.2 Solutions to Com...
Page 7 - to confirm selection. You will now be in the Main
5 .4 Satellite Interface Components HDTV Satellite Interface User interface for the HD Satellite Interface. Using this panel, the user can select the satellite service provider, choose the toggling pair for DirecTV, control satellite antenna in manual mode and many more features. Interface also prov...
Page 8 - Tools and Material Required for Installation; Small flat head screwdriver; Select a Location to Install the Satellite Interface; Plan your entire installa
6 . SAFETY . Installation Safety: Winegard highly recommends the Winegard HD Satellite Interface System be installed by a professional installer, as RV roof top work may be required, as well as some electrical wiring. Do not install the roof top portion of this system in the rain. Before drilling an...
Page 10 - Plug Power Cable into Satellite Interface
8 After power/data cable and coax cable(s) have been routed to Satellite Interface, seal under- neath cable entry plate with approved sealant and screw down plate using 12 screws with drill and 5/16” nut driver. Seal over screw heads and around entry plate. Clamp excess cable with supplied cable cla...
Page 12 - Connect Satellite Interface to Primary DirecTV HD Receiver; “HD CTRL 1” on the Interface to “To Control” on the HD Converter.
0 (110°) HD CONVERTER MODEL WB-1100 WINEGARD COMPANY • BURLINGTON, IOWA TO RECEIVER TO INTERFACE/DISH TO CONTROL Made in USA SAT. ANTENNA IN SAT. RECEIVER OUT FACTORY USE ONLY HD CTRL 1 HD CTRL 2 COMM. OUT 1 TO SAT. ANTENNA DC IN DC OUT TO SAT ANTENNA BLK/RED SATELLITE IN Figure 3.7 Satellite Interf...
Page 13 - coax cable from satellite antenna to “Satellite In” on receiver.; Connect the Satellite Interface to 0VAC Power; end into a 110V AC outlet.
3.5. Connect the Satellite Interface to Primary Dish Network or ExpressVU HD Receiver Using the mini coax cable provide with the Satellite Interface, connect “Sat Receiver Out” on the Satellite Interface to “Satellite In” on the Dish Network or ExpressVu HD receiver. See Figure 3.8 . See Appendix A ...
Page 15 - Connect Data Cable to Electronics Board and Replace Dome; Note: Movin’ View board shown. RoadTrip board will be slightly
3 After the software has been loaded, you are ready to proceed to the next step. If you are installing the HD Satellite Interface as an add-on and have not yet installed the data cable and interface, return to section 3. Route Cables . If you have already installed the Satellite Interface and data c...
Page 16 - Configure Satellite Interface box for DirecTV programming
4 4. DirecTV Operation 4. DirecTV Overview When connected to a Winegard automatic satellite antenna, the Winegard HD satellite In- terface is capable of receiving the following satellites: 101°W - Majority of standard programming 119°W - Standard programming and some HD programming 110°W - Only HD p...
Page 17 - Configure DirecTV Receiver Antenna Type; You must set your DirecTV receiver to the “; Oval Dish, 3 Satellites; Press; Important DirecTV Program Guide and Channel Note; Please be patient while the guide fully downloads.
5 Configure DirecTV Receiver Antenna Type You must set your DirecTV receiver to the “ Oval Dish, 3 Satellites ” Dish Type. As many DirecTV receivers have been made by different manufacturers, consult your receiver’s owners manual for instructions on changing Dish Type. 4.3 Watching DirecTV programmi...
Page 18 - Example of DirecTV Satellite Switching.; begin watching a standard definition program on satellite 101°W; Note on Satellite Switching.; correct alternate satellite.
6 Example of DirecTV Satellite Switching. For a brief example of DirecTV satellite switching, read the following example. You have powered on the Dish, and you have locked onto satellite 101°W and watch as the guide begins to download. Satellite 110°W is your chosen alternate satellite. After a few ...
Page 19 - Dish Network Operation; Configure Satellite Interface box for Dish Network programming
7 5. Dish Network Operation 5. Dish Network Overview When connected to a Winegard Automatic Satellite System, the Winegard HD satellite Interface is capable of receiving the following satellites automatically: Satellite 119°W - Majority of standard programming Satellite 110°W - Standard and HD progr...
Page 21 - Programming
After unit enters Sleep Mode, you now have 6 minutes to run the check switch test. Press the “Menu” button on the Dish Network remote control. Select “System Setup” option “6”. Select “Installation”, option “1”. Select “Point Dish/Signal” option “1”. If you do not see signal on your meter, be sure s...
Page 23 - Bell ExpressVU Operation
6. Bell ExpressVU Operation 6. Bell ExpressVU Overview When connected to a Winegard Automatic Satellite System, the Winegard HD satellite Interface is capable of receiving the following satellites automatically: Satellite 82°W Satellite 91°W • • In Automatic Mode , your Winegard automatic satellite ...
Page 24 - “Check Switch” test during the initial installation.; Install the Satellite Switch; Power on your satellite receiver and press
A confirmation message will appear. The satellite antenna will reset and begin its search routine for satellite 91°W . Your satellite antenna is now set for Bell ExpressVU program- ming. Each time your power on the Satellite Interface, the satellite antenna will locate Bell ExpressVU programming. Co...
Page 25 - Watching Bell ExpressVU programming; Network satellite 91°W.
3 Select “Point Dish/Signal” option “1”. If you do not see signal on your meter, be sure satellite 91 is selected and try a different transponder. All transponders may not be active. See Figure 6. . Select “Check Switch” from the Point Dish Screen. Be sure that any options, such as “Alternate” are u...
Page 26 - Satellite Interface Menu; Automatic Mode
4 7. Satellite Interface Menu 7. Main Menu After the Satellite Interface has been powered on and the antenna has acquired the satellite signal, the status screen will the display the current satellite. Follow the steps below to ac- cess the main menu at any time. [BUTTON] denotes a button to be push...
Page 27 - Manual Mode; * DirecTV Satellite 110°W is not available in Manual Mode; Note for Dish Network and Bell ExpressVU Manual Mode operation.
5 From the Service Provider menu press [SELECT] until your Satellite Service Provider is selected. DTV → DirecTV DISH → Dish Network BELL → Bell ExpressVu Press [ENTER] to confirm. If Dish Network is chosen, you must then select Dish 500 or Dish 1000. If you are unsure, check with your satellite ser...
Page 32 - Configuration Menu
30 7.5 Configuration Menu The Configuration Menu is only to be used by Winegard Authorized Dealers or under the direction of Winegard personnel. The Configuration Menu is password protected for Winegard use only.
Page 34 - Push power button and Interface does not power up
3 8. Solutions to Common Operating Issues Symptom Solution Push power button and Interface does not power up Check that Satellite Interface is connected to good AC power source Push power button and Interface powers on but antenna does not begin searching Be sure that the antenna 12VDC power cable i...
Page 35 - RoadTrip or Movin’ View Antenna; Winegard HD Satellite Interface; Primary Dish Network HD Receiver; Secondary Dish Network Receiver (optional)
33 SAT. ANTENNA IN SAT. RECEIVER OUT FACTORY USE ONLY HD CTRL 1 HD CTRL 2 COMM. OUT 1 TO SAT. ANTENNA DC IN DC OUT TO SAT ANTENNA BLK/RED Appendix A Winegard HDTV Wiring Diagram A.1 Dish Network - 1 or 2 HD or Standard Receivers RoadTrip or Movin’ View Antenna Primary Coax Cable Ou t Data / Power Ca...
Page 37 - Appendix A Winegard HDTV Wiring Diagram; Secondary DirecTV HD Receiver
35 SAT. ANTENNA IN SAT. RECEIVER OUT FACTORY USE ONLY HD CTRL 1 HD CTRL 2 COMM. OUT 1 TO SAT. ANTENNA DC IN DC OUT TO SAT ANTENNA BLK/RED Appendix A Winegard HDTV Wiring Diagram A.3 DirecTV - 2 HD Receivers RoadTrip or Movin’ View Antenna Primary Coax Cable Ou t Data / Power Cable Bundle Modular Dat...
Page 38 - SLEEP
36 Appendix B. Recommended Receivers Winegard recommends the following receivers for use with your Winegard Automatic Satellite System. Winegard does not recommend the use of receivers with hard drives for mobile use. All information below is accurate as of March, 2007. Receivers and compatibility i...
Page 39 - WINEGARD MOBILE PRODUCTS LIMITED WARRANTY
37 Winegard Company • 3000 Kirkwood Street • Burlington, IA 52601 • 319/754-0600 Fax 319/754-0787 • www.winegard.com Printed in U.S.A. © 2007 Winegard Company 2452114 WINEGARD MOBILE PRODUCTS LIMITED WARRANTY (2 YEARS PARTS; 1 YEAR LABOR) Winegard Company warrants this product against defects in mat...