Winegard VS-0503 - Manual
Winegard VS-0503 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Figure A
- Page 3 – not; RECORDING
- Page 4 – TROUBLESHOOTING; the control box. Check to make sure all connections are correct.; location. If picture quality is degraded and you are; INSTALLING COAX CONNECTORS; Trim braid close to outer cover and remove 1⁄4” of inner insulation.; Be careful not to nick center conductor and make
WINEGARD
®
ENTERTAINMENT SELECT
MODEL VS-0503/VS-5312
Model shown has five inputs, three outputs.
FEATURES:
•
Simple push button controls allow you to send signals
from any one of 5 different inputs to 2 TVs and VCR.
•
5 Inputs are Satellite Receiver, TV Antenna, VCR,
Cable TV & Auxiliary.
•
3 Outputs: Main TV, TV 2, VCR.
•
Built-in +12 VDC TV antenna power supply eliminates
need for separate wall mounted TV antenna power supply.
•
Self-resetting fuses used in antenna power supply
prevent failure caused by shorted connections.
•
Video switch allows for independent viewing of
signals at different TVs, with a record option from VCR.
•
Low profile housing blends
nicely with other electronic
components; fits easily in
overhead cabinets.
•
Shielded circuitry for high
isolation and low signal loss.
•
Oversize, easy-to-read graphics
for proper function selection
when mounted in out of the way
locations.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
COAX CABLE CONNECTIONS STEP 1. Connect the coax cable from the output on the switch box marked “To Main TV” to the antenna input connection on the back of the main TV. STEP 2. Connect the coax cable from the output on the switch box marked “To TV 2” to the antenna input connection on the back of the...
OPERATION Once all the connections have been properly made to the control box, you are ready to watch your favorite programming. USING THE BUTTONS ON THE FRONT OF THE CONTROL BOX VIEWING STEP 1. To view signals from an amplified TV Antenna, first press the TV Antenna POWER button to the ON position....
TROUBLESHOOTING If the unit doesn’t switch properly between inputs, ( TVs, VCR, SAT, CABLE, etc.), be sure the coax is connected to the proper jacks on the back of the control box. Make sure the center conductors of the coax cables are not bent and are making good contact. See “Installing Coax Conne...
